The sofa looks a little old, how should it be renovated?

Remove the outer skin of the old sofa first, and try to remember every link and process when removing it. Because there is a certain difference between modern technology and the technology of the past, there must be a difference in assembly. The more time passes, the bigger the difference.

In short, remember that it doesn't hurt. If you can't remember, take a picture with your phone. In this way, the sofa cover can be customized in the future, which is convenient for communication with the processor.

When the outer cloth is removed, the sponge is exposed. I chose to throw away the original set after the sofa was completely used. Some sizes and shapes are readily available.

When I remove it, I will find that there is felt in the seat in addition to the sponge. So keep this process in mind so that it can be renovated like it is now.

After removing the sponge, all that's left is the frame. Because the old craft has a mortise and tenon structure, white latex is needed at this time, and there is a wooden square. That was a long time ago.

The wooden frame of my sofa is ash, which is hard but brittle. If the self-tapping screws are tightened too tightly, it is easy to crack. Choose a hand drill to open the eyes, with white latex reinforcement, and check the spring and reinforcement at the same time.

Finally, the rust removal lubricant is selected to spray to increase the firmness of the spring structure. When cutting a new sponge, you can sharpen it with a kitchen knife and watermelon knife at home. In the beginning, I opted for a paper cutter.

The cutter body is too small, and the cutting is uneven, which will affect the future effect. Pay attention to the size when cutting, and try to achieve success at the first time. I just cut a sponge because I didn't pay attention to the size, and the corners had to be thin.

The shape of the sponge is the shape after wrapping the cloth later. If you're willing to use leather, you can use the same reason. Because the leather will explode in the future, I choose fabric.

To attach the sponge, use a special sponge glue, which can be purchased at the place where you bought the sponge.

The processing of the picture frame is simple to say, but the most difficult to do, the original paint film has to be scraped off little by little with a scraper. It is more difficult to punch holes directly with sandpaper. Scrape off and then polish with sandpaper, dismantle the mortise and tenon joint, and then reinforce it with white latex.

After treatment, apply the varnish. The first is cleaning, as the old sofa was sprayed with a layer of wax when it left the factory. In addition, the sofa has undergone daily use, leaving behind dirt and oil stains that must be washed once.

Leather cleaners can deeply treat leather, remove residual leather wax and stains, improve the surface condition of the leather, increase the adhesion of the leather post-treatment agent, and better prepare it for finishing and discoloration repair.

When repairing the damage, apply the blade tool evenly to the damaged **, dry it and sand it with a fine sand peel. The leather veneer cream has a strong surface coverage effect, small volume shrinkage, and good polishing performance. Once the coating film is dry, it can be fully combined with the leather.

It can quickly fill the scratches, cracks, cuts, holes and burns on the leather surface, and restore the smooth and smooth surface of the leather surface. Please replace the colored paint after repair. The colors of leather discoloration paint are red, yellow, white, purple, black, and brown.

The gloss is available in high-gloss, medium-gloss, matte, semi-matte, and natural light. It has good coverage, strong adhesion, folding resistance, water resistance, cold resistance, abrasion resistance, excellent smoothness and soft hand feel. The color can be adjusted according to your taste, spray directly on the clean and repaired **, and then let it dry.

If you want to reassure the sofa, you can buy some sofa cover fabrics, you can customize a suitable scale, and then customize a sofa cover, otherwise you can directly rest assured.

If the sofa looks a little old, you can buy a sofa cushion to cushion the sofa so that it looks newer, or you can simply replace it with a sofa.

You can rinse it, so that the outside is cleaner, and naturally it is relatively new, that is, it is relatively good. It looks good and makes people like it.

1. How to renovate an old wooden sofaHow to renovate an old wooden sofa? Before renovating, clean it up first, remove the dirt on the sofa, especially the dust in a few corners, be sure to wipe it clean, and summarize the reasons why the sofa looks old now. Then communicate with your family to find out what kind of wood your sofa belongs to.

If you want to paint, you need to sand it with sandpaper to remove the paint from the surface. In fact, the sofa of this material is relatively easy to renovate, and the finger vertical can be repainted, and if there is some damage to the wooden structure, it needs to be corrected by a carpenter, but the cost is generally lower.

