It s raining today, I turned on the wipers and forgot to turn them off, will the wipers be bad?

The impact depends mainly on the situation at the time. In summer, the wiper is activated, because there is a thick layer of dust on the glass, the wiper has no water movement, and the most direct damage is the wiper rubber, or even the windshield. If it's winter and the wipers are frozen, and if they are scraped immediately after driving, there is a high chance that the wipers will burn out.

If the owner's car forgets to turn off the wipers when it is parked, then it is often not good for the car. When the owner starts the car again, it is easy to cause damage to the wipers at this time, of course, this situation can also be avoided, for example: the owner turns off all the functions when leaving the car, and checks it again, then you can avoid forgetting to turn off the wipers, and this good habit is also more beneficial than disadvantageous to the owner.

In addition, the presence of wipers is also particularly useful, for example: when it rains, the wipers can make the owner's vision clear, and it is not easy to cause traffic accidents due to blurred vision.

When it rains, if you turn on the wipers and the weather is sunny, if you ask the flowers, it generally has no effect on the crossover, although you forget to turn it off, but you will see, if you see its use, you must have turned it off. It didn't have much effect on him, at most it was a little bit of wear and tear.

If you park and forget to turn off the wipers, it basically has no effect. Because, when the vehicle turns off the ignition switch, the electrical equipment of the whole vehicle is basically in a state of power failure. If the wiper is turned on, the wiper will stop working when the power is turned off, except that the wiper blades will stop in a slightly different position than normal.

If you do it occasionally, it will not have any bad effect on the wipers, because even if the wipers return to their positions, they are exposed to the outside sun, and they can be returned to their positions in time after being found.

Dry wipers on the windshield without moisture can indeed hurt the wiper blades, but as long as it's not for a long time, you don't have to worry.

You should reinstall it on a rainy day, and after all, there may be some dangers in such a situation, and there is no way to see the road ahead while driving, so be sure to pay attention.

This can be alleviated by applying soap to the glass surface, and the road surface can be observed in this way. The safest thing to do is to approach the side of the road, pull over, turn on the marker lights and double flashes, hazard signs, and wait for the rain to light before driving.

We can put some soapy water on the windshield of the car, and then we can use the power of the rain to clean our windshield.

Try not to drive on rainy days, because if the wipers cannot be used in time, it will affect your driving vision.

If the wiper is broken, it must be repaired in time, after all, the wiper is also very important for the car, and it also plays some decisive factors, do not drag it out of repair.

The wiper assembly is equipped with an electric motor, a reducer, a four-link mechanism, a wiper arm journal, a wiper blade assembly, etc. When the power switch of the wiper is pressed, the motor runs, and the speed ratio of the motor pushes the lower swing arm through the speed reduction and torsion increase effect of the rack and pinion, and the lower swing arm drives the four-link mechanism, and the four-link mechanism drives the transmission shaft installed on the front cover plate to shake up and down, and finally the wiper blade is driven by the transmission shaft to sweep the windshield of the car.

Common faults in any position of the wiper assembly will definitely cause the abnormality of the wipers. The wiper may not move because the fuse is broken, so the wiper can't move, so you have to open it to take a look, if so, just replace it.

You can refer to the following methods to find the problem.

Open the lead cover to see if the drive link is out of place (this is the most common cause).

Check that the fuse is in good condition.

Disassemble the motor cord plug to turn on the power supply, and use a multimeter to measure whether there is voltage.

If the fuse is intact and the motor has no voltage, check whether the circuit and turn signal combination switch is intact.

Generally, the motor will have a burnt smell when it burns out.

If you turn on the power supply and measure the normal voltage at the wiper motor, you can consider that the motor is broken.

Pay attention to whether the pole is connected to the wiper rocker arm in the correct way. Some of the arms are screwed to the rocker arm, while others are locked with a buckle.

Pull the wiper up and touch it with your finger to check for damage to the cleaned rubber wiper and the elasticity of the rubber blades. If the blades are aged, hardened, or cracked, then the wiper is broken.

