What is the reason why the pipe connected to the outside of the air conditioner is not dripping?

Updated on Car 2024-06-25
10 answers
  1. Anonymous users2024-02-12

    It is normal for the external unit not to drain; If the air conditioner runs continuously for more than 4 hours, and the indoor unit does not drain water, there may be an abnormality.

    When cooling in summer, the indoor unit blows cold air, the outdoor unit blows hot air, the heat is transferred from the indoor unit to the outside unit, and the condensate pipe connected to the indoor unit produces condensate.

    Here, the temperature of the outdoor unit is getting lower and lower, until it is below 0 degrees, and here it will produce condensation outside, and then frost or ice will form, and the higher the air humidity, the more frost or ice will be formed.

    However, this will affect the heat exchange efficiency of the external machine. So when it was designed, it was designed so that every once in a while, the outside would heat itself up to melt the ice that was wrapped around the outside. Therefore, when it melts, the ice and water will flow directly from the outside machine, making a loud noise.

  2. Anonymous users2024-02-11

    This situation may be caused by the blockage of the internal drain pipe or drainage hole, and it is recommended that you use the wire to repeat it several times to solve the problem. This situation has no effect on the air conditioner, but the condensate cannot be drained out and will leak out of the inner unit and soak the wall, so it is better to deal with it as soon as possible.

  3. Anonymous users2024-02-10

    Turn on the air conditioner for about half an hour to see if there is any water leakage in the room, if there is a water leak, the pipe may be blocked or broken.

  4. Anonymous users2024-02-09

    The reason why the air conditioner does not drip water:

    1. Air drying.

    If it is relatively dry, then there is no way to form water, or the amount is relatively small, in this case, there is no way to drip out.

    2. The height of the water pipe.

    If the tube is bent, it will definitely be blocked inside, and there is no way to flow out, so it is recommended to straighten the tube to solve this problem.

    3. The water pipe is blocked.

    You can wash it, if there is a lot of dirt in it, it will definitely not drip water.

    The principle of dripping water in the pipe of the air conditioner is very related to the principle of air conditioning. The compressor of the air conditioner passes through the refrigerant.

    It is compressed, then expanded through a valve, and the expansion releases heat so that the temperature of the refrigerant is lowered, and then the refrigerant flows into the evaporator in the room.

    Through the contact between the evaporator and the indoor air, the heat of the indoor air is absorbed, and then it is compressed and expanded again, so that the reciprocating circulation takes away the heat of the indoor air little by little. Since there is a lot of water vapor in the air, the evaporator will turn into water when it encounters a very low temperature.

  5. Anonymous users2024-02-08

    Reasons why the air conditioner does not have water outside:

    1. Air humidity.

    What is the reason why the air conditioner does not produce water, the humidity of the air is also a reason that affects the water of the air conditioner, because when the air conditioner is refrigerating, the wind deflector is very cold, so that the indoor air will form water droplets there, and it will be discharged from the external drain pipe, especially when it is high temperature and humidity, or in the afternoon, the external unit drains the most.

    2. Connecting pipe for internal machine.

    There is also a reason that there is a problem with the connecting pipe of the air conditioner, or it is blocked, so it cannot be discharged, at this time, you can see whether the internal unit is leaking, if the water leakage is this problem, if it does not leak, the indoor air is dry, and there are water droplets formed inside, and the drainage is normal.

    3. The height of the outlet pipe.

    When installing the air conditioner, the location of the air conditioning pipe is also very critical, if there is no drainage, it may be because the air conditioning drain pipe is mainly high and outside, there is no way to drain the water, and this situation will also lead to the blockage of the water pipe.

    4. Air conditioning temperature.

    When the air conditioner is working, the external unit can not work normally, and if the temperature of the air conditioner is set relatively low, there will be a situation that the air conditioner does not drain water, and the temperature of the air conditioner cannot be constantly changed when the indoor temperature is set, which will also have a great impact on the compressor of the air conditioner.

    The maintenance of the outdoor unit of the air conditioner is as follows

    1. Clean regularly during use.

    Clean the filter regularly: generally once every two weeks, more often in dusty areas. If the air conditioner is equipped with deodorization and dust removal filters, it should be cleaned and replaced regularly according to the instructions of the manual, and it can be equipped with a voltage regulator

    If the voltage in the area is unstable for a long time (manifested as difficulty in starting the fluorescent lamp, slow fan speed, etc.), it will affect the normal use and life of the air conditioner, and the user can configure the voltage regulator by himself.

