It s been twenty days since Ye Plug Orange Monroe, report the results, do you know?

The survival rate of orange Monroe leaf cuttings is very low, and the main reason is that because of its compact leaves, it is easy to hurt the growth point when recording leaves.

The reason why the survival rate of orange Monroe leaf cuttings is low is mainly because its leaf layer is compact, and it is easy to hurt the growth point when picking the leaves.

Orange Monroe is fleshy, and the leaves are well planted in March. Succulent leaf cuttings are best in spring and autumn, and if the temperature can be kept at about 15-20, leaf cuttings at this time will grow and take root faster.

In fact, it can be carried out in cool weather in summer, but the emergence rate is relatively low. Thick, plump leaves should be used for leaf cuttings, and shriveled leaves will grow poorly. Wait patiently after the leaf cutting, and do not turn the leaf at will.

Orange Monroe Succulent Farming Method.

Temperature and light.

Orange Monroe prefers a sunny, cool, dry growing environment and is drought tolerant and not cold-tolerant. It has the habit of growing in cold season and dormant in high temperature in summer. In summer, when the high temperature reaches about 35 degrees, it is necessary to properly shade and ventilate.

In other seasons, full sunshine is permitted. In winter, when the temperature is lower than about 5 degrees, it should be placed indoors in a sunny place for maintenance.

Moisture management. The watering of Orange Monroe can be carried out according to the principle of "do not dry and do not water, water thoroughly". In summer, a small amount of water can be sprayed on the soil surface every week to prevent root death. And Orange Monroe try not to get caught in the rain, once it is exposed to the sun after the rain, the chance of hanging is particularly large.

But if you accidentally get caught in the rain, you must dry the water in time, and then spray carbendazim for prevention.

Mode of reproduction. Orange Monroe is not easy to grow in groups, so it can be propagated by leaf cuttings. It should be noted that the leaves should not be watered immediately after the leaf cuttings and direct light should be seen. Put it in a well-ventilated environment, wait until the seedlings are large, and then gradually restore the light and watering.

At the same time, leaf cuttings should pay attention to the selection of soil with good air permeability, such as the increase in the proportion of peat soil.

1 leaf cuttings orange monroe germinated but not rooted, need to pay attention to follow-up treatment.

2 Leaf cuttings need to grow in a moist environment, so they need to be watered promptly.

However, too much water can cause the root to rot, so you need to control the amount and frequency of watering.

In addition, the light of leaf cuttings is also very important, and it is necessary to ensure that the light is sufficient but not strong, so it is recommended to place them in semi-shade.

3 If the leaf cuttings have sprouts but have not taken root, try adding some soil around the buds to help the plant grow roots.

You can also try to use plant growth aids such as rooting powder to improve the success rate of hair roots.

To sum up, it is necessary to pay attention to watering and control the amount and frequency of watering during the infiltration chain, ensure that the light is sufficient but not strong, you can try to add soil around the buds, and you can also use auxiliary tools such as rooting powder.

Hello. Leaf cuttings orange Monroe germination does not sprout roots, you can bucket stove to remove the root core draft to let it sprout from the new, if the root system is too long, it will consume a lot of water, and the mother leaf nutrition is not enough to die.

Orange Monroe seedlings do not have long leaves.

The leaves of orange Monroe seedlings are round and flat, not long, and they are only long when they grow up.

Cultivation methods. There is a very critical condition for the state of orange Monroe, that is, to look at its genes, there may be meat friends who think that the genes of Orange Monroe are not important, but I have raised a lot of orange Monroe trees in the spring, and I feel that the genes are really too important, and at the same time, several orange Monroe trees are kept in one environment, often only one. Two trees can appear orange in the spring, and I personally think that this is its genetic problem.

Orange Monroe likes light, and under 6-8 hours of direct light, Orange Monroe is more likely to show color. But only sufficient light is not enough, Orange Monroe likes a slightly lower temperature to a certain extent, the general temperature difference is about 10 degrees, the high temperature does not exceed 25 degrees, and the low temperature is lower than 15 degrees and higher than 5 degrees, which is easier to make Orange Monroe state.

If the light, temperature, temperature difference, genes these conditions are reached, orange Monroe still can't raise the state, then you have to find the reason from the soil, orange Monroe needs some minerals to promote coloring, meat friends to orange Monroe soil, you can only put succulent nutrient soil or peat soil and perlite in the roots, all other places use particles, the particles are best with Maifan stone, volcanic rock, red jade soil.

Volcanic rocks have a certain effect on promoting the color of Orange Monroe, if there are not so many kinds of particles, the effect of using pure maifan stone particles, plus peat soil and perlite around the roots is also good, and it is best to put a little rice husk charcoal on the roots.

Orange Monroe's leaves are indeed long, you can see the <> just by looking at **

It is a succulent plant of the Sedum family with leaves of a certain thickness.

Orange Monroe can be planted in the spring, the temperature at this time is relatively stable, and it is easier to survive, and it can germinate after a month of maintenance after the leaf cutting. If you want to germinate quickly, you should treat its leaves before cutting, let the leaves dry for two days, and then cut the leaves so that the germination speed is faster.

How long does it take for orange Monroe leaf cuttings to germinate.

Orange Monroe can be planted in the spring, the temperature at this time is relatively stable, and it is easier to survive, and it can germinate after a month of maintenance after the leaf cutting.

If you want to germinate quickly, you should treat its leaves before cutting, first dry its leaves for two days, and then cut the leaves so that the germination speed is faster.

Maintenance of orange monroe leaf cuttings after germination.

1. Orange Monroe can add some scattered light appropriately after the leaf cuttings sprout, but the silver stove should be increased little by little, and it cannot be directly exposed to direct light.

2. After the orange Monroe leaves are inserted and germinated, you need to water it when you need to sharpen it, but pay attention to the amount of watering, and do not let the appearance of stagnant water in the soil.

Orange Monroe leaf insert precautions.

When cutting the leaves of Orange Monroe, it should be moved to a place with a good ventilation environment, so as to ensure that it can breathe fresh air, thereby promoting the germination of Orange Monroe leaves, and you can also give it some small amount of water, which is also conducive to promoting its germination.