During the test, the wiper switch is placed at various speed positions to check whether the wiper maintains a certain speed at different speeds. Especially in the intermittent working state, it is also necessary to pay attention to whether the wiper maintains a certain speed when it is in motion.

Check the wiper status and whether the wiper rod has uneven swing or leakage. If the following three situations occur, it means that the wiper is unqualified: first, the swing is not smooth, and the wiper is not beating normally; Second, the contact surface of the rubber and the glass surface cannot be completely fitted, resulting in wiping residue; Third, after wiping, the glass surface presents a water film state, and fine stripes, fog and linear residues are produced on the glass.

During the test, attention should be paid to whether there is abnormal noise in the motor, especially when the wiper motor is humming and does not rotate. This indicates that the mechanical transmission part of the wiper is rusted or stuck, and the wiper switch should be turned off immediately to prevent the motor from being burned.

The structure of the wiper is very simple, mainly a brush and a motor, and there are relatively few failures. Even if the wiper doesn't move, it's probably because the fuse has blown out. Just open the fuse, find the fuse of the wiper, and remove it for a new one.

There are two main types of fuses: chip fuses and glass tube fuses. The chip fuse blows.

If you are not ready and are driving in the rain, you can change to a fuse on other secondary lines. If you borrow the fuse of the horn, you can also borrow the fuse of the headlight during the day. As for the glass tube fuse, in addition to the above workaround, it can also be replaced with tin foil in the cigarette case (but never with aluminum foil).

The method is to wrap tin foil around the glass tube several times to temporarily replace the tin foil.

Driving in rainy days, no matter how big or small the rain is, if the wiper failure cannot be eliminated, the rainwater on the windshield cannot be effectively cleaned, people's vision will be extremely reduced, safety can not be guaranteed, and they cannot continue to drive. At this point, it can be solved by applying soap to the soil. It is to apply a layer of fat soap to the windshield, so that you can maintain a clear line of sight for at least thirty or forty minutes.

At the same time, soap can also be applied to the rear window glass to improve the problem of poor rear vision. While soap can help us on rainy days when the wipers fail, sometimes we don't necessarily have soap in our car and it's not always available nearby. In this case, if you can pick up some cigarette butts on the side of the road and apply them to the windshield, you can also solve the problem.

If cigarette butts are hard to find, another trick is to find some slightly thicker, more watery leaves on the side of the road, which can be crushed and painted on the windshield to work.

A wiper is a piece of rubber wrapped in iron sheet that is inserted into the end of the rocker arm in an embedded manner. So after a long time, the wiper blades will fall off, causing the end of the swingarm to rub directly against the windshield, which will not only blow rain, but also scratch the glass. It's not often that two wiper blades come off at the same time.

If it is the left driver's seat, you can remove the wiper blade of the right passenger seat, install it on the left side, and then find a rag to wrap the wiper head on the right side. If it's too much trouble, simply remove the swingarm to avoid scratching the windshield.

The windshield plays an important role in front of the driver. It not only protects the driver's safety from dust, rain, sand and strong winds, but also allows the driver to see the road conditions in the distance and ensure driving safety. On the other hand, the windshield material is brittle and hard.

As long as there are scratches on the surface, they will break if you touch it lightly, so take good care of them and never allow scratches. Scraping the windshield is the dust that adheres to the wipers. The scratches of these dust are many fine lines like sand glass.

When a car is moving at high speeds, even such a tiny scratch can cause the windshield to break. In the past, many people couldn't find the cause of the sudden crack of the windshield on the highway, but they didn't know that those small scratches caused the disaster.

Millions of car purchase subsidies.

1. Apply soap.

Driving in rainy days, no matter how big or small the rain is, if the fault of the wipers cannot be eliminated and the rain on the windshield cannot be effectively scraped, the sight of the Zen people will be extremely reduced, and the safety will not be guaranteed, and the capital car cannot be continued. At this time, you can use the soapy soil method to solve the problem. It is to put a layer of soap on the windshield, at least it can be maintained.

Thirty or forty minutes of clear sight. At the same time, soap can also be applied to the rear window glass to improve the condition of poor rear vision.

