What to do if the wall is leaking? How to solve the water leakage in the wall?

This is the responsibility of the property management office, as soon as possible to call them to see, generally do not charge a fee, when processing, to keep up, to see if their procedures are correct, whether there are any corners, usually first find the source of water leakage, knock on the outer wall, repair, repair you check whether it is firm, tell them to lay a layer of water barrier, a few days later do not leak, and then put on cement, painted with wall powder, it is OK, to ensure that nothing goes wrong. Ha ha.

The solution to a wall leak is as follows:

1, paint once or twice with cement slurry mixed with waterproofing agent, and then according to the requirements of different floor surface layer practices, first do base mortar leveling or fine stone concrete leveling, and then do floor finishing;

2. After the board surface is cleaned, first do 1% (2% for the larger area) slope screed screed at the downwater, and after the surface layer is dry and hard, it is laid with 2 3 thick modified asphalt waterproofing membrane, and the screed layer or the surface layer is directly done;

3. Serious cracking is poured with fine stone concrete, with 4 two-way steel mesh sheets, and the surface layer is constructed after the polyurethane waterproof coating layer.

4. Toilet leakage, clean up the base layer and re-do the waterproof layer, you can use one of the three waterproof practices on the board surface (cement mortar mixed with waterproof agent leveling layer, modified asphalt waterproof membrane, polyurethane waterproof coating), and the waterproof layer is completed after the irrigation test is checked to be not leaky, and the construction surface layer.

There are two possibilities, one is that the 2nd floor seeps down, you can find the property to check on the 2nd floor to see if there is any water leakage. There is also the seepage of water on the exterior wall when it rains, which requires you to pay attention to it and compare it before and after the rain. Finding the source of the leak is easy to do.

I wish you a speedy solution.

Wall leakage is very common, what should I do if the wall leaks? Wall leakage is a very common construction problem, there are many reasons for wall leakage, and some people's wall leakage is due to improper use of water at ordinary times. Some people have leaking walls because of burst pipes, while others have leaking walls because of problems with the building itself.

There are many reasons for wall leakage, and different causes can be dealt with differently. Let's share with you the treatment methods and common causes of wall leakage.

1. What are the causes of wall leakage?

1) The masonry mortar of the masonry is not full, the ash joints are hollow, and the capillary channel forms a siphon effect: the material texture of the interior decoration surface is loose, and it is easy to dissipate the moisture in the capillaries; The thickness of the plastering of the exterior wall finish is uneven, resulting in the fast and slow water collection, the plastering is prone to cracks and shelling, and the bottom ash of the lattice strip is not dense and there are sand holes, resulting in water leakage on the wall.

2) The connection between the door and the window and the wall is not tightly sealed, the window roof is not set with olecranon and drip line, and the outdoor window sill board is higher than the indoor table. The outdoor window sill plate is not sloped downstream, resulting in water backflow.

3) There is no serious blockage and embedded sealing paste between the rear plug window frame and the wall, or the window frame protection tape is not torn off, resulting in water leakage.

4) Improper blockage of feet, hands, eyes and other holes.

5) The bathroom can be regarded as the most leaky place, because the bathroom is the place where the most water is used, such as showers, flushing toilets, ......Inevitably, over time, there will be some small cracks, so that the water from the upstairs can easily seep into the roof of the downstairs residence. Water pipe leakage, water pipes hidden in the house, or solar water pipes will inevitably leak over time, resulting in different degrees of dampness on the wall.

2. How to deal with wall leakage:

1) Find the existing leakage points and external wall cracks on the wall, chisel the external wall plastering layer at the interface between masonry and structural beams, the cracked plastering layer of the parapet wall and the large-scale cracking cracks of the external wall along the crack peak, and use a handheld cutting machine to cut the plastering layer before chiseling, so as to prevent the new hollow drum due to vibration when the plastering layer is chiseled.

2) After chiseling off the plastering layer, clean the base layer, and then spread a layer of steel wire mesh between the masonry and the structural beam to prevent the plastering layer from cracking again.

