I want to go back to the countryside to repair the earthen house, what is the most appropriate desig

If you want to go back to the countryside to repair the earthen house, the wall thickness of the rural earthen house is generally designed to be 24 cm.

If it is in the north, then the house needs to consider its thermal insulation function. If the exterior wall is too thin, then the insulation measures must be done well. Otherwise, the indoor temperature will be very low and the heating effect will be poor.

Therefore, the exterior walls of houses in the north are thicker than those in the south, which is a regional difference, which is also a major reason for the climate. The reason for the cracking of the cement plastering layer is that the ratio of cement and yellow sand is wrong when the wall is plastered, which in turn causes the cracking of the cement mortar plastering layer, which in turn leads to the cracking of the latex paint. The first thing to do is to remove the putty layer.

After the cement plastering layer sees cracks, it should be directly pasted with carbon fiber anti-crack cloth.

Latex paint cracks are mainly manifested in the cracks in the paint film of the wall, which are relatively simple to deal with. The treatment method is to sand off the cracks with fine sandpaper and then repaint the latex paint. If the temperature changes unevenly, it will cause cracks in the wall due to uneven shrinkage, and cracks will occur when the thermal expansion and cold contraction of reinforced concrete and brick walls are not at the same time.

The living conditions of rural residents are getting better and better, and many families have plans to build new houses. Decades of old houses can no longer meet the needs of modern life, and rural villas have comprehensively improved the quality of housing. In the practice of building houses in rural areas, brick-concrete structures are widely used.

Small and medium-sized homesteads, with good geological conditions, will choose a brick-concrete structure if they only build two or three floors. When building a house in rural areas, many people will ignore the insulation of the house and only use electrical equipment to ensure the heating in the later stage, which not only increases the cost of the house, but also wastes resources.

The cast-in-place structure formwork support must be removed after the cast-in-place reinforced concrete reaches a certain strength, and the cantilever structure can generally be dismantled after the cast-in-place reinforced concrete reaches 100%. If dismantled before the curing time is reached, the cantilever structure can easily crack over time if the concrete structure is not strong. The above is the answer to the question of how much is the most suitable wall thickness for rural earthen houses if you want to go back to the countryside to repair the earthen house.

The thickness of 40 cm is about the same, and it should be determined according to the specific use, and in general, the thickness of the wall of the earthen house should be thicker.

40 cm is more appropriate. If you go beyond this range or don't read it, it's likely that you'll have a quality problem.

The walls of the house are generally about 30 cm thick. Otherwise, it can't be supported.

I now live in an earthen wall house, half a meter thick, high meters, north and south called rice into the body, 3 meters between the mouth, earth wall to build a house to support beams, how to support beams, no pouring surface, ceiling.

You can build a shed, and the advantage of an earthen wall is that it is warm in winter and cool in summer, as long as you are willing to provide your reference options. Is it necessary to build yards and earthen houses at both ends? The plan for building an earthen house should be considered in advance according to your ideas, and it is better to have drawings or renderings on the chosen land, and now there are such conditions.

<> then dig the foundation groove, the foundation groove must be dug to the end, the width of the foundation groove should be determined according to the geological conditions of the land, if it is originally a mountain, the geological conditions are relatively hard, there is no need to dig too wide, meters to 2 meters wide, if the geological conditions are not very hard, to dig wider to dig deeper, after the foundation groove is dug well, it is necessary to use stones to lay the foundation, building a house and building is a truth, the foundation must be firm, to rely on. This is a prerequisite to prevent and avoid the soil from sinking after the house is built!

The height of the foundation should be determined according to the general environmental and geological conditions of the earthen house. If it is a damp place, the foundation can be built higher so that the house does not get wet. Those bricks were thick and big.

The bricks of the old house are fifty or sixty years old, but they are not waterproof, so they can live up to 20 years. It was demolished a few years ago, leaving a corner room, and my dad managed to clean it up. This year another pig has been added.

To be honest, the quality of the mud bricks is really good, the waterproofness is good, it is normal to repair it often and support it for hundreds of years.

Do a detailed interpretation of the problem, I hope it will help you, if you still have any questions, you can leave me a message in the comment area, you can comment with me more, if there is something wrong,..You can also interact with me more, if you like the author, you can also follow me, your like is the biggest help to me, thank you.

Generally speaking, the wall thickness of the rural earthen house should be two meters, so that it is relatively stable, and there is no need to be afraid of heavy rain.

