How to deal with water in Longines watches, how to get water in Longines watches

1. If the Longines watch is soaked in water, you can wrap the watch tightly with several layers of toilet paper or flannel cloth that is easy to absorb moisture, put it at about 15 cm near the 40-watt light bulb, and bake for about 30 minutes. Do not bake the watch close to the fire, so as not to deform the watch by heat.

2. Put the surface face inward, the bottom shell facing outward, and wear it on the wrist, and the water vapor can be eliminated after two hours. If the water ingress is severe, it is best to immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

3. Put the granular silicone into a closed container with the watch that has accumulated water, and after a few hours, take out the watch and the water will disappear. This method is simple and economical, and there is no damage to the accuracy and longevity of the watch. The silica gel that has been absorbed many times can be dried at 120 degrees for several hours, and the water absorption capacity is renewable, and it can be used again and again.

Hello, glad to answer for you!

1. If the water ingress is not serious, but there is a layer of fog on the surface, you can use toilet paper or flannel cloth that is easy to absorb moisture to wrap the table tightly.

If the watch is faulty, you can click below to consult the official** or click on the avatar to call for consultation**!

Hello, I recommend that you go directly to the relevant after-sales service center to deal with the water inside the watch to avoid unnecessary trouble caused by your own independent operation. Professional things should still be done by professional people. You can also click on my homepage to consult about after-sales service and deal with the degree of water ingress in your watch.

Make sure that the watch is in good condition. Welcome to consult.

If you have any questions, please call** Please feel free to call.

Longines watches will enter the water without paying attention, or the humidity in the place where you live, there is water vapor in the place of work, etc., in addition, there is another possibility that the staff operation is not standardized enough when the last time you changed the battery of the watch, and the case was not completely buckled, so the existence of the gap can not be observed by your naked eye, but it can still seep into a part of the water, so it may inadvertently cause the watch to enter the water, and the solutions to the water in the watch are as follows.

1. Use silica gel to dry the granules, water enters the case, you can use a granular substance called silica gel and put it into a closed container with the watch that has accumulated water, and after a few hours, take out the watch, and the water will disappear completely;

2. Bake with an electric light bulb, if the water is not serious, but there is fog in the surface glass, you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the table tightly, and bake it at a distance of 15 cm from the 40-watt light bulb for about 30 minutes, which can eliminate the water vapor;

3. You can directly wrap a small piece of calcium chloride with gauze, then take out the watch cover, seal the calcium chloride wrapped in gauze and the electronic watch into a plastic bag and box, and wait for half a day to take out the watch, and you can see the water vapor of the electronic watch disappear.

Longines watches will enter the water without paying attention, or the humidity in the place where you live, there is water vapor in the place of work, etc., in addition, there is another possibility that the staff operation is not standardized enough when the last time you changed the battery of the watch, and the case was not completely buckled, so the existence of the gap can not be observed by your naked eye, but it can still seep into a part of the water, so it may inadvertently cause the watch to enter the water, and the solutions to the water in the watch are as follows.

1. Use silica gel to dry the granules, water enters the case, you can use a granular substance called collapsing silica gel and put it into a closed container with a foot of the watch that has accumulated water, and after a few hours, take out the watch, and the water will disappear completely;

2. Bake with an electric light bulb, if the water is not serious, but there is fog in the surface glass, you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the table tightly, and bake it at a distance of 15 cm from the 40-watt light bulb for about 30 minutes, which can eliminate the water vapor;

3. You can directly wrap a small piece of calcium chloride with gauze, then take out the watch cover, seal the calcium chloride wrapped in gauze and the electronic watch into a plastic bag and box, and wait for half a day to take out the watch, and you can see the water vapor of the electronic watch hand disappearing.

First of all, don't be in a hurry, don't dry the battery or use a hair dryer as soon as the water enters, it needs to be treated according to the situation.

There are mainly the following treatment methods: 1. If the water ingress is not serious, but there is a layer of fog in the surface glass, then you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the table tightly, and bake it for about 30 minutes at a distance of 15 cm from a 40-watt light bulb to eliminate water vapor. Do not bake the watch mask directly close to the fire, so as not to deform the watch by heating.

2. Put the surface face inward, the bottom shell facing outward, and wear it on the wrist, and the water vapor can be eliminated after two hours.

3. If the water ingress is serious, it is best to immediately send Longines after-sales to wipe the oil to remove the moisture of the movement to avoid rust of the parts.

