How can a billiards ball hit a curveball? Which part of the tie rod is hit?

Here's how to hit the curveball:

Tie rod part: <>

The rear hand grab bar should be forward, otherwise it is not conducive to the force. The arc of the tie has a great relationship with the inclination angle of the club, the higher the back hand, the greater the inclination angle of the club, and the more obvious the arc. The hand frame should be as stable as possible, and the fingers and the table form a plane, which helps to improve the stability of the rod.

A slight tilt of the body is in place to allow the club to have a downward effect.

The curve ball is the lower left or right part of the ball, the force should not be too large, and the force should be soft. The stick must be lifted more than 45 degrees, and the upper part of the ball is done with a wooden jumping rod, which has a lot of friction and is easy to pick.

Depending on the size of the arc, the height of the pole is set to play the point of the left and right games a little lower.

The tie is the lower left or right part of the game (the top is fine, but the bottom is easier to spin), and the club is close to 90° to the table.

Tie the rod is the lower half of the ball, the club is high, the ball must be strong, and there will be a rotating effect when the ball is pierced, which is more difficult and difficult to control the cue ball. . .

Elevate the pole, play from the top to the bottom, left and right, the key depends on you, it is highly recommended that you watch the tutorial of Mr. Pang Weiguo.

Playing the above style is wrong, I am 100% sure. Although it can also hit the effect of hitting the rod, it has its limitations, and the cue ball will feel like it can't run. You'll know when you compare the two.

Tie the pole is a very extreme rod method, and it is difficult to play well. The way to play is to play the lower left or right part of the ball with the tail of the club, and the head of the club is slightly tilted to the left or right, and the force must be thorough, so that you can hit the curved ball.

The upper deflection rod, parallel to the axis line, runs through the outgoing rod.

To hit the ball to the right on the lower right side of the ball, use force and raise the club.

The first is the angle between the rod and the table, usually when we hit the ball, the general rod and the table are as horizontal as possible, and when the rod is played, the rod should be raised as much as possible, generally about 70-80 ° with the table;

Then there is the point of impact, which is the point at which the cue stick touches the cue ball at the moment it hits the cue ball, which is about 7 tenths of the way to the ball (upper) when viewed from the front of the cue ball. To hit the right-hand rotation (clockwise), hit the right seven-tenths position.

Finally, the rod method: the rod should be stable, and the usual hand frame posture can not be played, and the fingertips need to be raised to touch the table, pay attention to the angle with the table, and quickly get out of the rod.

It takes a lot of practice, and I'm sure you'll be able to do it.

The middle and lower part of the ball is left or right, depending on the specific situation.

The middle is a little bit up.

Freestyle billiards: How to hit a precise curveball? Hope this teaching is helpful to you!

Go up left or top right, depending on which side you want the king to fight.

How to hit a curved ball with billiards:

1. It can also be said that you can play arc ball, and you need to understand the posture, hitting point, hitting angle, and hitting power to play different arc lines.

1. Tie the rod. It refers to a method of hitting the cue ball from top to bottom by hitting the cue stick at a certain angle or almost perpendicular to the table surface when hitting the ball, so that the cue ball produces a strong rotation and forms an arc.

2. The posture of the rod.

2. According to the specific spherical shape and the required arc size, the pole posture can be divided into two types:

1. The scaffold is on the countertop, the four fingers "bite" the countertop, and the rear hand raises the rod tail (the elevation angle is generally not more than 60°).

At this time, you need to pay attention to the stability and height of the hand frame, the body can be slightly tilted to ensure the stability of the bar, and at the same time, the rear hand grab bar is appropriately forward to help smooth force.

2. The hand frame is suspended, at this time the hand frame should be used phoenix eye hand frame, the front elbow joint is not thick near the waist, the rear hand grip is different from the usual grip, the five fingers should be clamped hard, and the club is almost vertically downward.

The scaffold is raised, and the tail of the pole is also raised at a certain angle to the level, but it cannot be greater than 90 degrees on its own side. Towards the obstacle ball around the ball (definitely not in the direction of the target ball), moderate force (not too big or too small, control well), add a strong side in the direction of the target ball, stabilize the shot, do not slide the stick or hit the kick. The cue ball will go around the obstacle ball and hit it in a straight line for a short distance, and then the arc motion will move in the direction of the stopper.

This angle is not easy to control, most people use this method to solve the ball, and few people say that they use this method to score goals. It points luck.

