What is the formula for A2 reversing warehousing skills?

The left light of the tie-up gear flashes, step on the clutch and release the handbrake, and slowly lift the clutch to start slowly.

Optimistic about the right line to adjust the body, the left mirror vertical seam along the right line. The front horizontal line is stopped shoulder-to-shoulder, and the reverse gear clutch is loosened. The left mirror covers the corner of the horizontal line, and it is good to kill the direction to the right.

Look at the left mirror and other library lines, the angle of 30 times a circle, wait until the car is parallel to the line, two full circles in the positive direction, the left mirror covers the front corner of the library, step on the clutch and brake. Hang up the first gear to go out of the warehouse, the front of the car touches the left foot. The front cover line car is parked, and the direction does not move and the car is reversed.

Look at the right mirror and other library lines, and the angle is 30 times. Wait until the car is parallel to the line, return to the positive direction for two full turns, cover the front corner of the garage with the left mirror, and step on the clutch and brake. Hang up the first gear to go out of the warehouse, the front of the car to touch the right foot.

Inverted inventory. It's not difficult to get out of the warehouse, the left light flashes on the strap mount, and the clutch lets go of the handbrake.

Slow lift, clutch slow start.

Optimistic about the right line to adjust the body, the left mirror vertical seam along the right line.

The front horizontal line is stopped shoulder-to-shoulder, and the reverse gear clutch is loosened.

The left mirror covers the corner of the horizontal line, and it is good to kill the direction to the right.

Look at the left mirror and other library lines, the angle of 30 times a circle, wait until the car is parallel to the line, back to the positive direction of two circles, the left mirror covers the front corner of the library, step on the clutch and brake.

Hang up the first gear to go out of the warehouse, the front of the car touches the left foot.

The front cover line car is parked, and the direction does not move and the car is reversed.

Look at the right mirror and other library lines, the angle of 30 times a circle, wait until the car is parallel to the line, back to the positive direction of the whole two circles, the left mirror covers the front corner of the library, step on the clutch and brake.

Hang up the first gear to go out of the warehouse, the front of the car to touch the right foot.

The front cover line car is parked, and the ability to correct the body is high.

Through the "two in and two out", the entire reversing and warehousing examination process is completed.

1) Drive in place.

Before the test, drive your vehicle to the starting point of the garage. During this process, attention should be paid to adjusting the position of the vehicle. When you arrive at the starting point, you must stop right, and it is best to be about one meter away from the side line of the garage, as shown in Figure 4-44.

2) One into the garage.

Press the clutch and engage reverse gear. Then gently lift the clutch pedal to the semi-linkage, release the parking brake lever, and start slowly backwards.

Looking back at the right rear triangular window, when the vertical edge of the triangular window is level with the right side of the garage (i.e., the line connecting positions 1 and 4), quickly turn the steering wheel to the right to the limit position, as shown in Figure 4-45.

Observe the exterior mirrors and adjust the distance between the body and the garage sideline. When the left front door handle coincides with the bottom line of the garage (i.e., the line connecting positions 3 and 4), stop the car immediately, as shown in Figure 4-47.

3) One out of the garage.

Trick dialing: In order to save time and reduce mistakes, as long as the car is correct when parking, the position of the steering wheel can be maintained, and there is no need to return to the right.

1. Look at the left rearview mirror when reversing, and when the left rearview mirror blocks the white line, quickly beat the steering wheel to the right;

2. After seeing that the left rearview mirror is parallel to the white line of the storage location, go straight into the warehouse;

3. Stop when the visual position of the front edge line of the storage location is close to the left rearview mirror.

Subject 2: The reversing and warehousing formula is as follows:

There is a principle of reversing into storage, and the body should be straight front and rear. There is a knack for right-hand reverse garage and steering is better than later.

It's too early to see the corner and go back around, and it's difficult for the gods to treat it late. The left and right rear eyes see the bottom of the library, and the bottom of the library on both sides is almost the same.

Return to the right direction as quickly as possible, if the body deviates slightly. The whole vehicle is parked before entering the warehouse, and the left light out of the warehouse is not forgotten.

The direction of the hand is loose for three points, and the distance between the return to the warehouse is half a meter. The left is wide and the right is narrow, and it can be repaired when it is reversed.

The key points of reversing are as follows:

1. The speed must be well controlled, and try to slow down as much as possible.

2. Look at the rearview mirror when reversing, and fill the steering wheel when the lower edge coincides with the reference line.

3. Continue to reverse, in the rearview mirror, the car is 30cm away from the storage position, and the steering wheel is wide back to the banquet.

4. When the rear wheels are in the extension line of the library, the steering wheel is full, and when the body is aligned, both sides are in the frame line, and the steering wheel is back to the center.