Second, how to renovate the old leather sofaHow to renovate an old leather sofa? If the sofa at home is leather, or the leather is better, the sofa looks old, just because there is more dust on it, or some stains, and it does not need to be renovated. And some of the monks who are really too old or have peeling off the skin due to poor material only need to be re-customized and find a job to re-wrap a layer, but because the entire leather surface needs to be replaced, the cost will be relatively high.

3. How to renovate the old fabric sofaHow to renovate an old fabric sofa? This one is relatively easy to get dirty, and it is easy to get oil stains or something, but it is also relatively easy to replace. Just go to the market and find the corresponding sofa cover for better.

If there is a deformation phenomenon in the sofa such as springs, you can find a master to replace the springs, and you can actually make it by hand, and the cost will be much less.

The sofa at home is easy to become dilapidated after being used for a long time. So how do you renovate an old sofa? PChouse will take you to find out.

1. Cleaning: Because the surface of the old sofa was sprayed with wax when it left the factory, it will inevitably leave dirt and oil stains after being used for a long time, so these must be cleaned once. In particular, leather sofas and leather detergents can remove residual wax and dirt, improve the surface condition of the leather, and prepare it for paint and color change.

2. Repair the injury: use a tool to cut the damaged leather surface, and use fine sand skin to polish and smooth the acorn. Leather patch has a good covering effect and good sanding properties, and can be completely combined with leather after drying.

In particular, it can quickly fill the scars, cracks, holes and other blind burials on the leather surface, restore the smoothness of the leather surface, and use leather paint after repair.

3. Change the color: The common leather paint colors are red, yellow, purple, black, brown, etc. Gloss levels include high-gloss, matte, natural light, etc.

It has strong adhesion, water resistance, cold resistance, wear resistance, soft feel, adjust the color according to your preference, immediately apply it to the repaired leather surface, and can be used when dry.

1. Cleaning: Because the old sofa is sprayed with a layer of wax on the surface when it leaves the factory. In addition, after the sofa has been used for a long time, it is inevitable that some dirt and oil stains will remain, which must be cleaned first.

Especially for leather sofas, leather cleaners remove residual wax and stains, improve the surface condition of the leather and better prepare it for finishes and color changes.

2. Repair the injury: scrape off the damaged leather surface with a tool, and polish it with fine sandskin. Leather patch cream has a good covering effect, as well as good sanding performance, after the coating is dry, it can be completely combined with the leather.

In particular, scratches, cracks and holes on the leather surface can be quickly filled, and the smoothness of the leather surface can be restored, and leather paint can be used only after repair.

3. Color change: Usually, the common leather paint colors are red, yellow, purple, black, brown, etc.; Gloss levels include high-gloss, matte, natural light, etc. It has strong adhesion, water resistance, cold resistance, wear resistance, soft feel, can adjust the color according to your own preferences, and directly apply it to the leather surface of the repaired pants, and can be used after drying.

The sofa at home looks older after a period of time, because there is a lot of dirt on the surface of the sofa after a long time, so it looks old. If you want to renovate, you can wipe it all down with alcohol and it will be clean.

You can go to the market to buy some sofa skin, and then rewrap it to renovate the sofa, and it is more affordable and cost-effective. Can be worth a try.

It can be refurbished by painting, veneering, repairing.

1. Paint renovation: If the surface of the leather sofa is only dirty, decolorized, worn, aging, etc., the sofa needs to be cleaned before painting, if it is damaged, it needs to be repaired, and then use the sofa paint of the same color to be painted in the position that needs to be filled, and wait for the sofa paint to dry out, that is, the forest book can continue to use the sofa.

2. Veneer renovation: If there are holes on the surface of Li Mao, or if the crack is serious, you need to use new leather to patch it, and then brush a layer of paint of the same color as the sofa, or directly re-venerate the whole sofa, so that you can also change the original color of the sofa, and you don't need to remove the original sofa leather surface.

3. Repair and renovation: first clean the sofa, and then use the repair cream to repair the sofa without traces, if there is a damage to the macro, you can use elastic adhesive bonding, use an adjustable spray gun to spray color on the surface of the sofa, and then spray a layer of fixing agent, wait for it to dry and then spray brightener, and finally apply the feel agent.