From the picture above, the rod is not a complete arc, there are no rules, so it is difficult to control the cue ball line, calculate his angle, the purpose of the rod is to understand the ball. So the closer we get to the ball, the more the tail of the rod should be raised, and the stopper should be thinner and more powerful. The farther pole is a little less powerful, for fear that he will turn his head and stack the end of the pole low.

The prerequisite is that you don't make mistakes in your hand and during your shots.

In fact, the low stick can also play the arc effect, and you can't see the effect when you use it at close range, only when you play the long table, you want to go around the obstacle ball and add a point plug, and hit the position of the thin point of the low club, and the power is a little smaller, so that the cue ball quietly bypasses the obstacle ball, this kind of stroke is also called "stealing", in fact, it is a low ball arc.

Freestyle billiards: How to hit a precise curveball? Hope this teaching is helpful to you!

What needs to be said has been said! You just have to practice diligently!

This should be quite difficult, I'm a billiards lover, I've tried it before, and it's very difficult to play an arc, I hope it will help you.

Freestyle billiards: How to hit a precise curveball? Hope this teaching is helpful to you!

Stand up the cue stick and hit the cue ball above. The left (right) side can be used, note: the main control power and the take-out lever are required"Fast".

After the rod is played, the cue ball rotates the scale distance and position! That's what we're calling"Tie the rod"Finish. You have time to practice!

Still, watch more, ask more, and practice more.

The speed of the exit and the closing speed should be fast, and the side of the white ball should be a little bit.

In billiards, the tie arc ball mainly relies on the judgment of power and spin to control the target ball.

In fact, the curved ball and the usual stopper ball are theoretically the same, both of which make the cue ball spin sideways when hitting the ball. Although the ordinary stop-up ball can't hit an obvious arc, in fact, the ball will still deviate slightly from the ball path during the rolling process, so it is usually necessary to give way when playing the stop-up ball in some cases, which is the reason.

The pole arc ball is to hit this deviation in a real way, and use the arc to bypass the obstacle ball and then hit the target ball. Although the visual effect is different, it is actually the same as the ordinary stopper. Playing the same ball, with the same spin, the greater the hitting force, the less obvious the arc, the faster the ball speed, and vice versa, the more obvious the arc, the slower the ball speed.

Therefore, if you need a rad when it is not very obvious, you can have more power. On the contrary, if the power of the shot is small and the arc is large, then the point that is given up before hitting should be increased accordingly.

The practice process of all the stoppers is actually the practice process of hitting the ball and the control of spin, each person's power is different, resulting in different spin effects, there is no shortcut to follow, only through their own hard work, find a balance point suitable for themselves in the middle of power and spin, and then match the handicap amplitude suitable for the actual situation, you can play well.

I don't understand your question.

But, hehe.

Your bounty points.

To put it simply, tying the ball is to rotate the ball sideways, and when hitting the ball, hit the main ball from top to bottom by hitting the club at a certain angle or almost perpendicular to the table.

The style of play is quite complicated, involving strength, club angle, and hitting point, which are introduced separately:

Force: First of all, it is not explosive.

It's the kind of power that is very inert.

That is, the speed is not fast.

But the power is great.

Equivalent to the torque in the engine.

Of course, the greater the force of the above.

The greater the radian.

Club angle. Roughly speaking, it is.

The hindbars are higher than the forelimbs.

After putting about high. The greater the radian.

The point of impact is based on the power and club angle, the higher the back handlebar.

The higher the point. The rod should be erected to cut the side of the cue ball, first taking into account the obstacle ball and then the position of the target ball, similar to the aiming point of the spinning ball. Normally, it is not needed, and it takes a long time to practice. The premise of hitting the stick is that the obstacle ball should be close to the cue ball between the target ball and the cue ball, and if the obstacle ball is close to the target ball, it will be difficult to hit the target ball with the stick.

The specific way to play is that the hand frame should be elevated, the cue stick and the table are 20 30 degrees, and the hitting point is on the left or right side of the cue ball (from the cue ball directly above the eight o'clock or four o'clock position, the point can not be too close to the edge of the ball, otherwise it will slide the bar), hit it with medium force, and the strength should have the feeling of penetrating the cue ball, too much or too small is not good, and the main thing is to master the sense of rhythm.

The billiards god teaches you to play billiards like this, how to use the tie rod correctly, and the position of the hands is very important.

Adjust the angle of your hand and tie the pole down!