Which is the exhaust gas failure light in the dashboard of the BAIC Shenbao D50 car

The exhaust gas fault light in the instrument cluster is shown in the red box position in the figure below:

This fault light is called differently on different brands of models, some are called engine fault lights, some are called exhaust system fault lights, but the graphic identification is very unified; This light is on to indicate a malfunction in the engine's exhaust gas monitoring system, commonly known as a three-way catalytic converter.

Poisoning. If the light is on or flashing while driving, slow down immediately and drive to the nearest service station for service.

This fault is mostly due to the quality of domestic oil products in the oxygen sensor in the three-way catalytic system.

Damage or three-way catalytic converter poisoning, although you can drive to the maintenance service station by yourself, but also pay attention to this fault, if the oxygen sensor is damaged, another one can solve the problem, and the cost is not much, but if it is a three-way catalytic converter.

The damage is invalid, it is more troublesome, and it takes thousands of dollars to replace the three yuan.

Hello this is the emission problem of the engine, it is recommended to repair it in time, glad for your problem.

Hello. It's the engine fault light [There is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Hello is the engine fault light, I hope mine is helpful to you, if you still have questions, please continue to ask! I wish you a happy use of the car [If you have a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

The red exclamation mark on the dashboard of the Senova D50 car means that the warning light of the car brake system.

There are many reasons why the warning light of Shenbao D50 brake system is on, such as serious wear of brake pads, forgetting to put the handbrake or brake fluid being too low. If the car's braking system has a warning light, it is likely that the car's handbrake is not lowered. The solution is to drop the handbrake.

If it is not a problem with the handbrake, it may be the reason why the brake pads are too thin, if it is a brake pad with a sensing line, when the bridge limb is worn to the limit position, the sensing line will automatically turn on the circuit and light up the fault light, usually the hissing sound made by two iron plates rubbing against each other, at this time, the driver should know to replace the brake pads.

Summary. All the fault lights on the instrument are flashing, and the engine can not start, this situation is that there is a problem with the engine's control computer, that is, according to the normal, these fault lights will appear a self-test process, after the self-test is completed, these fault lights will be extinguished, if all flashing, it means that the system self-test is not completed, it is the engine control computer that needs to be checked.

Hello, happy to answer your questions.

All the fault lights on the instrument are flashing, and the engine can not start, this situation is that there is a problem with the control computer of the engine, Hu Sun is according to the normal of the friend, these fault lights will appear a self-test process, after the completion of the self-test, these fault lights will be extinguished, if all flashing, it means that the system self-test is not good to do and complete, it is the engine control computer failure that needs to be checked.

After maintenance, how to cancel the dashboard with a wrench.

This maintenance reminder light for this car needs to be eliminated by computer. You can eliminate it with a detection computer.

How can you do it without a computer?

There is no computer, and there is no way to eliminate this by manual operation. This maintenance cycling wrench, Zhaohong, which can be eliminated, has no impact on the normal use of this vehicle.

Hello, I am your exclusive technician, attentive, careful, dedicated to answering your car questions, for you to find the corresponding problem solutions and solutions! Here's how to do it: Check the brake fluid level first!

Open the head cover to see how much brake oil there is in the brake kettle, and the brake fluid is not lower than the lowest line! min is the lowest! The liquid level is checked normally, which happens to check the brake pad!

This side key is from the inside of the caliper gap**! As long as there is a centimeter left in the brake pads, it will be fine! If it is less than 3mm, it will call the police!

The specific situation depends on the reasons for the failure of the brake light: 1. The failure of the braking system, the failure of the brake bulb and the failure of the brake switch are caused by the wear of the slow brake fluid tube, which causes the brake system to be seriously lacking oil; 2. The low oil level in the brake fluid tank causes the float sensor to malfunction, resulting in the brake alarm light not lighting up or lighting up, indicating the failure of the braking system, serious wear of the brake pads, and the failure of the braking system due to the wear of the embedded wire; 3. The failure of the brake alarm system itself, such as short circuit and other simple circuit faults and the steam generated by the brake fluid in the pipeline, causes the brake system to fail. The workaround is:

1. The failure of the brake bulb mainly refers to the fact that the brake bulb has passed its service life, and the current halogen brake bulb has a service life of 1 to 2 years, and the LED lamp can be replaced to solve this kind of problem, and its life span can reach 5 to 10 years, and the power consumption is small, the response speed is fast, the lighting is not delayed, and the environmental protection is pollution-free; 2. The fault of the brake switch mainly refers to the poor contact of the switch behind the brake pedal, and the solution of the brake light not lighting is relatively simple, and the brake switch can be replaced.

Summary. Hello, I am helping you sort out the answer to your question, please wait a while How to eliminate the faulty lamp of Senova D50EPB.

Hello, I'm helping you sort out the answer to your question, please wait a while Hello, the car has a faulty light because there is an early failure in the system. EPB is an electronic parking brake system. There are probably some parts that can cause such problems.

EPB switch, handbrake brake elevator. Have you used a computer to detect the fault code and shouted early?

No. This shows up.

How do you cancel this faulty light?

This faulty lamp can't be eliminated manually. You need to clear the fault code with the help of a decoder.

Can't you cancel it yourself?

Yes, once a malfunction is formed. To become a historical glitch, it must be cleared with a computer. There is no way to cancel manually.

Hello, the key is turned on, just step on the brake a few times.

There may be some carbon build-up in this condition, and it is recommended to check the injector, which may be faulty.

The longer the idle time, the longer the engine reaches normal temperature, and the slower the rate of evaporation of gasoline when it is injected into the back of the valve, which creates carbon deposits. At the same time, if you are driving at idle speed, the air flow into the engine will be small, so the scouring effect on carbon deposits will also be weak, which will promote the deposition of carbon deposits.

The purpose of running more high-speed is to use the scouring effect of the air flow on the intake tract to prevent carbon deposits. In addition, increasing the speed of shifting gears is also similar to running at high speed, turning the original gear shift at 2000 into 2500 conversion, which can not only effectively prevent the generation of carbon deposits, but also improve the dynamics of the car, and also avoid the detonation caused by too low shift speed and protect the engine.

Check whether the lower throttle is dirty, and there is the ignition system, and use the computer to check the specific fault.