How to solve the freezing in the drainage hole of the refrigerator fresh keeping room?

To solve the problem of freezing in the drainage holes, on the one hand, it is necessary to reduce the collection of water, and on the other hand, the temperature should not be set too low. The following measures can be taken: 1. Do not put the food that is not cold into the refrigerator, because the food that is not cold will not only raise the temperature in the refrigerator, but also evaporate the water vapor into the refrigerator.

Therefore, the food should be cooled thoroughly, and when put in the refrigerator, use a crisper or plastic wrap to seal it. 2. Reduce the number and time of opening the door, when the outside air humidity is high, try to open the refrigerator door as much as possible, and do not open the door for too long to reduce the entry of external moisture. 3. Check the tightness of the refrigerator door, if there is more food in the refrigerator, the refrigerator door is not closed properly, or there is a problem with the door seal of the refrigerator, the airtightness of the refrigerator will be affected, and the moisture from the outside will enter the refrigerator and increase the condensation of water vapor.

4. To prevent freezing, do not set the temperature too low, the direct cooling refrigerator is mostly mechanically controlled by temperature, that is, the gear is set through the dial, generally in the refrigerator. Therefore, the refrigerator temperature is generally set at 1-3 to meet the use. If you're putting in a lot of food, you can set it at 6 or 7, but it's best to move back to 1-3 after a day.

Reduces the likelihood of icing. Sometimes, even if there is no freezing, the drain hole is in the lower part, and it is easy to be blocked by food debris in the refrigerator, resulting in poor drainage. When the direct cooling refrigerator leaves the factory, the manufacturer is generally equipped with a "through-hole pin" to dredge the drainage hole.

If there is no through-hole pin, don't worry, you can use soft copper wire or iron wire to insert it into the drainage hole to dredge. Note: The tip of the copper or iron wire should not be too sharp.

1. Non-faulty water accumulation Non-faulty water accumulation is due to the user's usage habits, resulting in an increase in water vapor inside the refrigerator. When the water vapor encounters the inner wall of the cooler refrigerator, it will condense into water, and if there is too much water, the drainage hole will not have time to drain away, resulting in water accumulation. There are three common habits that tend to cause water accumulation:

1. Hot foodPut hot food in the refrigerator, and the moisture in it will evaporate quickly. Therefore, it is best to wait for hot food to cool before putting it in the refrigerator, or wrap it in a layer of plastic wrap before putting it in. 2. Open the door frequently (open the door but not close) When the refrigerator door is opened, the hot air outside the refrigerator will be mixed with water vapor (the humidity in the hot air is greater) and quickly enter the refrigerator.

3. Put the freshly washed dishes directly into the refrigerator and put the dishes in the refrigerator without protection. This moisture will slowly evaporate in the refrigerator, causing the refrigerator to accumulate water. 2. Faulty water accumulation 1. Blocked drainage holeWhen there is water in the refrigerator, it should be discharged through the drainage hole.

However, if the drain hole is blocked, it will inevitably lead to water accumulation in the refrigerator. The problem of drain holes is very easy to solve, just take a thin wire and poke it into the drain hole, some refrigerators will have their own tools (plastic rods) to unclog the drain holes. 2. The sealing strip has been aging for a long time, and the sealing strip is polluted or aging, which will lead to poor sealing of the refrigerator.

The consequence is the same as opening the door of a refrigerator, and the air outside the refrigerator rushes in, carrying a large amount of water vapor. 3. The problem of damage to the thermostat is more serious, which means that the thermostat has failed. And the thermostat is the commander of the refrigerator, controlling the start and stop of the compressor.

If the thermostat is broken, it will cause the refrigerator to not stop and keep cooling. As a result, the temperature in the refrigerator will drop again and again, and the temperature in the refrigerator will drop below freezing, which will naturally cause freezing.

Ways to remove ice from drain holes:

First unplug the refrigerator, open the refrigerator door to take out the food inside, let the ice slowly melt in the natural environment, find a wire to poke down from the drain, and pour some warm water from the drain hole to help melt the ice. Until all the ice in the drain hole has melted and drained.

Extended information: Tips to completely solve the icing of drain holes: The outlet of the drain hole of the refrigerator is above the refrigerator compressor, and the water discharged from the drain hole falls in the water tray above the compressor, and the heat dissipation temperature of the compressor evaporates the water into the air.

