Maximstar cannot restore the router to factory mode 20

Try pressing reset for a longer period of time with or without power.

The norm should be when the power is on, and there is a network cable for you not to connect first.

If there is a restoration, the light of the router should change, it may be not on at all, and then it will be on all again.

The IP and password behind the re-installation route are used to log in to the incoming route.

Turn off DHCP for your routing settings. It's a switch!

There is one more way. You change the route PPPoE to, Auto IP. Connect the cable you received from your friend to the WAN port.

Then change the IP range in the route to be different from your friend's. For example, if your friend is coming over, you change yours to - this DCHP is going to be turned on.

Once you've set it up. Your local network will be disconnected once, which is normal, and now connect the network port. The network should be normal.

Good luck.

The router is connected to the router and let the router be routed when the switch makes it completely ok you mask out the network layer (layer 3 of the OSI reference model) function of the router below the router.

1. Change the IP address submask of the LAN port of the router of the switch, the LAN port address of the router that connects the cat is generally the subnet mask by default.

2. Disable the DHCP function of the router when the switch, don't let him assign IP to the computer, assign the IP address and connect the router of the cat, don't care about the other DNS,

Method 1: There is a button [RESET] button on the back of the router, press and hold for 5 seconds, and the indicator light on the router panel will be off and then on, which means that the settings have been reset.

Method 2: Enter the router.

Open the browser - enter the general router address is this or check the login information on the back of the router) enter the route - enter the user name, password, (the default is generally admin).

Click on System Tools --- factory reset.

There is a small hole in the back of the general router to restore the factory, and if there is a button, press the finger for more than 7 seconds, and if there is no button, use a toothpick to press it for more than 7 seconds

Log in to the router settings page, select Reset, or press the reset button (next to the power connector), and release it after 5 seconds. If you are satisfied, please give points!

Restore the factory settings of the Metstar router, if there is no reset button, you can achieve factory reset through the reset hole.

When the router is powered on, hold the reset hole on the back of the router for about ten seconds, wait for the indicator lights on the router to turn off and turn on, and the router will be restored to factory mode.

Restore the factory settings through the router background, open the browser on the computer connected to the router, enter the parameter values on the back of the router for details), enter the account and password to log in (the default is mostly admin) - click System Tools in the lower left corner - Restore factory settings - click on the right page to restore factory settings - wait for the router to complete the recovery and restart.