    There can be no heat source near the internal unit: there can be no heat source near the internal unit of the air conditioner, otherwise it may not only affect the performance of the air conditioner, but also deform the plastic parts of the internal unit, which will affect the appearance and increase the noise.

    2 Remember to ventilate during the downtime period.

    Dry the moisture of the indoor unit: Before long-term disuse, the ventilation block should be opened to dry the moisture in the indoor unit. Unplug it:

    Unplug the power supply and remove the battery from the remote control of the air conditioner. Cover the inside and outside: If possible, cover the inside and outside with a cover to keep the indoor and outdoor heat exchangers clean.

    Clearing the air outlet before use: Before the use season arrives, the air conditioner should be checked. First of all, remove the cover on the internal and external units, remove the obstacles on the indoor and outdoor air inlets and outlets, then install the remote control battery, turn on the power of the air conditioner, and observe whether the air conditioner is running normally after turning on the machine.

  6. Anonymous users2024-02-07

    The reasons for the lack of water from the outside unit of the air conditioner may be as follows:

    1. Fluorine leakage from air conditioner.

    The air conditioner leaks fluorine, and there will definitely be no condensation flowing out without the Freon cycle. Whether the machine is refrigerated or not, if the machine is not refrigerated or the refrigeration effect is not good, the moisture in the air will not condense, so the air conditioner will not drip water.

    2. Pipeline blockage.

    There are always dust fibers in the air, and the small ones will enter the water outlet hole with the moisture through the air conditioner filter. If the filter is blocked, the air and the evaporator will not be able to exchange heat, and there will be no water outflow.

    3. The air is not humid enough.

    What is the reason why the air conditioner does not produce water, the humidity of the air is also a reason that affects the water of the air conditioner, because when the air conditioner is refrigerating, the wind deflector is very cold, so that the indoor air will form water droplets there, and it will be discharged from the external drain pipe, especially when it is high temperature and humidity, or in the afternoon, the external unit drains the most.

    4. The height of the outlet pipe is too high.

    When installing the air conditioner, the location of the air conditioning pipe is also very critical, if there is no drainage, it may be because the air conditioning drain pipe is mainly high and outside, there is no way to drain the water, and this situation will also lead to the blockage of the water pipe.

    The solution to the water supply of the air conditioner outside the unit:

    In the short term when the air conditioner is turned on, the air conditioner does not produce water, or does not drain water, which is a normal phenomenon, don't worry, just wait for a while. Look at the setting status of the remote control: the refrigeration or dehumidification status should be set to see if it is wrong.

    In addition, it is normal for the air conditioner to not drip water when it is heating. Because air conditioning heating is just the opposite of refrigeration, the gas freon is pressurized by the compressor to become a high-temperature and high-pressure gas, which enters the heat exchanger of the indoor unit, condenses and liquefies heat to become a liquid, and at the same time heats the indoor air, so as to achieve the purpose of improving the indoor temperature. Because the temperature of the indoor unit is relatively high when heating.

  7. Anonymous users2024-02-06

    Dear, hello, I'm glad to answer for you, what happens when the air conditioner drips water but doesn't refrigerate Answer: The air conditioner is not refrigerated and leaks for the following reasons: first check whether there is electricity and whether the power supply is turned on.

    Then check whether the air conditioner is in the working condition of refrigeration. If the indoor unit filter is dirty, open the panel, take out the filter, if there is dust on it, there is a waste toothbrush to wash it in the water. Put it back on.

    If it still doesn't work, check if the compressor is working. Generally, there are several situations that will cause the compressor not to work: the external temperature is too high or the heat dissipation is not good, and the compressor is overheated protection.

    In this case, it is necessary to consider relocation. The evaporator of the external unit is too dirty, and the compressor does not work. Clean, but it's best to have a professional do it.

    Whether the refrigerant is less or not, this should be checked by professionals. Electrical components are faulty, and the air conditioner is not cooling, which is generally the reason. It may be that after the refrigerant leaks, it is not enough to sell it (commonly known as "refrigerant" is not enough), and the refrigerant can be added.

    2.The supply voltage is not enough, and the compressor cannot operate normally. It is recommended to install a voltage regulator.

    3.The refrigeration power of the air conditioner is too small, and the room area is too large; Room insulation is not effective. Take these factors into account when choosing an air conditioner.

