Can t get internet on your wireless router? Why can t wireless routers access the Internet

Quite simply, because the router is also a Layer 3 device of the OSI, the IP address you receive is managed by the wireless router rather than the route in the background of the organization that can provide you with Internet access, so you cannot access the Internet. Therefore, the simple point is to turn off the DHCP function of the wireless router, and connect the LAN interface of the wireless router to the incoming wire. This is actually downgrading a wireless router to a wireless switch, but as long as it can be used.

First of all, from the perspective of the Internet interface provided by your company, you need to figure out whether it is the Internet service provided to you by the company's routing or the switch, which is very important. If it is provided from the route, you don't need to connect the WAN port of the business pilot, and directly connect to 123....Port, if it is provided by the switch, then you need to set up your business pilot.

Your company is not bound to the MAC address, if it is, then you need to bind the MAC address of your machine to your route, if not, you can set the dynamic address in the route.

You only need to connect any LAN port of the router to the Internet interface, and it is best to add a password to the wireless router to prevent the speed from being affected by the network.

The router is connected to the switch and the router is used as a switch, and the incoming line should not be connected to the WAN port.

The specific settings are hehe, please master.

You don't have to set up dialing, the wireless router also needs to dial up, in order to connect to his device to go online, there is a place for settings, you look for the username and password of your access method,

When you buy a router, you should ask how to set it up!

There's an installation wizard inside, and you can follow step by step.

At the same time, you need to put all the password accounts into the route, that is, add them.

Routing is generally not bad, but there are exceptions. There is still functional damage.

If you are sure that debugging is fine. Maybe the wireless function is broken.

7660 Gigabit Edition.

Mercury D268g

What brand and model of router, if it is an old router, you can replace one while 618.

If the wiring is normal, then it may be that the wireless module is broken.

Maybe there is a problem with the quality itself.

It's very simple, you don't need to dial after using a route, and your approach is obviously to dial after using a route.

1. You plug the line connected by the cat into the route, and then first connect a line to the route and the netbook, and go into the routing setting interface, which is generally used to enter.

2. Then set the network connection mode PPPOE in the WAN, and you replied that the factory settings should be the default dynamic IP. After selecting PPPoE, the password input box will appear below, fill in the password you used to dial.

3. Set up a wireless signal connection in WLAN, generally select WPA2 as the encryption method, and set a wireless Internet password to prevent people from rubbing the network.

4. Save, exit, confirm that the Internet has been connected normally in the case of network cable connection, no need to dial up.

5. Unplug the network cable and connect the wireless signal with a wireless network card.

If you don't understand, you can hi me, we can discuss it.