What should I do if I can t find the hard disk after entering the PE system?

You can also go to the computer BIOS settings to modify the hard disk mode.

Enter the PE system.

What should I do if I can't find my hard drive.

Take Lenovo Computer.

System version: Windows7 as an example:

There are two solutions to find the hard disk after entering the PE system, one is the latest version of PE, install it to the U disk. The second way is to go to the BIOS settings to modify the hard disk mode, the specific steps are as follows:

1. Restart the computer directly, and press the computer brand shortcut key when the boot screen appears.

Go to the BIOS (e.g. F2), and in the BIOS interface, use the left and right arrow keys on your keyboard to select Advanced, and then select SATA Configuration.

2. After that, press the "OK" button directly to enter, you will see the SATA mode section (hard disk mode options), the hard disk mode options include ahci and IDE two, select IDE mode, press the "OK" button and then press F10 to save to change the settings.

The above is an introduction to what to do if you can't find the hard disk after entering the PE system, I hope it can be helpful to you.

Reason: The PE system you are using is not perfect enough and does not support the new hard disk interface mode, and the BIOS is set to the new mode, so it cannot be recognized.

Solution:1Replace yourself with a reliable, pure, and complete PE system.

2.Go to the BIOS settings and change the AHCI mode (or RAID mode) to IDE mode.

3.The new motherboard (such as ASUS's) may not have AHCI and other modes to switch, so you need to find a keyword called "VMD" (such as VMD controller) and turn it off.

Note that after the Step toggle is turned off, remember to switch back after reinstalling the system and other operations.

I can't find the hard disk of the computer, one reason is that there is a problem with the hard disk, and the other reason is that the format of your hard disk is not supported by PE.

Modify the hard disk compatibility mode.

Restart the computer, the boot screen appears, press the DEL key to enter the BIOS interface, select Advanced SATA Configuration in turn, there are two options below, AHCI and IDE, select IDE Enter, press F10 to save and exit.

After completing the above steps and entering the PE system, if the hard disk is still not displayed, please use the following methods to solve the problem.

The hard disk interface cable is faulty.

Open the case and switch the hard drive power cord and SATA cable to another socket.

Change to win7pe or win8pe to start.

The hard drive was replaced.