2. Paint cigarette butts or broken leaves.

Although, in the event of a wiper breakdown, soap can help us on a rainy day, sometimes we don't necessarily have soap in the car and don't necessarily have it nearby. In this case, if you can pick up some cigarette butts on the side of the road and apply them to the windshield, you can also solve the problem. If cigarette butts are hard to find, another trick is to find some slightly thicker, more watery leaves on the side of the road, crush them and apply them to the windshield.

3. Adjust the wipers.

The wipers are made of iron wrapped in a rubber sheet and inserted into the end of the rocker arm in an embedded way. Therefore, after a long time, the wiper blades will fall off this foot, causing the end of the rocker arm to rub directly against the windshield, which will not only not clean the rain, but will scratch the glass. If the two wiper blades fall down at the same time, if it falls on the left driver's seat, you can remove the wiper blades of the assistant seat on the right and install them on the left side, and then find a rag to wrap the rain drama head on the right, or it is troublesome, simply remove the rocker arm to avoid scratching the windshield.

Here we are verbose, the windshield in front of the driver, the role is very important, not only to protect the safety of the driver, to block dust, rain, sand particles and high-speed strong winds, but also to allow the driver to clearly see the far road conditions, to ensure driving safety. On the other hand, the material of the windshield is relatively brittle and hard, as long as there are scratches, it will break if you touch it lightly, so you must protect it well and never allow it to be scratched casually. The windshield is also scratched by the dust attached to the wipers, and if you don't look at the scratches of this dust, you will find many sandglass-like fine lines.

Hand height at high speed in the car, even such a fine scratch can cause the windshield to break. In the past, many people had incidents of sudden windshield bursting on the highway and could not find the cause, but they did not know that it was those small scratches that caused the trouble.

The structure of the wiper is very simple, mainly a brush plus a motor, and there are relatively few failures. Even if the wiper fails, it is mostly because the fuse has been blown out. When you rule it out, just open the fuse box, find the fuse of the wiper, and pull it out and replace it with a new one.

It doesn't have to be damaged, but it does have an impact on both the wipers and the glass.

The surface of the windshield is generally covered with a layer of ice, which cannot be scraped off with a wiper, which will affect the line of sight, and the wiper will generally be frozen in the snow and forcibly started, which will damage the service life of the wiper.

In addition, using the wipers to hang the ice before it melts will cause the ice to rub against the glass, causing small scratches on the glass.

Solution:1If you fix it, it may be because the fuse of the wiper motor is burned.

Just open the fuse box, find the fuse of the wiper, pull it out and replace it to see if it still works. 2.It can be solved by applying soap to the earthen method.

It is to apply a layer of soap on the windshield, which can maintain clear vision for at least thirty or forty minutes.

When using the wipers, if the wiper motor emits abnormal noise, especially the wiper motor makes a "buzzing" sound but does not rotate, it means that the mechanical transmission part of the wiper is rusted or stuck, and the wiper should be turned off immediately to prevent the motor from being burned. If the wiper motor is not abnormally noisy, but the wiper is not working, it is mostly because the fuse is blown out. At this point, just find the fuse of the wiper and pull it out and replace it with a new one.

If you don't have a dedicated wiper fuse, you can use something else instead. Chip fuses can be replaced with fuses on other secondary lines, and the fuses for glass tube tours can be replaced by wrapping the foil inside the cigarette case outward around the glass tube a few times.

When it rains lightly, the wiper can not completely brush the rainwater on the windshield, leaving traces of uneven wiping on the glass surface, in general, this is because the rubber part of the wiper is hardened, and the wiper can not fit closely with the glass surface, or because the rubber on the wiper has a scar that causes uneven wiping and forms residual dirt. At this time, it is best to buy a new wiper or rubber sheet and replace it with a new one. If the surface of the glass is foggy, beady, streaked or partially blurred when the wiper is working, this is due to the influence of oil film, dirt or car wax, as long as the windshield and wiper blades are cleaned.

Photo by Xu Shuanghe) @2019