How to make a homemade fishing bottle, how to make a fishing bottle out of a bottle

1.First of all, we need to prepare an empty plastic bottle (it is best to use a bottle with a relatively high hardness, which has good plasticity and is not easy to deform).

Please click Enter a description.

2.Then cut along the bottle (you can first use a knife to cut a notch, and then use scissors to cut it), and then drill two holes at the left and right ends.

Please click Enter a description.

3.Then we prepare a thick wire about 8 10 cm long, not too thick, too thick will increase the weight correspondingly, and it will be difficult to twist.

Please click Enter a description.

Twisted like this.

Please click Enter a description.

5.Go through the bottle again.

Please click Enter a description.

6.Fold the two ends in half to prevent the wire from falling off.

7.Unscrew the cap again and drill a hole in the cap.

Please click Enter a description.

8.Prepare a fishing line that you usually use, but of course other lines are fine, about one meter long. Thread through the cap.

9.Tie a few knots at the ends, or wear a space bean to prevent the cap from falling off.

Please click Enter a description.

10.Then use wire to make such a hook.

Please click Enter a description.

11.Then thread the thread through the hole above the hook and tie a knot to make it like this.

Please click Enter a description.

12.Then drill a few holes in the bottle to drain the pressure.

Please click Enter a description.

Please click Enter a description.

The guy makes plastic bottle fishing, which is simple to make, but it is a realistic version of the fishing artifact!

1. First of all, we need to prepare an empty plastic bottle (it is best to use a bottle with a relatively high hardness, so that it can be said to have good plasticity and is not easy to deform).

2. Then cut along the bottle body (you can first use a knife to cut a hole, and then use scissors to touch and cut it), and then drill two holes at the left and right ends.

3. Then we prepare a thick wire about 8 10 cm long, which can be too thick, too thick will increase the weight accordingly, and it will be laborious to twist.

4. Twist it like this with pliers.

5. Pass through the bottle again.

1. Find an ordinary canned bottle and tie it with a rope to the shrinkage of the bottle mouth for 2-3 meters, and tie the outgoing wire to the winding board.

2. Find a small fish pond or wild water area with more fish (it is best to find a corner of the fish pond where small fish are more concentrated, and it is best to find a place with plants in the water in wild water, where there is more organic matter and suitable for small fish to feed).

3. The requirements for bait for catching small fish are not too high, you can use some leftover bones, or you can go to the fishing gear point to buy some commercial bait (commercial bait should be used with a large proportion or should not float away from the canned bottle).

4. Put the bait in the bottle, and then drag the other end of the line to throw the bottle out, (the bottle should be filled with water) When you feel that the bottle has reached the bottom of the water, you can fix the thread in your hand in a place to rest.

5. Pull it up in a few minutes and take a look, try to hurry up when pulling, there will be some small fish and shrimp in it.

How to make a bottle by hand The content is as follows:

Method 1: 1. Manual aircraft; Attach the paper to the bottle. Cut out the wings and propellers. Fasten to the plane and it's done.

2. a storage box; Pinch the bottle into a heart shape, glue cardboard, fix it together, and you're done.

3. a toy trolley; Cut the bottle, decorate it with a cap, dig a few small holes in the wheels, install the wheels, and a small car is ready.

4. handmade bottles; Cut the bottom of the bottle, wrap it with cardboard, cut out some shapes to make a fussy decoration, and fix it.

5. a storage box; Cut the bottle and pinch it into a heart shape, wrap it in colored cardboard for decoration, and finally use a piece of cardboard to make a handbasket, and you're done.

Method 2: 1. The bottle can be used to make a pen holder: take a pen and draw a mark on the mineral water bottle, remove the bottle head, and cut the bottle along the mark.

Mix the white and red pigments together, apply the outer part of the bottle with a mask material, apply a little white paint to the bottle, and draw two black dots as eyes. Slightly retouch the eyes under the noisy hall, draw the nose, and the mineral water bottle DIY pen holder is completed.

2. The bottle can be used as a decorative bottle: plastic beverage bottles, cut from the upper part of the bottle body, cut into two, cut vertically, cut to the position of the pattern to stop, cut into thin strips of equal width, cut the bottle body into thin strips of equal width all week, start to weave flowers, first buckle the bottle body down, so that the cut out of the tassels, is put over and no longer retracted. The bottle for decoration is ready.

