Car film process? How and what are the steps of car film?

Car wrap tool preparation

Explosion-proof film pasting tools mainly include glass cleaning brushes, wipers, wipers, shaping scrapers, utility knives, watering cans, hot air blowers, etc.

Glass cleaning

Use a special glass cleaner to remove dirt from the glass as well as dust.

Cover

Cover the areas that will get dirty in the film, such as the lead and the door.

Cutting and blanking

First, measure the size of the glass to be filmed, then cut out the basic suitable film, and then stick the cut film on the wet glass, and trim it according to the shape of the glass.

Stereotyping

Because the front and rear window glass (and some side window glasses) have a slight spherical bending, which prevents the film from being flattened on the glass and is prone to wrinkles, the film should be shaped after cutting. The method is to heat the membrane with a hot air blower, and while heating, it is squeezed with a plastic scraper until it fits perfectly with the curved surface of the glass.

Internal cleaning

The adhesive surface of the glass should be further cleaned before pasting, and then the glass should be scraped clean and the frame should be wiped clean with a soft cloth and scrubbing paper.

Spray the installation fluid

After the inner surface of the glass is cleaned, the protective layer of the explosion-proof film is torn off first, and then the installation fluid is sprayed on the film and the inner surface of the glass respectively.

Paving

As the adhesive surface on the membrane temporarily loses its stickiness due to the spraying of the mounting fluid, the membrane glides smoothly on the clean glass inner surface, ensuring that the membrane can be adhered in place.

Squeeze water to dry

When the membrane is stabilized in its final position, the membrane surface should be sprayed again with wine installation fluid to lubricate the surface to be squeezed. A special squeezing tool is then used to remove all "bubbles" and as much mounting fluid as possible. Scrape the film from the center to the edges, from top to bottom and then to the bottom so that excess water drains out of the window frame.

Finally, wipe the edge of the glass with a towel to dry the moisture and mounting fluid.

Car film cleaning inspection

Once installed, scrub the inner and outer surfaces of all window glass to remove streaks and smudges. Finally, the paste quality should be carefully checked. One is to check whether the paste is firm, especially the corners; the second is to check whether there are bubbles; the third is to check whether the membrane is wrinkled; Fourth, check whether there are scratches.

If a problem is found, it should be reworked.

The methods and steps of car film are as follows:

1. Spread the solar film on the front windshield first, then blow it with a hair dryer to deform it, and smooth the solar film by hand while blowing to make it extend, which can fit the curvature of the glass;

2. Use a special tool to scrape the solar film flat, so that the film completely fits the front windshield. Use a knife to cut the film into the desired shape, and then remove the various annual inspection signs pasted on the windshield;

3. Gently take off the film that has been extended and cut the shape, spray the mixture of water and washing spirit on the front windshield, and then wipe all the dirty things on the glass clean, and then spray the mixture of water and washing spirit after wiping it clean;

4. Tear off the adhesive and gently stick the film on the glass stained with water and washing spirit mixture according to the shape cut before. Use a tool to expel all the water and bubbles between the solar film and the glass.

Car Wrap Steps:

1.Spray clean water on the inside of the clean glass and then peel off the protective film of the solar film. Spray water on the glued surface and select the appropriate size of the film, 2

Attach the solar film to the glass rot and then cut it along the edges, 3After pasting, there will be a lot of bubbles on the glass ring, 4Plastic scraper for extrusion, 5

If the car film is baked and shaped, 6Finally, stick the film in the car and do some details, 7Finally, just rinse the body.