What to do with coconut shoelaces to press the instep, how to fix the coconut shoe laces

Coconut laces to press the instep of the solution:

1.Pull out all the laces, fold them in half, and thread them through the holes in the same way as you normally wear them, and then wear them from the inside out.

2.Thread the laces through the first row of holes on the lowest side, and align the laces at both ends to ensure that the laces are of equal length.

3.Thread through the second row of outer holes, then through the first row of outer holes, and then thread the laces through the second row of inner holes, doing this at both ends of the laces to form two "X" shapes on the bottom side of the upper.

4.Thread the laces through the third row of inner holes, noting that the above steps are done on one side and there is no crossing between the laces.

5.Cross the laces so that the left lace is threaded through the fourth row hole on the right and the right lace through the fourth row hole on the left.

Coconut shoes laces sloppy foot solution:

1.Hit the upper with a hammer to soften the upper a bit so that the laces don't feel so awkward.

2.Stuff some newspaper in your shoes, be careful not to use too much water, and soften the newspaper so that you can prop up your shoes and reduce friction.

The above is the solution for coconut shoelace presser instep and coconut shoe lace awkward foot.

After pulling out all the laces, thread the laces through the first row of holes on the lowest side, and then pair the laces at both ends. The left and right shoelaces are threaded through the fourth row of inner holes on the opposite side, and after the two side laces are threaded out of the third row of outer holes, they are threaded through the outer holes of the fourth row, and finally the third and fourth rows of shoelaces are wrapped vertically.

Coconut laces are not a way to sloppy your feet

1. If you want to make the coconut shoelaces not awkward, it is recommended to pull out all the shoelaces first, and then wear the shoelaces out of the first row of inner holes on the lowest side, and then align the shoelaces at both ends to ensure that the length of the shoelaces at both ends is equal.

2. Thread the shoelaces through the outer holes of the second row, and then through the outer holes of the first row, and then thread the shoelaces through the inner holes of the second row, and operate both ends of the laces in this way to form two "X" shapes on the bottom side of the upper.

3. Thread the shoelaces through the inner hole of the third row, it should be noted that the above steps are carried out on one side, and there is no crossing between the laces. After that, cross the laces so that the left lace is threaded through the fourth row hole on the right and the right lace is threaded through the fourth row hole on the left.

4. After the laces on both sides are threaded out of the third row of outer holes, they are then threaded through the fourth row of outer holes. After that, wrap it vertically between the third and fourth rows, and use up the remaining laces, and after the laces on both sides are operated in this way, the laces that are tied out will not be awkward.

1. If the coconut shoes press the instep, you can see if it is because the shoelaces are too tight, if it is because the shoelaces are too tight, you can loosen the shoelaces, so that the shoes will not strangle the instep.

2. You can also use the method of hammering, first soak the towel with hot water, cover the silver edge of the heel for a few minutes, let the wet place of the leather become soft, and then take the glass bottle and other cylindrical objects to gently knock and crush until the shoes become soft.

3. If the shoes are too small or the feet are too fat or too thin, this will cause the forefoot to be squeezed, you can soak the newspaper, pay attention not to too much water, soften the newspaper, and then stuff it into the shoes to cover the fight. According to the actual situation, the amount of newspaper can be decided, and after a period of time, the purpose of propping up the shoes can be achieved.

1. If the coconut shoes are pressed on the instep, you can see if it is because the laces are too tight, if it is because the laces are too tight, you can loosen the laces, so that the shoes will not be so strangled.

2. You can also use the hammering method, first soak the towel with hot water, cover the edge of the heel for a few minutes, let the wet place of the leather become soft, and then take a glass bottle and other cylindrical objects to gently knock and crush until the shoes become soft.

3. If the shoes are too small or the feet are too fat or too thin, this will cause the forefoot to be squeezed, you can soak the newspaper, pay attention not to too much water, soften the newspaper, and then stuff it into the shoes. According to the actual situation, the amount of newspaper can be decided, and after being placed for a period of time, the purpose of the shoe can be achieved.