There is a lot of oil on the keyboard, how to clean up the keyboard is very oily

Generally, the keyboard can be disassembled and washed, pick up the key spade from the side to start the shovel up, you need a little skill, patiently warp it down one by one, don't worry about the key spade will be broken, at most a little bit of warping hair on the edge below, install the invisible, be a little careful of the soft gasket below, don't miss it, but the general spade key is not able to fall out. This way you can see a very disgusting scene under the keyboard.,Take a small brush and brush it slowly.,But it's generally difficult to clean up well.。

If you want to be thorough, it is best to disassemble the screws behind the keyboard (remove the keys first), carefully remove the tailgate, you can see the circuit sheet, open it, the line connection next to it can be disconnected, mine is two black bar contact type, so you can completely take down the circuit, the reverse side of the circuit should be the contact gasket, pay attention not to fall here, after taking the circuit, only a shell is left, take a bucket, fill it with water and washing towels, hard, brush it hard, brush it hard, brush it off, spin dry, it is best to blow dry, I use one to wipe with a napkin, who told me to wait to dry......Then the gasket is stuck back into the slot, press the circuit piece, align the line interface, install the rear baffle, and then slowly dry and press the keys one by one.

It's best to find customer service.

and after-sales. Otherwise, there will be problems.

Put on gloves and type for 40 minutes.

The grease on the keyboard can be cleaned like this:

Ordinary membrane keyboard:

1.Flip over the keyboard with the back facing up and tap to clean up the clutter.

2.Use a blade to gently scrape away stubborn stains and mud.

3.Use a hair dryer to remove surface dust and smaller debris.

4.Use a clean, damp cloth to scrub the oil to clean the grease stains.

Mechanical keyboard: 1Since the keycaps of a mechanical keyboard are installed by snapping, the keycaps can be easily removed.

Before taking it, it is recommended to take a picture of the initial appearance of the keyboard, so that everyone can know what keys are in each position after cleaning.

2.Soak the keycaps with detergent and soak them for about 1 hour before washing, and do not use sharp objects such as wires to avoid damaging the keycaps. In general, after soaking for 1 hour, the oil on the keycap will automatically decompose.

3.Some areas with severe dirt can be wiped repeatedly with a soft dishcloth.

4.If you remove the keyboard, you can shake the keyboard upside down, or buy an air compressed air tank to blow air on the corners, circuit boards and other inconvenient wet places to blow dirt and floating dust away from the circuit board.

5.After cleaning and drying the keycaps, you can install the keycaps one by one.

For other types of keyboards, they can also be cleaned accordingly according to their material and structure. In addition, when not in use, try to have a glass cover or dust cloth to cover the keyboard to prevent dust from entering.

If the keyboard is oily, here are a few things you can try to clean it up:

1.Use a wipe or wipe: Gently wipe the surface of the keyboard with a wipe or wipe. Make sure they are not too wet to avoid damage.

2.Use a soft-bristled brush: Use a soft-bristled brush to gently wipe grease stains from the keyboard. You can use a makeup brush or a small high-open rubber brush.

3.Use a keyboard cleaner or alcohol: Spray a keyboard cleaner or diluted alcohol on a wipe and gently wipe the surface of the keyboard with it. Be careful not to spray cleaning precursor or alcohol directly on the keyboard to avoid liquid getting inside the keyboard.

4.Remove keycaps for cleaning: If the keyboard is very greasy, you can try removing some of the keycaps for cleaning. Use a small tool (such as a key or scissors) to gently pry the keycaps, then use wipes, wipes, or detergent to clean the keycaps and keyboard panel.

Remember to make sure the keyboard has been disconnected and turned off before all cleaning operations to avoid electrical failure. Take extra care during the cleaning process to avoid damaging the keyboard.

There are two types of computer keyboards: ordinary membrane keyboards and mechanical keyboards, and the cleaning methods are different.

Ordinary membrane keyboard, relatively cheap, generally between dozens to hundreds, cleaning methods are as follows:

1. Turn over the keyboard, back up, and pat to clean up the debris;

2. Stubborn stains and mud stains should be gently scraped off with a blade;

3. Use a hair dryer to clean up the dust on the surface and small debris;

4. Use a clean damp cloth to scrub the oil to clean the oil stains.

Mechanical keyboard, ** higher, generally three hundred to thousands of yuan, cleaning methods are as follows:

1. Crack Zheng Qiao uses a key puller to pull out the keycaps;

2. Use a brush to clean up the dust in the keyboard;

3. Put the keycaps in clean water, pour an appropriate amount of detergent, and gently scrub off dust and oil stains;

4. The keycaps are placed on the plane sideways and dried naturally;

5. Insert it back into each axis of the mechanical keyboard in turn.

The keyboard is very oily and can be cleaned with toothpaste, apply the toothpaste to the keyboard, add a trace amount of water, do not put too much water, and then use a toothbrush to brush back and forth.