Summary. If the watch is damaged by water, the repair cost is very high, and in principle, it is not recommended to repair it.

If the watch is damaged by water, the repair cost is very high, and in principle, it is not recommended to repair it.

That is to say, your Longines watch, if it is damaged because of water, it is the main component of the watch, that is, the motherboard is damaged, for the situation of late encounter, there is basically no way to repair, if you want to repair it, only replace its motherboard.

And this ** is very expensive, and it is basically not recommended to repair it.

In fact, for the 3C class of electronic products after the damage to the water, many times the balance type is not able to repair, if the water damage occurs in the water of your watch, in principle, it will not be repaired for you, because the maintenance cost is quite high, basically equivalent to buying a new one.

Therefore, in your case, it is not recommended that you repair the lead and silver of the ruler, and there are many cases in fact, and the after-sales company will not directly repair you, and many times it is a new one.

It's only been a month since I bought it, so I can't ask for it.

I only bought a month of shirt orange, generally not shouted in the case of after-sales, you can apply for after-sales first, to see if the after-sales or group has warranty service, if the after-sales can apply for warranty service, it must be the best.

Bought in Hong Kong.

If the after-sales service is indeed unable to apply for warranty service, then it is not recommended to repair it in many cases, because the cost of repair is quite large.

If you buy it in Hong Kong, you can directly contact your purchase channel for after-sales service, and you can see if you can invite the after-sales service to the Shendan banquet, but under normal circumstances, there is no way to apply for after-sales service in these situations.

Summary. Dear, hello, the Longines watch will be broken after a month of water, and it can still be repaired.

Dear, hello, the Longines watch will be broken after a month of water, and it can still be repaired.

Dear, if your Longines watch is broken after a month of water infiltration, then it is likely to be caused by water infiltration. [Cute].

Remove the watch as soon as possible and stop using it to avoid further damage. 2.Clean the watch case and strap and gently wipe the surface with a dry cloth for water traces.

4.At the repair point, the technician will conduct a comprehensive inspection of the watch, including the movement, battery, damaged parts, etc., and assess the work and cost required for the repair. 5.

If the watch is still under warranty, you can get a free repair or replacement parts. If the warranty period is exceeded, the corresponding repair fee needs to be paid. 6.

The repair point will provide a detailed repair report for the watch and repair the watch as quickly as possible. The repair time usually depends on the extent of the damage and the available parts, and can take anywhere from a few days to a few weeks. 7.

Once the repair is complete, the repair point will notify you to pick up your repaired watch. When retrieving, check to make sure you are satisfied with the repair. 8.

When collecting your watch, pay the repair fee to the repair location, such as by credit card, cash, or other designated payment method. 9.The repair point may provide a certain warranty period to ensure the quality of the repair.

Make sure you keep your maintenance records and related documents. [Cute].

I bought it in Hong Kong, and I don't know how to repair it.

Dear, this kind of big brand store is generally a chain, as long as there is a store in your area, you can take the relevant purchase information to repair. [Cute].

The mainland can buy it for maintenance at the counter, but the maintenance point bought in Hong Kong is 1,200 repairs.

Dear, if this is the case, you can find some well-known watch repair shops that will provide Longines watch repair services, or you can submit a repair application through Longines official ** or mobile phone application calendar program, and then mail the watch to Longines for repair. [Cute].

Hello dear A Longines watch can be repaired if it breaks down a month after it gets into the water. However, the feasibility and cost of the repair will depend on the extent to which water enters the watch and the extent of the damage caused. When the watch is flooded, it can cause corrosion and damage to the mechanical parts and electronic components inside.

If repairs and drying are not carried out in a timely manner within a month of water ingression, it can lead to further damage, making repairs more complex and expensive. If your Longines watch is still under warranty, you can contact the official Longines after-sales service center for repair or replacement according to the terms of the warranty. They will inspect and evaluate the watch, and then provide a repair plan and cost estimate.

If the watch is out of warranty or out of warranty, you can consult your local professional watch repair shop or approved repair center. They will conduct a comprehensive inspection and assessment and provide you with recommendations and cost estimates for repairs. It is important to note that the repair cost of a water-ingress watch can be higher, as it may require the replacement of damaged parts as well as repairs and cleaning.

In addition, the repair process may take some time, and the specific time will also vary depending on the specific situation of the watch. I hope the above can help you, I wish you a happy life!