What are some tips for cleaning your keyboard? Please, thank you

Keyboards are the most susceptible to dust and other dirt. Here's how you can give your keyboard a new look. Start by using a screwdriver to unscrew the screws on the back of the keyboard.

Place the keyboard face up on the table and gently lift the panel, and we will see a bunch of small rubber pads, and when you see it, you will understand why each key is bouncy. Take out the small rubber pads and wipe them one by one, then put the keyboard panel into the warm water that has been washed and cleaned for a while, then scrub it clean, and finally brush it with a soft brush, and the panel will be clean. The circuit board is generally not too dirty, just wipe it with a clean, soft cloth.

Once the cleaning is complete, let the cleaned keyboard dry for a few hours or use a hair dryer to dry it, and then install the keyboard as it is. When installing, you should first put the panel down on the table, put the two sides with book pads, and then put the small rubber pads into the buttons one by one, then put the circuit board and bottom panel, and finally put the screws.

<><How to clean the keyboard

1. In order to clean the keyboard thoroughly, first find a cloth, the cloth must be soft, so as not to rub off the words of the keyboard and damage the keyboard, wet the cloth with water, and then dry it slightly, fully wash the keyboard, and not use a too wet cloth, because if the water enters the gap under the keyboard, it may cause damage to the circuit.

2. Squeeze a ball of toothpaste, about twice as much as usual brushing, part of it is applied to the particularly dirty keys, and one part is applied to a moist and dry cloth, and then use the cloth to scrub the surface of the keyboard clean, and the part can be wiped for a longer time.

3. Squeeze a ball of toothpaste, about the usual amount of brushing, put it on the palm of your hand, dip a little with a toothbrush, brush the side of each key of the keyboard, and press the key next to it to brush the particularly dirty place, and brush it with a toothbrush until it is clean and satisfied.

4. After the keyboard keys are cleaned with toothpaste, there will be a lot of foam and dirt that is difficult to be removed, which is a very important process, scrub with a toothbrush dipped in water, which is combined with a cloth, the cloth should be scrubbed clean and dried, and the dirt brushed out will be wiped away.

5. To further clean up the dirt, put the dry cloth on your hand, brush the keyboard with a clean toothbrush and then brush the cloth, so brush repeatedly, and the toothbrush needs to be cleaned intermittently until it is basically clean.

6. After continuous scrubbing, there must be acres of dirt not to fall to the lower part of each key, so that the keyboard can be brushed upside down, and at the same time shake it from top to bottom, wipe the dirt off with a cloth, and then hang the keyboard upside down in order to flow out a small amount of water.

7. After the keyboard is dry, wipe it clean with a cloth. After hard work, the keyboard is clean, just like the newly bought one, and the mood of surfing the Internet is much more comfortable, come to an advertising slogan: let your fingers dance on a clean keyboard. Hehe, my friend, don't take it a try.

When cleaning the keyboard, please turn off the wide sensitive computer first, and remove the power cord and battery (if the computer is a removable battery model).

You can use a keyboard cleaning brush or a balloon blow to remove the dust between pressing the keys.

The keyboard will definitely be dirty and dusty after using it for a long time, so you need to clean the keyboard once after using the keyboard for a period of time, thenHow to clean and clean the keyboardIs it clean? Below we will bring you the most complete keyboard cleaning tips, I hope you can help after reading the lead finger brother.

How do I clean my keyboard?

Keyboard cleaning trick 1, tap the keyboard: turn off the computer, remove the keyboard from the host, the key keyboard is facing down, pat and shake the keyboard, let some debris and bacteria inside the keyboard beat out.

Keyboard cleaning trick 2, blow off debris: use a hair dryer to blow through the gaps on the keyboard buttons, in order to blow off the debris attached to it, try to raise the temperature of the hair dryer before blowing, high temperature is also conducive to sterilization.

Keyboard cleaning tip 3: Scrub the surface with a clean towel: Use a soft cloth dipped in diluted detergent to scrub the surface of the keys. Then vacuum the keyboard again.

Keyboard cleaning tips 4, use alcohol disinfection: You can use a cleaning cotton swab to remove the booty bacteria inside the cracks of the keyboard.

Keyboard cleaning tips 5, thorough cleaning: thorough cleaning is to disassemble all the keyboard and clean the inside, which is not recommended for novice friends. Therefore, it is a technical task to take apart and clean the keyboard thoroughly.

Improper operation can easily lead to the destruction of the keyboard. In addition, for waterproof keyboards, you can directly rinse them in water.

Keyboard cleaning tips 6, use keyboard cleaning soft glue: keyboard cleaning soft rubber can clean up the dust and bacteria in the cracks of the keyboard in an all-round way. This kind of keyboard cleaning soft rubber is not expensive, generally around 1-8 yuan, and when shopping ** to buy a new keyboard, many stores will give the keyboard cleaning soft rubber as a gift.

The operation method of keyboard cleaning soft rubber to clean the keyboard is very simple, that is, to dip the "keyboard cleaning soft glue" on the keyboard, and then slowly tear it off, remember to be careful in the process of slowly tearing it off, otherwise the keyboard cleaning soft rubber will be troublesome if it is left in the gap, and you can see the potholes and dust of the keyboard after tearing it off.

The above is for you how to clean the keyboard to be clean? The entire content of the most complete keyboard cleaning tricks.

1. Clean the base: use a soft brush dipped in a little water to dry and then clean it, and blow off the dusty mold with a hair dryer. For particularly firm dirt, wipe it off with a cotton swab + alcohol.

3. Remove all the keycaps and put them in a bucket, put a small amount of cold water (hot water may make the keycaps hot and deformed), just cover the keycaps, and add a washer, or keyboard cleaner.

4. Soak for more than ten minutes, you can clean the keycaps, after a period of soaking, most of the dirt has fallen off, and after washing, you can dry it with a hair dryer.