The temperature of the compressor is very high, and the temperature of the high-pressure pipe will reach about 70 degrees Celsius. Insert a wire into the refrigerator from the outlet of the drain hole, one end of the wire should not go beyond the drain opening, and the other end is wrapped around the compressor's high-pressure pipe. Because the temperature of the high-pressure pipe is very high when the compressor is working, these temperatures will be conducted to the iron wire, because the iron wire is connected to the drain port of the refrigerator, so as to ensure that the temperature of the entire drainage hole will not fall below zero, and there will be no freezing.

The drain hole of the refrigerator fresh-keeping room is frozen, in this case, the power should be cut off, clean the fresh-keeping room, try to put less things in the safe, do not cover the drain hole, so that the problem of freezing of the drain hole can be solved!

Hello. In general, it may be because when the food is refrigerated, the food residue enters the refrigerator drain hole, resulting in the blockage of the refrigerator drainage, and the ice in the refrigerator drain pipe cannot melt in time, which will actually lead to the blockage of the drain hole. Poke the chopsticks into the drain hole in the refrigerator to unclog the drain hole pipe.

By doing so, you will avoid water accumulation in the refrigerator compartment that can lead to freezing.

How to deal with freezing in the drain hole of the refrigerator's fresh-keeping compartment? Then you can turn off the power of the refrigerator so that the frozen area slowly opens, and that's it!

It's recommended to dredge it every week, don't wait until it freezes and you can't do it, now you can take things out first, and then wait for the ice to melt and clean it up.

First cut off the power, then open the back cover of the refrigerator, wrap the compressor in a plastic bag, and leave a hole in the corner under the drain hole.

This means that your temperature should be relatively low. In other words, if this temperature is slightly higher, then your place will not freeze, that is, the temperature of this normal temperature place is a little low.

This situation is mainly due to the high humidity in the refrigerator room, the surface temperature of the evaporator on the wall of the refrigerator room is -20 when working, and the moisture in the air in the refrigerator will gather on the back of the refrigerator and condense into ice beans or frost.

Blanch hot water, dredge smoothly, do not store water when blanching, and dry it in time.

Turn the refrigerator temperature up because the temperature in the refrigerator compartment is low in winter, and the defrosting water freezes.

Answer: The heat contained in the food will condense water and adhere to the inner wall of the refrigerator, if the heat is dissipated more, it is likely that the entire space of the refrigerator refrigerator will not reach the refrigeration temperature, then the compressor of the refrigerator will continue to work under high load, so that the place where the inner wall of the refrigerator refrigerator contacts the evaporator will freeze. The refrigerator compartment is too crowded, the internal air cannot form a circulation, and when the refrigerator stops working, the gradually rising temperature is hindered and cannot reach the evaporator, and the rime on the evaporator does not melt away, so it starts working again. It's freezing in the fridge.

The temperature control of a direct-cooling refrigerator is not as precise as that of air cooling, so even if the refrigeration temperature is set above 0 degrees, the temperature at the back plate may be below 0 degrees, which is not difficult to explain why the drain holes are prone to freezing.

What should I do if the drain hole in the refrigerator freezer is frozen? Drainage hole icing is generally caused by blockage or insufficient foaming, to be solved according to the specific situation, the former to solve the blockage, de-icing can be solved, if it is caused by insufficient foaming, icing first to unplug the refrigerator power supply, claw a foot thick copper core wire, one end into the drainage hole, not the other to wrap it, the temperature of the high-pressure pipe on the high-pressure pipe can be transmitted to the drainage hole, and the icing is solved.

You can use a hair dryer or hot water or put some salt in it and wait for a while it should melt, but it will be unblocked by injecting gas with a gas pump.

The refrigerator is always frozen, and it turns out that the problem appears in this small hole, and a trick teaches you to solve it quickly.

1. Causes of icing.

1. The air humidity in the freezer is relatively large, while the temperature of the evaporator in the refrigerator is relatively low, so the water vapor in the refrigerator will condense to the back wall and form ice.

2. When the temperature of the refrigerator drops, the ice on the back wall of the refrigerator will melt into water and flow out through the drainage hole. However, if the drain hole of the refrigerator is blocked or the setting mode is incorrect, the water flow is not smooth or the ice is not completely melted, and the refrigerator freezes in the refrigerator.

3. The refrigerator is not closed tightly, resulting in the condensation of water vapor in the air.

Second, the solution.

