What s the matter with the range hood dripping all the time

There are three causes, which are lack of oil in the bearing, contamination of the gas probe and position offset.

Answer: There are three reasons.

Lack of oil in the bearing: If the bearing in the range hood is relatively dry during operation, it will keep ringing, which is caused by the lack of oil, and it needs to be disassembled and drip some lubricating oil at the bearing, and then it will not ring.

Contamination of the gas detector: If the inside of the range hood is not cleaned for too long, the gas sensor will be contaminated with a lot of oil and dirt, and it will make a noise. You need to wipe the grease with dish soap and wash it off with water, so that it won't sound after natural air drying.

Position offset: If the range hood is not installed properly, after a period of use, there will be a certain shift in the position, and the fixing screws will also be loosened, in this case, there will be a sound all the time, and it needs to be removed and reinstalled.

Hurry up and check the gas pipes and gas stoves in your house, and turn off the valves of the gas pipes. Nowadays, many range hoods have a gas leakage alarm function, and the non-stop dripping sound must detect that the gas concentration in the air exceeds the standard. If you check and confirm that there is no problem with the gas pipe and gas stove at home, then there must be a problem with the gas leakage alarm of the range hood!!

Answer: Hello dear, the non-stop dripping sound is to detect that the gas concentration in the air exceeds the standard, but if the inspection confirms that there is no problem with the gas pipe and gas stove at home, it is a problem with the gas leakage alarm of the range hood.

Cleaning method: 1 Take a plastic bottle (all kinds of beverage bottles that can be pinched flat by hand), poke more than 10 small holes in the cover with a sewing needle, and then fill it with an appropriate amount of cleaning detergent, and then fill it with warm water and shake evenly.

2. Start the range hood and spray the cleaning liquid with a plastic bottle full of detergent to the part to be washed.

3 After the cleaning solution in the bottle is used up, continue to prepare and repeat the cleaning. Until the dirty water flowing out becomes clear, depending on the degree of fouling, it can be rinsed after 3 times.

4 If the fan blade is equipped with a grille, it is advisable to remove the grille first to enhance the washing effect.

5 Use a rag to wipe the area around the suction port, the surface of the casing and the lampshade.

Question丨The machine I just bought, it was used for less than ten days, what is the reason for this situation today?

moved, and there will be no warranty after sales at that time.

Question Okay, thank you.

Check whether the smoke cavity has fallen into something, generally the check valve of the air outlet has fallen!Then there is the abnormal sound of the wind wheels.

1. It may be that the gas concentration in the air at home is too high, and the Didi alarm sound from the range hood. 2. It is also possible that the range hood alarm is faulty. 3. There may also be too much dirt in the range hood, which causes the alarm sound.

How to deal with the drip sound of the range hood:

1. When the range hood at home keeps ringing, you must check whether the gas pipeline at home is leaking or not closed, and after checking the gas pipeline, you also need to detect whether the gas stove is damaged, generally speaking, the range hood.

Most of the alarms are caused by these two aspects, which reminds that it needs to be repaired as soon as possible, if you forget to close the gas valve, then after closing the gas valve, the drip alarm sound of the gas stove will automatically disappear.

2. After checking the gas pipeline and gas stove at home, if no gas leakage is found, then it is possible that the alarm system of the range hood is faulty.

3. The range hood is a place where it is very easy to accumulate oil stains, and it needs to be cleaned regularly, if it is not cleaned regularly, it will cause the operation key to fail, at this time, you only need to remove the oil stains in the range hood, and it can be used normally. Note that when cleaning, be sure to unplug the power switch to prevent the risk of electric shock during the cleaning process.

The range hood has a gas leakage alarm function, and the non-stop dripping sound should detect that the gas concentration in the air exceeds the standard, and it should be checked to confirm whether there is a problem with the gas pipe and gas stove at home, if not, then there should be a problem with the gas leakage alarm of the range hood. You can restart the hood after checking that it is correct.

The basic common sense of the use and maintenance of range hoods:

1. The installation height of the range hood must be appropriate, so as to ensure that it does not touch its heads, but also to ensure the effect of the range hood.

2. In order to avoid the occurrence of excessive sound or vibration, oil dripping, oil leakage, etc. The range hood should be cleaned regularly to avoid excessive oil sticking to the inner surface of the motor, turbine and range hood.

3. When using the range hood, it is necessary to keep the air circulation in the kitchen, which can prevent the air in the kitchen from forming negative pressure and ensure the suction capacity of the range hood.

4. It is best for consumers not to disassemble the range hood for cleaning without authorization, because once the motor is not installed, the smoking effect cannot be guaranteed, and the noise will increaseIt is best to let the manufacturer's professionals clean it.

