What are the new uses for beverage bottles? A new way to use beverage bottles

Plastic bottles. Skillfully make a "flower pot".

Xiaomei likes to plant flowers and plants at home, sometimes if the flower pot is not enough, you can use a large plastic bottle instead, first make a hole in the hook on the plastic bottle, and then fix it on the wall, and then make a few small drainage holes on each plastic bottle.

Egg yolk separator.

Take a clean plastic bottle and squeeze the plastic bottle while aiming the mouth of the bottle at the egg yolk to perfectly separate the egg yolk from the egg white!

Food seals.

Can't finish your food? Do not worry!

Cut 3 cm below the mouth of the plastic bottle, pass the bag that needs to be sealed through the cut bottle mouth, remember to pull the buckle completely out of the bottle mouth, and finally tighten the cap!

Wash the dish towel at home.

Drink bottles. Cut a knife at the upper 2 5 and lower 2 5 places, and then buckle the mouth of the beverage bottle upside down at the lower 2 5 places, it forms an open small can, which can be used to put dish towels, and the residual water flows down the mouth of the beverage bottle to the bottom to keep it dry, which is very hygienic.

Store your toothbrush. There are also small bottle caps, stick them to the wall of the bathroom, you can hang the toothbrush, you have to control the distance between the bottle caps, otherwise the toothbrush will fall in the middle!

The new use of beverage bottles can be used to make flower pots, various crafts, and filtration.

Plastic bag storage. There are mountains of plastic bags at home, and a plastic bottle can be perfectly stored!Toothbrush barrel.

Cut the plastic bottle of the toothbrush barrel like this, and the toothbrush barrel getsThe small shovel to be used in turning the soil, the shopping mall, sells more than 20, I have a heart, do it myself...The material is:

Yogurt bottles. At this point, you need to use a marker pen to trace along the outline shown in the picture. Then use ...

There are the following:Preparation materials: plastic Huaibian Xun bottle, self-spraying paint, knife, hemp rope, iron wire.

1. First of all, prepare a plastic bottle and a bottle of self-spraying paint, as shown in the picture below.

2. Use a knife to cut the plastic bottle into the above shapes, as shown in the figure below.

3. The lead is then sprayed with self-spraying paint, as shown in the figure below.

4. Use iron wire to make a hole in the opening surface of the bottle cap, as shown in the figure below.

5. Thread the hemp rope into it, as shown in the figure below.

6. The cap is on the plastic bottle, as shown in the figure below.

7. Finally, put in the flowers and plants that need to be planted, as shown in the figure below.

The new uses of beverage bottles are as follows:Preparation materials: plastic bottles, self-spraying paint, knives, hemp rope, wire guessing.

1. First of all, prepare a plastic bottle and a bottle of self-spraying paint, as shown in the picture below.

2. Use a knife to cut the Chongshi plastic bottle into the above shapes, as shown in the figure below.

3. Then spray the color with self-spraying paint, as shown in the figure below.

4. Use iron wire to make a hole in the top of the bottle cap, as shown in the figure below.

5. Thread the hemp rope into it, as shown in the figure below.

6. The cap is on the plastic bottle, as shown in the figure below.

7. Finally, put in the flowers and plants that need to be planted, as shown in the figure below.

Summary. If the cable is not long enough when charging, or the socket is too high, cut the plastic bottle and make a charging phone holder.

Cut off the top half of the plastic bottle and seal the bag with the cap.

Wear a string on the bottom half of the bucket to make a beautiful bucket that is perfect for children's toys.

Cut out the bottom half of the two plastic bottles and combine them with the cardboard tube in the middle of the toilet paper to make a mobile phone holder.

It's a good idea to cut the plastic bottle from the middle and put the top half upside down into the bottom half to put the dishwashing sponge.

What is the purpose of a beverage bottle.

Hello, I have received your question, I am sorting out the answer, it takes time to type, please wait a while, I will reply to you immediately

If the cable is not long enough for charging, or the socket is too high, cut the plastic bottle and make a charging phone holder potato oak. Cut off the top half of the plastic bottle and seal the bag with the cap. Wear a rope under the bucket to make a beautiful bucket, which is the most suitable for children's toys.