1. If the ice is thick, it should be de-iced in time, cut off the power supply first, then open the freezer door, take out the food, and clean it up after it melts naturally. It can also be cleaned with special cleaning tools, but not with metal products to avoid damaging the pipeline, or you can add a glass of boiling water to the refrigerator to speed up the melting speed.

2. If the drainage outlet of the refrigerator is blocked, resulting in poor drainage, and too much water in the box causes freezing, you need to check it first, there is a drainage hole in the middle and lower middle of the back wall of the refrigerator.

3. If the temperature of the refrigerator is too low, and the melted water cannot be discharged during the normal shutdown of the refrigerator to cause freezing, you can check it, there is a drainage hole in the back wall of the refrigerator refrigerator, and the melted water can be discharged from here during normal shutdown. Open the small lid behind the refrigerator to see the head of the drainage, and blow hard against the pipe to blow out the debris. Then pour some water from the drain hole in the refrigerator and rinse it several times.

You can see if the drain hole is blocked by foreign objects If not, it may be the refrigerator refrigerator drain pipe It is too close to the refrigerator refrigeration system pipeline You should find after-sales service After your refrigerator is opened, take a new drain pipe and then foam it from the new It will be foolproof I hope to help you!!

Dear, first cut off the power, if there is ice, melt the ice, find a slender steel wire or hard wire, and poke it open at the drainage hole in the back of the refrigeration;

You can first check whether there is vegetable leaf residue or something in the drain pipe, find a dredge with the wire, if there is no residue in it and often freeze, you can turn the gear up a bit, adjust to 3-4 gear to try.

There is a problem with refrigeration.

I've come across it too.

Ask the workers to fix it.

The refrigerator has always been an indispensable household appliance in every family life. Some families keep their refrigerators open year-round to keep ingredients fresh. But what should you do if water or ice appears after using the refrigerator for a long time?

Today I'm going to share with you a recipe for coping with a lot of family problems. The drain pipe of the refrigerator is clogged and drainage is difficult. Refrigerator Under normal circumstances, the main problem of the freezing temperature of the refrigerator has a lot to do with the food reserve, the humidity in the freezer room is too large, the temperature of the refrigerator is too low, add ice, generally minus 18 degrees, according to the situation of the food reserve, it can be increased to minus 15 degrees 12 times, the temperature of the refrigerator rises, and freedom will not freeze the wall of rapid drainage.

<> refrigerator is designed with an automatic defrost system. An automatic defrost system doesn't solve this problem either. Your fridge is broken, probably with a lack of refrigerant.

If the refrigerant pipeline system lacks refrigerant, during the circulation process, the refrigeration capacity is insufficient, the refrigerant cannot keep up with the front and back, and the pipeline system has serious vacuum suction in circulation. The lower the vacuum, the more water there is in the freezer, so it will only freeze and not freeze, so the drain of the freezer will freeze and clog badly.

Unlike air-cooled refrigerators with fans, straight refrigerators rely on the heat conduction of air to achieve the overall cooling of the refrigerator compartment. As a result, the water in the refrigerator will condense on the inner wall and flow to the bottom. The purpose of the drain hole is not to let water into the cold room.

At the same time, the evaporator of a straight refrigerator is generally located on the back plate of the refrigerator, so the closer the refrigerator is to the back plate, the lower the temperature. The temperature control of a straight freezer is not as precise as that of air cooling, so even if the refrigeration temperature is set above 0 degrees, the temperature on the back may be below 0 degrees, which explains why the drain holes are prone to freezing.

There will be water or ice in the refrigerator compartment of a regular refrigerator. There are two conditions. The first condition is that there is enough standing water.

When water vapor gets cold, it forms water droplets on the walls of the refrigerator. At this point, once the refrigerator drain hole is blocked, water droplets can form a water problem. Therefore, we should regularly clean the drain holes in the refrigerator compartment to avoid its blockage.

Start with chopsticks. Then insert the chopsticks into the drain hole of the refrigerator freezer to unclog the drain hole pipe. In this way, you can avoid freezing situations caused by water accumulation in the freezer.

You can turn off the power of the refrigerator, take out the food inside, and wait for the ice to melt naturally, then find a relatively thin wire to unclog the drain so that you can avoid freezing.

First of all, you need to unplug the refrigerator, let the ice slowly melt in the natural environment, find a wire, and pierce it down from the drain to dredge it more.