If you just bought a new car, you have to go on the highway, how many yards do you drive?

The new car you just bought needs to run in, and you need to get on the highway and drive the minimum speed (kilometers per hour) of the high-speed limit.

First, the new car run-in still exists for the current car, but the requirements and standards have been much lower, and the current new car run-in period has a relatively relaxed speed limit, and it is necessary to drive at the speed required by our traffic regulations;

Second, any car will have an instruction manual, and the speed requirements during the run-in period will also be indicated on the manual, but the common point is that the restrictions are relatively relaxed.

Third, so there is no problem at all with the new car on the high speed, you can get on and run at will, as long as it does not exceed the minimum speed (kilometers per hour) of the high-speed limit.

Fourth, the processing technology and assembly technology of today's cars have made great progress, and the tolerances between various parts are small; Another point is that in the past, the engine only experienced cold running-in before leaving the factory, and today's engine has to be cold and hot running-in before leaving the factory. The large-scale use of automation has enabled car companies to complete this run-in work well, so the new cars in the hands of car owners only need a short period of "running-in".

There is a speed limit on the highway, even if you are a new car, as long as you want to go on the highway, then you must maintain a minimum speed of 80 miles per hour. If you drive too slowly, it's against the traffic rules.

It depends on what kind of car you buy, whether it is a sedan or a truck, this is based on the situation of the next week at high speed.

If it is a new car, it is best to keep the speed at about 100 yards, so that it will have less impact on the car. Avoid sudden refueling, sudden braking, and maintain a constant speed to drive stably at high speeds.

The first 500 kilometers of the new car must not be loaded, the speed can not exceed 80 kilometers per hour, 1000 kilometers can be slightly loaded, the driving speed should not exceed 100 kilometers per hour, and the driving speed within 2000 kilometers should not exceed 120 kilometers per hour.

After the end of the first insurance, because it is the first tank of engine oil before the first insurance, it is also the most metal chips and the most impurities, and using these oil with a large number of debris to pull the high speed, it will greatly increase the loss of the engine, and even cause abnormal wear. In this way, the vehicle after the break-in period may not be in the best condition.

Car break-in period.

Before the assembly of the car, each running part is processed separately, and there are geometric deviations when processing the parts, so after assembly, some running parts will be in direct contact locally, and the lubricating oil is difficult to enter the friction surface, resulting in early wear.

The run-in period is to grind off this part of direct contact within a certain period of time, which is called the run-in period. The run-in mileage of new cars is generally 1000 km to 3000 km.

Today's new cars have been tested before they leave the factory.

Therefore, there is no rule on how much you have to run on the highway when a new car is on the highway, but remember not to speed!

The new car can run at high speeds, but there are a few things that need to be paid attention to when running at high speeds:

First, it is best to maintain a reasonable speed, and the reasonable speed mentioned here is not that the car runs at a speed, like a cruise at a fixed speed, but that the car should neither drive at a low speed nor accelerate sharply at high revs. The speed of the vehicle is best controlled within 100km h, and the engine speed and speedometer should be observed during driving, and the engine speed should not exceed 3000 rpm.

Second, during the driving process, do not start "floor oil", brake to the end, emergency braking will affect the braking system, but also increase the impact load of the chassis and engine. You know, being gentle with your car is the only way to get a long-term plan.

Third, manual transmission models should use the gear reasonably, do not drive in low gear for a long time, in addition, high gear low speed and high speed and high speed low gear are not the best plan. It is best not to rely on "D gear to go all over the world", and the reasonable use of such as S gear, manual mode, etc., is beneficial and harmless to the gearbox.

Fourth, don't drive with full load and don't overload, because this will cause damage to your car's parts. In addition, if the new car is used in the northern winter, it is best to give the engine a sufficient lubricating time before starting, and it is also beneficial to warm up for a short time.

Most of the new cars run at high speed 80 yards, it is best not to load, 1000 kilometers can be slightly loaded, the driving speed should not exceed 100 kilometers per hour, and the driving speed within 2000 kilometers should not exceed 120 kilometers per hour. Try not to drive on the highway after buying a new car, if it is necessary to go, the time should not be too long, the new car running at high speed will affect the engine life.

Precautions for high-speed on new cars:

1. Most new cars have engine speed regulations during the run-in period, and running on the highway must be a long-term high-speed operation, which will easily lead to excessive load on the engine. Under normal circumstances, domestic cars cannot exceed 75% of the specified load, and imported cars cannot exceed 90% of the specified load, and if the limit is exceeded, it will cause damage to the engine.