Cut out the bottom half of the two plastic bottles and combine them with the cardboard tube in the middle of the toilet paper to make a mobile phone holder. Cut the plastic bottle from the middle of the bottle and put the top half into the bottom half to put the dishwashing sponge.

Can be used as a mosquito trap. The specific method is as follows, first prepare the materials: drink bottle, ordinary pen or marker, utility knife, ruler, 1 4 cups of brown sugar, 1 3 cups of hot water, 1 gram of yeast, measuring Sanhui cup, adhesive tape.

1. Use a ruler to measure the place 10 cm below the cap of the beverage bottle, and then make a mark with a pen.

2. Draw a circle on the bottle along the mark.

2. Use a utility knife to cut the bottle in half along the circle of the sheep.

3. Put the brown sugar into the beverage bottle, pour in an appropriate amount of hot water, dissolve the brown sugar, and then let it cool for later use.

4. After the brown sugar water cools, add 1 gram of yeast. No need to stir after addition. Yeast reacts with sugar to produce carbon dioxide, which attracts mosquitoes.

5. Turn the top half of the bottle into the core and hold it in your hand. With the cap facing down, hold the top half with one hand and the bottom half of the bottle with the other.

6. Put the top half of the bottle upside down into the bottom half. Gently press the top part down until the two edges of the cut overlap. Make sure the neck of the bottle is above the solution in the bottle.

7. Fix the edge of the bottle with tape. Make sure the upper and lower parts fit well together.

8. Done. <>

The main raw material for making beverage bottles is polypropylene plastic, which is non-toxic and harmless, and has no adverse effects on the human body when used to hold soda and cola-type beverages.

However, since plastic bottles still contain a small amount of ethylene monomer, if fat-soluble organic matter such as wine and vinegar are stored for a long time, chemical reactions will occur.

Long-term consumption of food contaminated with ethylene can cause dizziness, headache, nausea, loss of appetite, memory loss, etc., and in severe cases, it may also lead to anemia.

In addition, when wine and vinegar are used in beverage bottles, the bottles will be aged by oxygen and ultraviolet rays, releasing more ethylene monomer, which will deteriorate and change the taste of wine and vinegar stored in the bottle for a long time.

It can be made into a plastic vase.

Tools Raw materials.

Plastic bottles, scissors.

1. Prepare a 1500ml beverage bottle and scissors.

2. Cut the plastic bottle from the upper part of the bottle.

3. Cut it in half.

4. Cut vertically, cut into thin strips of equal width, and stop when you cut to the position of the pattern.

5. Cut the bottle into thin strips of equal width all over the week.

6. When starting to weave flowers, press down the thin strips and buckle the bottle body downwards to cut out the ears.

7. After pressing, it will no longer be retracted.

8. Take Article 4 as a group, and refer to Article 1 with reference to **Reference**.

9. Article 2 is the same.

10. The same method is compiled in turn.

11. The same way is the way to wrap up.

12. Success!

13. Insert flowers to see the effect!

1.It can be sold as scrap;

2.If you have the ability to cut it into handicrafts;

3.weaving toys or patterns from multiple bottles;

4.In case of emergency, it can be cut into a funnel to divert liquid;

5.When you go out, you can use it to fill water as your own drinking water;

6.Pen; 7.make flower pots;

If you have flowers at home, you can make a watering can for a drink bottle, the method is: find a thin wire and heat it on the gas stove, and pierce a small hole in the cap of the drink bottle, the hole should be dense and small. Fill the drink bottle with water and close the cap on the finished bottle, do not overfill it.

By hand-pressing the bottle, you can use the bottle as a watering can.

All kinds of art decorations, pen holders, small flower pots, etc.

And the most useful thing is to make a waterbed, and hundreds of them are glued together, and they are filled with water, and it's very cool to lie on in the summer.

It's just that the sound is noisy when you turn over.

Poke the lid into a few small holes and you can water.

Cut the bottle open, you can grow a small bonsai or make a pen holder.

Don't throw away the finished drink bottle, it is useful to cut it twice with scissors.

The amount of waste drink bottles can be used to make clothes.