The range hood has been ringing, you have to check whether the range hood is in ** has poor contact? caused this dripping and dripping.

That's because there is water vapor dripping from the range hood, which is a normal phenomenon.

1.The sound of the range hood may be caused by the alarm device, at this time, you should pay attention to whether the gas in the kitchen exceeds the standard, whether there is leakage, if you do not turn off the alarm device in the range hood.

2.Water ingress into the range hood fan may also cause a dripping sound, at this time, you need to turn off the range hood, disconnect the power supply and use a hair dryer to dry the fan.

3.Check whether the automatic smoke exhaust function of the range hood is turned off, if it is turned off, it may cause an alarm caused by too much smoke in the kitchen or the gas sensor probe is polluted by oil and gas, then the automatic smoke exhaust function can be turned on and ventilated.

4.It may be that the internal parts of the range hood are aging or worn, at this time the work of the range hood should be stopped, and professional maintenance personnel should be asked to disassemble it, and if it is worn or aged, replace it with new parts.

5.If the turbine is too loose or the turbine is faulty, you have to wait for the maintenance personnel to replace it with a new one.

6.Check the smoke chamber for foreign objects, and if so, gently remove the foreign objects with tweezers.

7.The smoke alarm device caused by the aging of the internal circuit of the range hood is abnormal, and the internal electronic circuit needs to be replaced.

8.If the smoke in the kitchen is too large or too humid, and the gas valve from the natural gas ignition is damaged, it will also lead to an abnormal alarm of the range hood.

See if there are any measures in the manual?

Hello, I have seen your question and am sorting out the answer, please wait for a while 4. The smoke alarm device caused by the aging of the internal circuit of the range hood is abnormal, and the internal electronic circuit needs to be replaced. Hope it helps! I wish you a happy life and a happy day.

Hope it helps! I wish you a happy life and a happy day.

What kind of range hood does the landlord use? Which model?

Find an after-sales person and ask him to change the switch for you, it should be a problem with the switchIt may be that there is a problem with the integrated line, and you have to find a dealer for repair.

Or there may be water during cleaning, if the sound time is short, the problem should not be big, if the time is long, then you have to ask the master to check it.

Precautions for the use of range hoods:

1.Turn on the range hood for 1-2 minutes before cooking to get a good smoke extraction effect.

2.When replacing the bulb of the range hood, the power should not exceed the maximum value indicated on the manual, otherwise it is easy to cause the temperature rise of the wire connecting the lamp holder and the lamp holder to be too high, resulting in the potential danger of electric shock.

4.Before replacing the bulb or cleaning the range hood, unplug it and cut off the power supply.

5.Clean the oil filter regularly, remove the oil mesh and soak it in a neutral detergent for about 10 minutes, then use a soft brush to wash the dirt and wipe it dry, please use a neutral detergent and a soft cloth when cleaning, so as not to damage the surface or coating of the shell.

CPU usage peaks and troughs? This doesn't seem to affect it, presumably because your memory module is loose. You can wipe the memory clean with an eraser, reinstall it, and then turn it on.

Because the memory of the fingers will be oxidized over time, so the connection is broken, and we re-wipe it, is clean of oxide, and it can be a good contact.

I forgot to turn off the gas stove. Gas stove alarm.

The reason is that, 1. The gas leakage alarm function functions. 2. The uneven weight and uneven distribution of the blades will make the vortex balance unstable, when the vortex or deviates from the coaxial and concentric motion trajectory, it will produce a shaking sound or a scraping sound with the cavity wall, the motor bearing and the vortex inner diameter hole will have a pladance deviation due to wear, and then produce a swinging sound, and the knocking sound of some parts of the machine due to loose connection of the smoke sucking machine, and the motor will produce a dull sound due to long-term overload operation under the conditions of strong wind, high pressure of the common flue, and poor air inlet and outlet. 3. There is a problem with the sound control system of the range hood.

Solution: 1. Hurry up and check your gas pipes and gas stoves, and close the valves of gas pipes. Nowadays, many range hoods are equipped with the function of gas leakage alarm, and the non-stop dripping sound must have detected the excessive gas concentration in the air.

If you check and confirm that there is no problem with the gas pipe and gas stove at home, then there must be a problem with the gas leakage alarm of the range hood, and you need to contact a professional to check. 2. To replace the 100% anti-smoke flue check valve, the market price is about 80 yuan, and the ordinary one is about 10 yuan. And it is best to put sealant on the wall hole to prevent air leakage.

3. Contact the after-sales maintenance personnel to check and see what the fault is, so as to deal with it as soon as possible. so as not to produce a bigger failure.