    Mobile Game 4The ambient temperature is too high, and the cooling time is longer than usual.

  8. Anonymous users2024-02-05

    What is the matter with the dripping water but not refrigeration of the outer pipe of the air conditioner Hello dear, there are many reasons for not refrigerating, and the possible reason is the phenomenon of the compressor protection device pei liang bending and jumping. Compressor overload protection will trip, indicating that the system is too high-pressure, the pressure is too high, or the overheating current is too high. Causes and elimination of high pressure and overheating:

    1. Too much refrigerant. Reduce the refrigeration dose appropriately. 2. Poor heat dissipation.

    Check the condenser pipe for dirt and dirt and clean the condenser. 3. The pipeline system is blocked. Refer to the pressure gauge to judge, eliminate, and re-process systematically.

    4. Dust and fouling of the evaporator or filter screen. The airflow becomes smaller, the system pressure and temperature are unstable, and the evaporator or filter is cleaned. 5. Fluoride deficiency is also possible.

    When there is a lack of fluorine, the compressor discharge temperature will overheat, so that the key guess overheat load protection switch will trip. The problems in the circuit are: 1. The control circuit board is faulty.

    2. The temperature sensor is overloaded and the information is wrong. 3. The power supply wiring is loose and the contact is poor. 4. The starting capacitor or compressor starting coil is burned out.

    The information is insufficient, so it can only be analyzed in this way, and there are many other possibilities, It is recommended to find a professional maintenance personnel to check it. Hope it can help you, satisfied. Thank you.

  9. Anonymous users2024-02-04

    When the air conditioner does not drip water, it is very likely that the connecting pipe is blocked, and after a long period of use, the connecting pipe is easy to be clogged if it is not cleaned and the water cannot be discharged; At this time, you can check whether there is water leakage in the inner machine, if there is water leakage, it is most likely this problem, if there is no water leakage, it may also be that the indoor air is too dry and the water droplets are formed, after the formation of water droplets, it is normal to not drip water. At this time, you need to find a professional to readjust the position of the air conditioner, adjust the air conditioner to a horizontal position, so that it can be kept level or as consistent as possible, so that the air conditioner can be used normally. Maintenance Method:

    Usually, household air conditioners are shut down and deactivated in September, and they are not turned on until May and June of the following year, and they are out of service for more than half a year. Therefore, before the air conditioner is turned on, a comprehensive "diagnosis" must be done, check whether there is a "problem" with the air conditioning equipment, and do a good job of maintenance and cleaning under the guidance of professional and technical personnel according to the results of the inventory; This maintenance and cleaning should be in place, including the shell, body, and filter of the outdoor unit and the indoor unit, and then start the trial operation to observe the refrigeration speed and effect.

  10. Anonymous users2024-02-03

    <> If the indoor humidity is insufficient, it is normal for the air conditioning pipes to not drip water. If the humidity is normal, the air conditioning pipe does not drip is not an abnormal number of wild jets, it may be that once the connecting pipe of the internal machine is blocked, it will lead to the water discharge can not be distinguished, or it may be that the air conditioning drainage pipe is in a state of high inside and low outside.

Related questions
20 answers2024-06-25

If someone else's air conditioning exterior pipe in the community occupies the bay window of our house, then we should discuss it with him to see if it can be improved and not occupy other people's things.

10 answers2024-06-25

If the contactor is engaged when the machine is turned on, the fan is working at this time, and the press is not working (the capacitance is good), the contactor can be preliminarily judged to be bad. Because both the press and the external fan are controlled by the normally open contacts of the contactor, the contact work is synchronized. If one of them works, the other does not work, which can be roughly judged as contact with the bad. >>>More

10 answers2024-06-25

When the outdoor temperature is lower than 0 degrees Celsius, the outdoor unit of the air conditioner will immediately frost, and when the user turns on the air conditioner for heating, it takes about 8-12 minutes to "defrost", and some users mistakenly think that the heating effect of the air conditioner is not ideal. 2. Due to improper use and maintenance by users, etc. 3. The reason why the air conditioner cannot work normally is because the power consumption increases greatly, which may cause the regional power supply voltage to be unstable or too low. >>>More

5 answers2024-06-25

Computer heat stroke. The CPU needs to dissipate heat.

Memory was the first to revolt. >>>More

12 answers2024-06-25

In the beginning, love was very passionate.

But after a long time, if you add that he eats you, then his true nature will be completely exposed. >>>More