2. Run-in is also called walk-in. The car run-in period refers to the initial driving link after a new car or overhaul, most of which are 1,500 kilometers, which is the general journey to ensure that the parts are fully contacted, rubbed, adapted, and finalized. During this period, it can be adjusted to improve the ability of each part of the car to adapt to the environment, and grind off the protrusions on the parts.

The quality of the car run-in will play a vital role in the life, safety factor and rationality of the car.

Today's new car just mentioned on the high speed, the car has not yet come out of the run-in period, I personally think it is best not to exceed 100 yards per hour, and the car is not fully loaded, and the engine speed is controlled within 3000 as much as possible.

Around 100-140 Just look at the tire noise and ground stability.

The speed on the highway should not be lower than 60 yards, and novices generally drive 90 to 100 yards!

Try not to change lanes at will. Just run 70-80 yards in the carriageway for the first time, and it's best not to overtake. On the far left is the passing lane.

100-120km h), the middle is the driving lane (60-100km h), the right is the emergency parking lane, do not let the car go, catch 200 pieces a.

When you pass through the port, there will be a sign to tell you the driving requirements, such as the speed limit. According to the Regulations for the Implementation of the Road Travel Safety Law, the minimum speed of expressways is not allowed to be less than 60 kilometers per hour, and the maximum speed is not allowed to exceed 120 kilometers per hour.

Of course, don't think that you are a novice driver should give you more understanding, if the speed of 60 kilometers per hour does not necessarily dare to go on the highway, then it is best to run on the urban road a few times, feel capable to get on;

Hello, first of all, if you are still in the internship period, you are not allowed to drive on the highway, and then you can drive on the ordinary highway without violations, and you should be able to drive at the specified speed after a year.

How much to drive should be determined in combination with the actual situation, it is dangerous to drive too slowly, and it is also very dangerous to drive too fast, it is recommended to take the rightmost lane, and control it at 90 to 100.

There is a set speed on the highway, and it is not as much as you want. In addition, novices need to be accompanied by someone with more than 3 years of driving experience.

The first 80 does not occupy the express lane.

The new car has just gotten off the ground, during the run-in period, just don't run at high speed, in principle, within 2500 kilometers, the engine speed does not exceed 2500 rpm. Of course, it is not impossible to go to the high speed, as long as the engine speed can be controlled within 2500 rpm, it is no problem to run at 80 kilometers per hour in fifth gear.

Grinding stupidity and shouting together also called away the wax substance. The car run-in period refers to the initial driving stage after the new car or overhaul, generally 1000 1500 kilometers, which is the basic mileage to ensure that the parts are fully contacted, rubbed, adapted and finalized. During this period, the ability of each part of the car to adapt to the environment can be adjusted and the protrusions on the parts can be sharpened.

The quality of the car run-in will have an important impact on the life, safety and economy of the car.

After leaving the factory, although the new car has been run-in, the surface of the parts is still rough. In addition, there are certain deviations and some hidden dangers that are difficult to find in processing and assembly. In addition, there are many metal particles falling off between new parts and accessories, and these wheel fluid metal particles not only aggravate the wear between parts, but also reduce the quality of the oil after falling into the oil, which affects the lubrication effect.

Since the new parts have more frictional resistance during operation than in normal times, the fuel consumption will also be higher.

Most new cars run 80 yards at high speeds, and it's best not to load them. They can be lightly loaded at a speed of up to 1000 km and at a speed of up to 100 km h and at a speed of up to 2000 km at a speed of up to 120 km. Try not to drive on the high-speed Volrot Highway after buying a new car.

If necessary, the time should not be too long, the high speed of the new car will affect the engine life.

Precautions for the new high-speed:

1.Most new cars have engine speed regulations during break-in. Driving on the highway must be a long time of high-speed operation, which can easily lead to excessive engine load.

Under normal circumstances, domestic cars cannot exceed 75% of the specified load, and imported cars cannot exceed 90% of the specified load. If the limit is exceeded, the engine will be damaged.

2. Run-in is also called run-in. The car run-in period refers to the initial driving link of a new car or overhaul, most of which is 1000 to 1500 kilometers, which is the general stroke to ensure that the parts are fully contacted, rubbed, adapted and shaped. During this period, the adaptability of the various parts of the car to the environment can be adjusted and improved, and the bulges on the parts can be worn off.

The running-in quality of the car will play a vital role in the service life, safety factor and rationality of the car.

Millions of car purchase subsidies.