In fact, the most important thing in subject 2 is to be familiar with the vehicle as much as possible, and work hard to learn and master the relative position of the car, although we can't predict the position of the car when we practice subject 2, so we need to remember some key points. When slowly reversing into storage, it is recommended to get out of the car to take a look at it when practicing, feel the position seen in the car and the real position of the car, and look at it a few times to feel more, and it is better to say a few more times than to see it a few times, and the coach also teaches like this.

The formula for the reversing and warehousing exam in subject 2 is as follows:There is a principle of reversing into storage, and the body should be straight front and rear.

There is a knack for right-hand reverse garage and steering is better than later.

It's too early to see the corner and go back around, and it's difficult for the gods to treat it late.

The left and right rear eyes see the bottom of the library, and the bottom of the library on both sides is almost the same.

Return to the right direction as quickly as possible, if the body deviates slightly.

The whole vehicle is parked before entering the warehouse, and the left light out of the warehouse is not forgotten.

The direction of the hand is loose for three points, and the distance between the return to the warehouse is half a meter.

The left is wide and the right is narrow, and it can be repaired when it is reversed.

The Subject 2 exam is a little more difficult than other exams, and the grasp of details is more rigorous. For candidates, as long as they grasp the details and adjust their mentality, it is very simple to pass the reversing and warehousing exam.

When adjusting the steering wheel, we should pay attention to the following points, the first point of the swing amplitude must be small, because the garage is very small, and it is easy to press the line when the adjustment amplitude is large. The second point is that the direction of return is predictable, and when you see that the body is about to be aligned, you should hurry back to the direction, and don't wait until it is completely aligned and then return.

Finally, the mentality must be adjusted. In addition to mastering all operations, you must have a good attitude in the face of the exam, be confident, so as to give full play to your true level, if you are too nervous, always not confident enough, it is difficult to complete successfully, the key is to be bold and careful, serious and patient, do not put too much pressure on yourself, and do every operation as well as possible.

The formula for reversing and warehousing in subject 2 is as follows:The principle of reversing and warehousing is remembered, and the seat adjustment is not ignored.

The storage point should be kept in mind, and the body should be straight front and backward.

It is important to control the speed, and it is better to steer sooner rather than later.

Which side is wide to which side, the whole vehicle is parked when it is put into storage.

The left light out of the library can not be forgotten, and you must think diligently after practicing.

Specifically, if the novice student is not proficient in driving, remember the most reliable point. After getting into the car, you need to adjust the seat, and then learn to see the points, play the steering wheel, and adjust the body according to the method of viewing the points taught by the coach.

Precautions. Subject 2 is tested in the examination room, and the speed of the vehicle needs to be controlled by the clutch, so in order to ensure that the test is successfully passed, the speed of the vehicle must be slow. Of course, slow does not mean not moving, nor can there be a halfway stop, the speed of the car is slow, the point can be more accurate, the body is more convenient to adjust, and it is not easy to press the line.

Whether it is reversing into the warehouse or the entire learning process of the driving test, you need to think diligently, and you can't improve the students' operation skills just by practicing without memorizing.

There is a principle of reversing into storage, and the body should be straight front and rear.

There is a knack for right-hand reverse garage and steering is better than later.

It's too early to see the corner and go back around, and it's difficult for the gods to treat it late.

The left and right rear eyes see the bottom of the library, and the bottom of the library on both sides is almost the same.

Return to the right direction as quickly as possible, if the body deviates slightly.

The whole vehicle is parked before entering the warehouse, and the left light out of the warehouse is not forgotten.

The direction of the hand is loose for three points, and the distance between the return to the warehouse is half a meter.

The left is wide and the right is narrow, and it can be repaired when it is reversed.

Subject 2: Reversing and warehousing operation method:

1. Gently lift the clutch to move the car backwards, control the speed, look at the left rearview mirror, and kill the steering wheel right when the right starting point induction line appears in the left rearview mirror.

2. Kill the steering wheel to the right, continue to move back, can not stop in the middle, and observe the right rearview mirror at the same time, until the rightmost line is exposed, keep the distance between the body and the library angle 750px (less than 750px back half a circle steering wheel adjustment, greater than 750px continue to kill the steering wheel on the right, the body is still greater than.

30cm, it may be that the steering wheel is slow when you look at 1 o'clock, and the next time you will advance or speed up the direction). Continue to move back, when the right mirror library edge line is parallel to the body, the steering wheel is straightened, the body is adjusted, and it is reversed into the garage.

3. Look at the left rearview mirror when the warehouse is at the bottom, and when the front edge line of the library is in the left rearview mirror position, stop and complete the relocation.

4. Out of the warehouse, hang a gear forward, when the front head cover of the car just can't see the curb line, the steering wheel left to die, when the body is in time, back to the right direction, the front wheel to do the starting point induction line, stop.