It is generally best to design the wall thickness of 5 cm for rural mud houses, because it can bear a particularly high pressure and is not easy to break.

The thickness of the earthen wall should generally reach at least about 40 cm, so as to have the effect of warmth and insulation.

The thickness of the earthen wall should reach at least about centimeters, so as to achieve the result of thermal insulation.

The wall thickness of self-built houses in rural areas is 24 cm in the south and 25-30 cm in the north.

The difference in the thickness of the walls of a self-built house:

1. In the south, two thicknesses are generally used. If it is a brick-concrete structure house, then the thickness of the exterior wall will generally be made to 24 cm, and if it is a frame structure house, then the thickness of the exterior wall only needs to be made 20 cm.

2. In the north, the outer wall of a house made of masonry will be 37 cm or 49 cm thick, and the thickness of the outer wall of a frame structure house will generally be 25 cm or 30 cm.

3. If the exterior wall is too thin, then the insulation measures must be done, otherwise the indoor temperature will be very low, and the heating effect will be relatively poor. Therefore, the outer walls of the houses in the north will be a little thicker than the houses in the south, which is a regional difference, and this collapse is also caused by the climate.

Precautions for the construction of rural self-built houses:

1. Thermal insulation:

In rural construction, many people will ignore the insulation and other aspects of the house, and only use electrical equipment to ensure heating during the post-auction period, which not only increases the cost of housing but also causes a waste of resources.

2. Template: cast-in-place structure formwork support must be dismantled when the cast-in-place reinforced concrete reaches a certain strength, and the cantilever structure can only be dismantled when the cast-in-place steel bar reaches 100%, and if the maintenance time is not reached, the concrete structure is not firm, and the cantilever structure will be easy to crack after a long time.

3. Concrete pouring:

Concrete pouring should be in place, otherwise it will easily cause a series of problems such as concrete vibration leakage and vibration is not compact.

4. Wall building: Before the construction of the wall, the bricks should be watered and moistened a few days in advance, and it is best not to use them in situ, and the situation of dry bricks directly on the wall must be avoided, otherwise it will directly affect the stability of the wall. <>

I want to go back to the countryside to repair the earthen house, how much is the appropriate wall thickness of the earthen house in the countryside? If you want to go back to the countryside to repair earthen houses, to be honest, it is rare to repair earthen houses in the countryside now, and I am afraid that they have become extinct. I used to repair mud houses in the countryside, and now I will tell you about the basic process.

<> in rural areas, the first step is to obtain the land of the house through the villager group and the village committee, and when selecting the site, it is necessary to consider that there is a backer behind it, preferably surrounded by mountains on three sides, and the front of the front should be very open, and you can see far away from it is also a wide field of vision. Then it is necessary to consider whether water, roads, power supply, and supporting facilities and conditions closely related to life are convenient. After obtaining the land, it is necessary to go to the township to which the land belongs to go through the relevant approval procedures for repairing the earthen house.

Once this is done, construction can begin.

Wiring, how many earthen houses need to be repaired? Is it necessary to build yards and earthen houses at both ends? The plan to build an earthen house should be done in advance according to your ideas, and it is best to have drawings or renderings for the plan on the chosen land, and there are such conditions now.

Then dig the foundation groove, the foundation groove must be dug to the end, the width of the foundation groove should be determined according to the geological conditions of the land, if it is originally a mountain, the geological conditions are relatively hard, there is no need to dig too wide, meters to 2 meters wide.

If the geological conditions are not very hard, to dig wider, second, to dig deeper, after the foundation groove is dug, it is necessary to use stones to lay the foundation, building a house and building is a truth, the foundation must be firm, to rely on. This is a prerequisite to prevent and avoid the soil from sinking after the house is built! The height of the foundation should be determined according to the general environmental and geological conditions of the earthen house.

If the weather is wet, the foundation can be built higher so that the house does not get wet.

Do a detailed interpretation of the problem, I hope it will help you, if you have any questions, you can leave me a message in the comment area, you can comment with me more, if there is something wrong, you can also interact with me more, if you like the author, you can also follow me, your like is the biggest help to me, thank you.

I think the general design is only suitable at 1.5 to 2 meters, because this is based on science, and it can also protect our lives, so we must pay attention to this aspect when building a mud house.

The wall thickness in rural areas is generally 24 or 37, because such a wall thickness will make the house stronger, and it can also avoid relatively simple damage to the house, which can make the house stronger.

240cm, such a thickness is very suitable, and it can also ensure the quality of the house and also avoid the collapse of the house.