I got a large area of 502 glue on my hands, how to wash it off, and some of the skin has fallen off.

Updated on vogue 2024-07-13
10 answers
  1. Anonymous users2024-02-12

    You can rinse it with cooler water, and you will see that 502 will fall off more easily than before, and we don't have a day when we don't touch 502, and we deal with it like that when we touch our hands.

  2. Anonymous users2024-02-11

    When it's dry, soak it in water and buckle it with your fingernails.

  3. Anonymous users2024-02-10

    The safest way is to go to the doctor and the hospital!

  4. Anonymous users2024-02-09

    How to remove 502 glue on your hands?

  5. Anonymous users2024-02-08

    I've touched a small area on my hands! After a long time, it will fall! If you have a large area, you should go to the hospital.

  6. Anonymous users2024-02-07

    502 glue.

    When you get it on your hands, the glue will slowly fall off, but the time will be very long between the holes, and you can use wind oil essence.

    You can quickly remove the glue from your hands in the following ways:

    4. Next, apply the wind oil essence to the 502 glue on your hand, and the wind oil hand stove essence can dissolve the glue, as shown in the figure below.

    5. Finally, the 502 glue on the hand is cleared.

  7. Anonymous users2024-02-06

    The removal method of 502 glue sticking to the hand is as follows:

    1. Wind oil essence method. Drop some wind oil essence on the sticky finger, wait for absorption, and gently rub the finger until it is open after 10 seconds.

    2. White vinegar method. Prepare a bowl, pour some white vinegar into the bowl, put the sticky fingers into the white vinegar and soak them, and then gently rub the fingers until they are rubbed open.

    3. Soap method. Prepare a bowl of hot water and a piece of soap, use scissors to cut some soap into the hot water, stir the soap until it melts, put the sticky fingers into the soapy water to soak, and gently rub the fingers until they are rubbed apart after 1 minute.

    4. Clear water method. If the adhesion time is short or the area is small, you can try rinsing with clean water or soaking it in warm water to soften the glue and remove it more easily.

    5. Dissolution method. In general, 502 glue is soluble in organic solvents. Therefore, nail polish remover, alcohol and other substances can also be used to remove glue.

  8. Anonymous users2024-02-05

    After soaking in soap + hot water, pick it off again!

  9. Anonymous users2024-02-04

    502 is an organic solvent, you just need to use an organic solvent to dissolve it in it, commonly used in life are alcohol, gasoline, and oil, in addition to going to the cosmetics store to buy a bottle of nail polish remover can also get unexpected results, you can try it! Apply hand cream to your hands, then rub and wash your hands.

  10. Anonymous users2024-02-03

    When 502 is stained on your hands, you should first wash it briefly in the sticky place, and then apply the wind oil essence to the glue, and in about three minutes, the phenols and esters in it will react with the molecules in the glue to dissolve, and then wash it with warm water to easily remove. In addition, the glue can also be removed with toilet water, because it contains alcohol, which is an organic solvent that can dissolve and volatilize the glue. In addition, if there is nail polish remover at home, it can be directly applied to the stained glue, and it can be removed by wiping it with a cotton swab after a few minutes.

Related questions
9 answers2024-07-13

When we find that the glue is sticky, we should rinse it as soon as possible, or we can use warm water to soften the glue, which is easier to remove. >>>More

7 answers2024-07-13

Method 1: This method must grasp the timing, that is, it must be used when the glue is not completely dry to be effective. When the glue is just dripping on your hands, quickly put your hands in cold water and soak for a few minutes, at which point you can see that the glue has become a solid, and then buckle the glue off your hands. >>>More

26 answers2024-07-13

502 is a kind of industrial strong glue for pasting items, which adheres quickly, so sticking to the hand is also a troublesome problem. So what to do if the 502 sticks to your hand? Let's find out. >>>More

7 answers2024-07-13

You can use a mop and dip it in the glass water used for the car, and you can easily wipe the glass clean!

5 answers2024-07-13

There's no way, it's all about getting a 502, or go and change the shell.