3) Repair the plastering layer, the plastering layer is repaired in two to three times, and a certain amount of micro-expansion agent is mixed into the repair mortar to reduce the interface cracks of the old and new plastering layers.

4) After the plastering layer is dry, then do the exterior wall paint, and finally wait for the wall paint to dry, and then paint one to two layers of waterproof coating film.

Water leakage must first find the source, the source is not repaired, no matter how to repair can not solve the problem, you call the property people to see, they have a house structure diagram, ** there are water pipes are clearer.

You can find a property! Does this mean that there is something wrong with this house in the first place?

It must be seeping down from the 2nd floor, so it is recommended to find a nearby 2nd floor to see if there is a leak.

Steps.

1. Strengthen the water pipe interface in the wall; Steps.

2. Repair the cracks in the water pipes in the wall; Steps.

3. Replace aging and damaged water pipes; Steps.

Fourth, redo the waterproof layer of the wall; Steps.

5. Repair damaged walls.

Steps. First, the cause of wall leakage is actually a variety of situations, need to be checked and dealt with step by step, find that the wall leakage first check the water pipe interface in the wall, to see if there is a loose falling off problem, if it is indeed the interface leakage, generally only need to re-strengthen and apply waterproof materials.

Steps. Second, after checking the interface, to the wall water pipe as a whole to check the leakage point, if the water pipe is cracked and seepage, you can use waterproof materials to repair, after the repair is completed, you need to carry out a water pressure test to make sure that it has been repaired.

Steps. 3. If the damage of the water pipe is more serious, or it has been aged, there is no need to repair it, and it is directly replaced with a new one.

Steps. Fourth, if after inspection, it is found that the cause of water seepage in the wall is not the water pipe, but the waterproof layer, it is more troublesome, and it is necessary to ask the workers to redo the waterproof layer of the wall to solve the problem.

Steps. Fifth, after the water leakage problem is completely solved, it is necessary to make the final repair of the moldy and damp wall, and refill and beautify it with concrete, so as to fully complete the water leakage repair work of the wall.

The solution to a wall leak is as follows:

If there is a problem with the waterproof layer of the wall caused by water seepage, the tile needs to be removed first, the wall needs to be beaten to the waterproof layer, re-brushed the waterproof, and then scrape the putty again after the waterproof layer is dry, and then pave the tiles. If the water leakage problem is caused by the rupture of the hose shirt and socks, the pipe pressure test is required. If the test results are due to broken or aging water pipes, find the leak point immediately and replace the problematic water pipe with a new one.

If the wall leaks due to moisture, it is good to pay more attention to ventilation and cleaning during use. If the wall is due to a crack in the external wall that allows water to soak into the wall through the crack, then it is necessary to notify the property as soon as possible to repair it or take other safe treatment methods.

Precautions for wall decoration

Generally speaking, the wall is the place that occupies the largest indoor space, so in order to ensure the safety of the family, the indoor wall decoration materials must ensure environmental protection. Especially for families with children, safety and environmental protection are the most important, and it depends on whether its environmental protection index meets national regulations, in addition, it is necessary to minimize the repeated superposition of wall materials to prevent the production of more harmful substances.

Wall decoration needs to be slotted to do the embedded work of wires, so the construction process is very important. Because the horizontal throwing has great damage to the wall, it has great damage to the seismic resistance and strength. The wall decoration should also do a good job of inspection, especially to check whether the wall is cracked and uneven.

Hello, I'm glad to answer for you, the following is the answer for your query, 1. Check whether there are cracks in the wall, if there are, you can use cement mortar to repair the cracks; 2. Check whether the wall is leaking, if so, you can use asphalt paint to waterproof the wall; 3. Check whether the wall is leaking, if so, you can use linoleum or other waterproof materials to waterproof the wall; 4. Xiao Mingchun checks whether the wall is damp, if there is, you can use moisture-proof paint to prevent moisture on the wall; 5. Check whether there is water seepage in the wall, and if there is, you can use water seepage protective coating to prevent seepage treatment on the wall. I hope it can help you

The solution to the wall leakage is as follows:

First of all, check the cause of water seepage, which is generally caused by a leaking water pipe. Then use a cutting machine to cut the ash layer of the wall and cut the socks, and chisel off the plastering layer. Clean the base layer of the wall, then lay a steel wire mesh between the structural beams, then repair the plastering layer, wait until it is dry, apply the wall paint, and finally apply the waterproof paint.

