How to change the brake pads behind the Buick LaCrosse electronic parking brake need to be matched?

Hello, you don't need to match, connect it with the battery wire and go back, and you can go back when you return to the position. Hope mine can help you. [Car questions, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello! No, you don't! The electronic parking brake has nothing to do with brake pads! Need to press the sub pump back! You can [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Hello, the brake pads behind Buick Regal are electronic brakes, in this case, you need to use a computer detector for basic settings, reset the brake cylinder, and then reset it after replacement.

I hope it can help you! Have fun with a car! [Car questions, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Your car, replacing these does not need to be matched, I hope mine is helpful to you, I wish you a happy drive [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

No, you don't. You need to take the computer to take the electronic handbrake motor back and it's OK. Remember the car question, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

If I can press back, I still ask you?

You don't need to match it, you can use the battery to connect it out, and you can connect it back with a decoder, and it's more convenient to use a decoder [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Take the current new LaCrosse as an example, the button of its electronic parking brake is behind the gear handle, P logo, and it will be lifted when you press it.

LaCrosse's electronic parking brake is located in the center console on the right-hand side, as shown in the figure below

Here's how to use it:

1. Start the ignition button of the LaCrosse car to make the car in a power-on state;

2. First of all, step on the brake pedal of the LaCrosse car with your foot, which is conducive to preventing the car from slipping backwards;

3. Then, use your right hand to pull the electronic handbrake button upwards and turn on the handbrake to use;

4. When the electronic parking brake is turned on, we can see that the indicator light on it turns red.

There are eight brake pads. The LaCrosse has eight brake pads. Buick LaCrosse brake pads are replaced for 3-50,000 kilometers.

Brake pads are wearing parts, and the replacement cycle of brake pads is determined according to the driving habits of the owner. If the thickness of the vehicle's brake pads is worn to 1 3 of the original thickness, it needs to be replaced. If the brake pads do not slip in time, it will cause the vehicle brakes to lose control and affect driving safety.

Here's how to replace the brake pads:

1.Before replacing the brake pads, you should first open the brake fluid reservoir lid in the engine compartment and look at the high chatter balance on the brake fluid page. If the brake fluid level exceeds the maximum limit, you should suck out some brake fluid to prevent the brake fluid from spilling during the replacement process.

2.Prepare the brake pads to be replaced and remove the wheels where the brakes are located. Avoid scratching the rim when disassembling;

3.Remove the bolts of the caliper with a wrench and sleeve, and then remove the brake pads (if there is a brake induction wire, remove the brake induction wire first). Observe if the brake pads are excessively worn or cracked, and if so, replace them in the next step;

4.Because there will be a lot of sand or mud in the brake caliper, it should be cleaned with a rag and then coated with silencer paste to prevent abnormal noise during braking;

5.Press the piston to a non-movable position with a piston pump and install the brake pads onto the caliper. After the new brake pads are installed in place (the brake induction line should also be installed), tighten the guide bolts to complete the installation;

6.After installation, close the reservoir lid and press the brake pedal several times to reset the brake. Then observe the brake fluid height, which should be within the appropriate height range;

7.After replacement, a test run is carried out to check whether the braking effect is reflected.

Millions of car purchase subsidies.

Hello, dear. Buick LaCrosse 2011 handbrake can be adjusted, the adjustment method is as follows: Buick LaCrosse 2011 car handbrake adjustment method:

1. Lift the rear of the car with a jack so that the two rear wheels of the car can rotate; 2. Adjust the gear of the car to the empty section, adjust the automatic gear to the P gear, and adjust the manual gear to the gear; 3. Adjust the tightness of the handbrake appropriately, and then use a wrench to twist the screw clockwise to adjust; 4. After the adjustment is completed, the handbrake is completely relaxed, check whether the rear wheel of the car can rotate, if the rear wheel can rotate, remove the bucket to check the adjustment effect after the jack. The professional name of the handbrake is the side-buried auxiliary brake, which is different from the principle of the brake, which is connected to the rear brake shoe by using a steel wire cable to brake the car.