Here's how to make a good look at the bottle:

1. Clean the empty laundry detergent bottle, mark the empty laundry detergent bottle and clean it, and the label on it is best to remove it, so that it is more convenient to operate it later. In addition, it is necessary to draw a line, which can be drawn with a marker, so that we can use a knife to cut along the line.

2. Use a knife to cut along the scribing lineWhen we design the line, we have to think about what it will look like. If it is a little more complicated, the cutting will be more laborious, and this requires patience.

3. Decoration is basically the last two steps, we can use a marker pen to decorate some patterns on the surface to make the whole "flower pot" look more beautiful.

4. The hollow vase is made to cut it out with a small hole, and a hollow vase is made, of course, everyone knows that it is easier to hollow out with hot ironing, but in the production process, the plastic will emit toxic gases that are harmful to health, so this rigid and primitive taxi method is adopted.

5. Find a Coke bottle first, take out a marker and draw a circle where the upper part of the Coke bottle connects with the lower part. Take out a utility knife or scissors and cut along the circle. After cutting, then draw a circle on the smooth place of the lower part of the bottle body and the interface with concave and convex places, and then use the scissors to cut it from the upper part to the place where the circle is drawn, and cut out one by one.

1. Tie the fishing line directly to the mineral water bottle slippery town, circle a few times, hang the lead sinker on the fishing line, and hang the bomb hook about 15 cm on the sinker. Bomb hook on the bait. After getting it done.

Hold a bottle of mineral water in your left hand and bait in your right hand. Throw as far as you can into the water. When throwing, the mineral water bottle in your left hand is in the same direction as when you throw it.

to ensure that the throw is far. It is similar to the function of the sea rod reel;

2. When winding the line, it is best to line it up in a circle, not too messy. If the wire is hard, it is easy to knot and break the wire when thrown. Throw the mineral water bottle after reading out, it is best to press it with a stone to match a pair of gloves, and when you hear the sound of the mineral water bottle, it is a fish in the trouble.

To say that as an old fishing friend who has been in the pit for more than ten years, I have basically seen all kinds of fishing methods, although I dare not say that I know all the fishing methods. But when it comes to various fishing methods, at least everyone knows what is going on. But recently, I discovered a somewhat amazing way to catch a fish, and if you don't see someone catch a fish with your own eyes, you really don't believe that this method of fishing can catch a fish.

You should know that this method of fishing does not require a fishing rod.

No floating, not even a hook. You only need to tie a glass bottle with a rope to catch a fish easily, and it seems that the fishing efficiency is not low. I don't know if any anglers have ever caught fish like this.

I feel that it is used to catch small fish, and the effect is really good.

Use a sturdy rope to tie it at the parallel, remember to tie it tightly. Bottles can not be used by any bottle, and finally choose this kind of bottle that is relatively long, with a small mouth and a large space inside, and it can't be too small. Once tied, place a shoe of flour, cornmeal or dough on a flat sole and slowly place the bottle in the water upright.

Until the bottle is no longer visible on the water, it is okay to wait. After three to five minutes, the bottle is ready to be lifted!

At this time, the gluttonous fish will be bottled and pulled up along with the water. You can catch two or three fish at a time, and if there are more fish, basically every time you lift the bottle, there will be fish in it. In fact, this kind of fishing method is the same as the principle of normal fishing in our usual time.

It's just that we use a hook to fish, and this method uses a bottle. Fish can't run away from hooks or bottles. (The space in the bottle is too small for the fish to turn around!)

After a while, I caught a fish in a storage box, which shows that this fishing method is still very efficient. However, the fish caught are basically this kind of fish, I don't know if any anglers know this kind of fish? It seems that this fishing method is more suitable for catching this kind of fish, and I don't know if it can be used to catch other fish.

If you have the opportunity, you can try this fishing method, it seems to be more fun, we anglers are more like to try new things!

This article was originally written by Sihai Fishing, thank you for sharing your fishing experience, and welcome more fishing friends to share their fishing experience in private messages. This article**material** is shared with fishing friends, please contact to delete the infringement!

5255 Reading.

Single apartment Must-see tips for everyday life**.

50 ** Single apartment Must-see tips for daily life.

3** 24704 people have read.

Design case renderings.

Mineral water bottles are designated as floating nests.

Ten types of homemade improvised fish traps.

Top 10 recommended fishing rods to buy.

Mineral water bottle fishing white stripe artifact.

Top 10 automatic fishing artifacts.

10-12 m rod recommended.