Materials needed to clean the surface of the keyboard: keyboard, anhydrous alcohol, old toothbrush, sturdy wet wipes, small container, hair dryer.

Cleaning steps: First, pour a little anhydrous alcohol into a small container (anhydrous alcohol must be used, alcohol with a large amount of water will damage the circuit board in the keyboard).

2. Then spread out the wet paper towel and soak it in a small container containing anhydrous alcohol.

3. After all the tissues are soaked, wring out the excess alcohol in the tissues.

Fourth, then use an old toothbrush to pad an alcohol-soaked paper towel on the keyboard to clean.

5. After all the places on the key surface are cleaned, finally blow the keyboard with the cold air side of the hair dryer (dry the residual alcohol on the key surface, and blow out the dust at the bottom of the keyboard), and clean the keyboard after blowing.

Unplug the keycaps and wash them the same as the dishes.

If the keycaps are not easy to pull, use a damp cloth (or wet wipes, alcohol cotton, etc., pay attention to twist the water first, and the water should be wet but not screwed out of the water, and the spill-proof keyboard can be ignored) to wipe, or buy that kind of "keyboard cleaning mud" can start to work, not as good as the first line.

1. Turn off your laptop.

Second, the method of cleaning the keyboard grease stains.

1.Wring it out with a towel or flannel soaked in hot water and wipe the keyboard;

2.Wipe the keyboard with a velvet part dipped in alcohol;

3.Wipe the keyboard with dish soap dipped in velvet; After that, wring it out with a towel or flannel soaked in hot water and wipe the keyboard.

3. To prevent the keyboard from being stained with oil, you can match the keyboard with a keyboard film.

If the keyboard is permeable, rinse it with soapy water, and then check it with a paper towel, and hang the keyboard in the air when you pour it.

Use a professional detergent, or put some dishwashing detergent into the water, and then use this water to wet the cloth, and then wipe, the cloth is not too wet!

For mechanical keyboards, pull off the keycaps and wipe them with a wet towel and some cleaning liquid, and ordinary keyboards can be brushed directly on the keyboard with a wet towel and cleaning liquid.

Wipe gently with a paper towel, then gently with a brush, and finally again with a paper towel.

There are specialized keyboard cleaning kits available in the market, and the cleanup is very clean. Give it a try.

Tips for life to quickly clean up the junk on your keyboard.

How to deal with the oil inlet of the laptop:

1. Unplug the power supply and battery immediately, the speed of power off directly determines the most critical factor in the severity of the damage to the notebook.

2. Pour out the water immediately according to the direction of the water intake, and quickly dry the water with a dry towel or paper towel. If there is water on the top of the keyboard, immediately turn the keyboard down (be careful not to let the water flow into the LCD screen), and try to pour out the water to avoid more water entering the motherboard.

3. If the notebook keyboard gets into the water, remove the keyboard and observe whether the water has entered the motherboard. Carefully dry the front and back of the keyboard with a paper towel. If possible, you can use a hair dryer to dry it with cold air, and be careful not to use hot air, because the keyboard keys and other keys are plastic, which is not resistant to high temperatures, do not use hot air, and avoid blowing damage.

If the liquid is cola, vegetable soup, etc., you need to remove some of the buttons and carefully scrub them with pure alcohol. Because cola and other substances contain sugar, if it is not clear, it will corrode the wiring over time and cause damage to the keyboard.

4. Completely disassemble the motherboard, if you will not disassemble the motherboard, it is recommended to find a professional maintenance personnel to deal with it. Observe whether there are water stains on the motherboard, and if so, carefully wipe it clean with pure alcohol. In the maintenance of notebooks, the motherboard is scrubbed with high-quality plate washing water, not the ordinary plate washing water.

This can be replaced with pure alcohol, which must be used with pure alcohol, not aqueous alcohol. Then dry the motherboard, or the hair dryer should not be too high, and pay attention to protect the plastic connectors on the motherboard.

5. Do not power on and turn on the machine before processing. Because the general user has no professional drying equipment, it is necessary to let many accessories be thoroughly dried as often as possible.

What kind of oil? If the keyboard can still be used, forget it; If it has affected normal use and some keys are out of order, then it is necessary to replace the entire keyboard (the keyboard of some ultra-thin models is integrated with the C-side and needs to be replaced as a whole, which is more expensive).