Causes of wall leakage:

1. The phenomenon of water seepage on the wall may be due to the fact that the waterproof measures are not done well when building the house, and this problem may occur after living for a long time.

2. It may also be that the water pipe near the wall is leaking, so it will stay along the wall and cause water seepage on the wall.

3. Water seepage on the wall, it may also be because the wall is not treated with a good insulation layer, because the weather changes too much, then the wall will be washed away and the phenomenon of internal heat and external cold, thus forming condensation, and the wall will be relatively wet, but it may improve after the weather is good, but the wall is likely to leave mildew.

4. If it is water seepage on the wall of the bathroom, then it is likely that the embedded water pipe leaks, or there is a problem with the joint of the water envy pipe, then it may also lead to water leakage.

Water leaks in the walls are a common problem, and here are some possible solutions:

Find the source of the water leak. To solve the problem, you first need to find the source of the leaker Sakura. This may require removing some surface decorations, such as wallpaper or paint, to find the cause of the water leak.

Turn off water sources. Once the source of the leak is found, the water source needs to be turned off to stop the leak. This can be done by finding a switch or valve near a water source.

Patch vulnerabilities. Once the source of the leak is found, the hole or crack needs to be repaired. This can be done by using waterproof paint, waterproof tape, or waterproof mortar. Make sure the repair material fits snugly against the wall to minimize the possibility of water leakage.

Cover the leaky area. Before you can patch a vulnerability, you need to cover the leaky area. This can be done by using waterproof carpets, tarps, or waterproof wallpaper. This protects furniture and décor from water leaks.

Apply waterproof glue. Before patching a hole or crack, a waterproof adhesive tip can be used to fill the hole or crack. Waterproofing adhesive can be purchased in many places and can also be purchased online.

Recheck the water resistance. After the repair is completed, the waterproofing performance of the wall needs to be rechecked. Under normal circumstances, waterproofing coatings and tapes should continue to be waterproofing for a certain period of time, but if the wrong material is used or if the application is not done properly, it may need to be re-waterproofed.

Please note that wall leakage is a problem that requires patience and care. If you can't find the source of the leak or can't fix the problem, consider seeking professional help.

If the defect is caused by water seepage on the interior wall caused by the rupture of the exterior wall, the property should be notified immediately for repair, because the exterior wall belongs to the main project construction and needs to be repaired by a professional master to avoid danger. If the water pipe in the wall is damaged and causes water seepage, the specific leakage point should be found at this time, and then the leakage hole should be drilled until the water pipe is exposed, and the water pipe can be replaced. If the paint is not completely dry before proceeding to the next step, the paint surface should be scraped off and repainted.

The method of checking for water leakage in the wall is as follows:1. First of all, we can check the way of water pipe leakage in the wall by pressing the water pipe, connect the hot and cold water pipe of the water pipe and the hose together to form a circle, and then close the water source at home from the valve, leave a nozzle to connect the pressure pump, press the pressure pump to 6 pressures left and right, shake the pressure rod, and stop when the pointer on the pressure gauge points to between.

How to deal with water leakage in interior walls1. After detecting the leakage point of the inner wall through the above methods, it is necessary to make up for the leakage point in time, if the leakage area is not particularly large, you can choose to use waterproof tape for winding, and if the leakage point is a large area of development, you must replace the water pipe in time.

2. Long-term water leakage will not only lose more unnecessary water charges, but also make the wall appear serious signs of anti-moisture, the wall will not only be prone to the problem of the wall falling off after being damp, but also lead to the problem of small insects breeding in the wall, which will also affect our normal living environment.