GUNPLA repair problem, how to maintain GUNPLA? Thank you.

800, 2000 good water sandpaper sandpaper, and then find a good paper towel with Tiangong finish polish, you must use finish this level. Grind hard, feel the heat and squeak sound, absolutely mirror highlight.

As long as it is not an electroplated plate.

You can simply polish him, polish it with fine sandpaper, and then polish it with toothpaste and cotton.

Sandpaper starts at 1000 and ends up above 1500.

It's actually very simple, wash off the original paint and repaint it!

The overall polishing is estimated to be impossible to do, you can try the whole model spray varnish.

If the color is rubbed off, it is recommended to wipe off all the paint and repaint.

Then polish it again.

This one needs to have a graph to analyze in detail.

From the description, the problem is similar to the plating surface being polished.

I'm afraid I'm going to have to repaint this.

Specifically, you can go to the 78 anime forum and ask about the people there who are very nice.

Spraying gloss varnish shouldn't have much effect, it's just speculation

I'm not very good at technology, but you can go.

Go up and ask where there are many men of God

The overall polishing is estimated to be impossible to do, you can try the whole model spray bright light, carefully sprayed.

Try to put it in the box when you don't play with it, if you must put it outside as a decoration, you can put it into a small display box of about 20 pieces, in fact, the resin yellowing can be cleaned off, and the same quality gold of bandai is not likely to fade, even if it fades, cover it with a golden marker.

Usage of matting spray cans:

It is sprayed directly on the plate.

1. Be careful not to get too close. Generally, the distance of the spray can is 20-30cm, which is to prevent too much paint accumulation on the surface of the model. Don't go too far, otherwise the paint will be half dry before it gets wet, and there will be a rustling feeling after spraying.

2. Hands should be moved. This is also to prevent paint build-up. Spray cans are meant to be used for large-scale painting, so a large amount of paint will be sprayed when you press it.

You can keep the part still (stick it on the sponge with a wooden or plastic stick) and move your hand from left to right at 50 cm per second (this speed is optimal). If it's windy, you can get closer and move more slowly.

3. Do not spray the same position repeatedly. Clear oils, especially matted ones, look semi-glossy before they dry, but when they dry, you will notice that the gloss has completely changed. If you spray too thickly, the white matting particles in the matting paint will accumulate and the matting effect will be lost.

So after spraying once, if the whole surface is shiny (that is, there is a feeling that the surface is wet), it will do. If there is a bulge in some places, it means that there is too much spray in that place. Generally speaking, one spray is fine.

Matting paint can be sprayed as long as the parts are as high as possible, but remember not to spray too much, which will damage the parts.

In addition, MG does not need to maintain a Bandai at most 300 yuan, but I can tell you the maintenance method of PG, the latest product of Jet Tian Palace!

It is best to put it in a box when not playing, and when spraying paint, the model is 20-30cm away, and it must be moved to avoid paint accumulation.

Brush it with toothpaste after dismantling!! Super useful to say! There is also a spray of protective paint to spray every part!!

After painting you should spray a coat of matte paint so that the model does not change color.

Rub the Gouda off with alcohol before (very importantly) coloring. Wait for the paint to dry before spraying matting paint.

The matting paint can be sprayed directly. The color is not easy to fall off after spraying.