Why is the network not available after connecting to the wireless router?

This is because wireless routers need to be set up correctly before they can be used.

1.The router is a device that sets up a LAN to achieve network sharing, and the general connection and setting methods are as follows: connect the network cable out of the broadband cat to the WAN port of the router, connect each computer to the LAN port of the router, and the IP address of the computer network card is set to be automatically obtained, enter it in the address bar of the computer browser, and specifically check the network parameters obtained by your computer network card, and log in through the IP address of the gateway) Log in to the router, and the general user name and password are admin, Select the WAN port settings, and set your broadband account and password to the PPPoE mode.

2.If the laptop uses wireless Internet access, the operation is as follows: right-click the online neighbor - properties - right-click the wireless network connection - view the available wireless network, click your wireless network name in the searched wireless network - connection, and enter your wireless network key for verification, after passing the verification, you can connect to the wireless router to surf the Internet normally; If it is a mobile phone wifi, the same as above, it is also a search for wireless signals and enter the wireless network key to connect and you can use it.

Originally, broadband with cats.

The network cable on the cat does not need to be moved.

Directly unplug the cable of the computer port and connect it to the routing WAN port.

Then connect to the computer from the other port of the router.

Connectivity does not require a point broadband connection.

Open your browser directly.

Enter the route settings screen in the address bar.

You can log in to the settings page.

Originally, a broadband connection was required to access the Internet.

Select PPPoE mode during the setting.

Next. Enter the account number and password for broadband.

Next. The SSID was changed to a simple number.

The PSK password is changed to 8 digits.

Next. Reboot.

Remember. Don't click on a broadband connection.

With the arrival of the 5G era, we must adapt to new opportunities and challenges, face new things, and make new changes.

Reset your router! Give the computer behind each router a fixed IP, in addition, the slow Internet speed is directly related to your Internet speed. If you're the ADSL512K type, it's recommended that you don't connect more than one computer to each other!

If the network is not connected, you must first determine whether there is a problem with the broadband, and this problem can only be repaired.

If the network is normal, it is possible that your routing is not set up correctly or that there is a problem with your routing.

Check the settings of the router, in this case, there is usually a problem with the DHCP or broadband account settings, you can re-set it step by step according to the tutorial, or you don't want to find customer service, or it may be a problem on their end.

The network is unreachable, cause 1: The line connection is incorrect.

Home Network Environment Cabling]:

1. There is a cat (modem): cat (modem) - router WAN port; The LAN port of the router --- a computer.

2. No modem: network cable --- router WAN port; The LAN port of the router --- a computer.

Reason 2: Router dialing is not set up.

Computer enters the router]:

1. The computer IP and DNS settings are automatically obtained.

2. Open the browser, enter the general router address in the address bar is this or check the login information on the back of the router) Enter the route - enter the user name and password, (the default is generally admin).

Set Router Dialing]:

1. In the [Setup Wizard], select [PPPoe Dialing] (some are ADSL Dialing), enter the Internet user name and password according to the prompts, and save.

2. In [Network Parameters] --WAN Settings], select [Normal Mode], and select [PPPoe Dialing] in the three options of [Connection]. The next step is to select [Auto Connect], Save, and Exit.