How to dispose of the dirty things on the keyboard, please help

Tips for cleaning your keyboard (tips).

Start by using a screwdriver to unscrew the screws on the back of the keyboard. It should be noted here that some keyboards are not opened by unscrewing the screws on the back, and there are two or three screws under the keys on the front of the keyboard, and some of the keys need to be pried off the keyboard to see the rest of the screws.

After removing all the keys on the keyboard, we will find that in fact, the circuit part of the keyboard is still very clean, and there is no need to clean, mainly because the keys and the front panel of the keyboard are dirty, and we only need to clean these two parts. Soak the buttons and front panel in water with detergent for a while, and then gently wash them with a soft cloth or brush, and the dirt that has accumulated for a long time will be easily cleaned.

Finally, let the cleaned keyboard dry for a few hours or use a hair dryer to install the keyboard as it is. It should be reminded that some keys have reeds, and the reeds should be installed when installing, otherwise the keys will be damaged if used for a long time.

Look at your keyboard, it's got a new look!

1. In fact, fingers often only touch the surface of the keyboard, and the surface is also the most likely to get dirty.

Unplug the keyboard, mix a small amount of dish soap with water, and scrub the keyboard with a soft cloth, pay attention to the soft cloth is moist, not dripping, otherwise it will damage the circuit.

If you don't think this is thorough enough, you can spray it with 84 disinfectant, also taking care not to form flowing water droplets.

Also, make it a good habit not to use the computer while eating fruit or melon seeds, which will make it easier to stain the keyboard. How do I clean my keyboard?

1. Open the keyboard.

Use a screwdriver to unscrew the screws on the back of the keyboard, it should be noted here that some keyboards do not open the keyboard by unscrewing the screws on the back of the keyboard, and there are 2 or 3 screws under the keys on the front of the keyboard, and some of the keys need to be pry off the keyboard to see the rest of the screws. Unscrew it and we can open the keyboard.

Second, after the keyboard is disassembled, we will find that in fact, the circuit part of the keyboard is still very clean, and it does not need to be cleaned, mainly because the keys and the front panel of the keyboard are dirty, and we only need to clean these two parts. Place the buttons and front panel in the dishwasher and turn the dishwasher to medium intensity. Of course, we can also use detergent to clean, sometimes the dirt of the keyboard is easy to clean, but sometimes because of the long-term use of the keyboard, the keys are aging and yellow, which may not be easy to clean, you can put the keys in the detergent for a period of time, the effect will be better.

3. After washing, let it dry for a few hours, or use a hair dryer to dry, and install the keyboard as it is. It should be reminded that some large keys have reeds, and you should install the reeds when you install them, otherwise the keys will be damaged if you use them for a long time.

Rub it with an alcohol-based cotton pad.

The first floor is very clear!

When cleaning the keyboard, turn off the computer and remove the power cord and battery (if the computer is a removable battery).

You can use a commercially available keyboard cleaning brush or blow up a balloon to remove dust between the keys.

Hello, before cleaning the keyboard, disconnect the keyboard from the main unit, reverse the keyboard with the bevel of the keyboard facing down, and slap the back of the keyboard with skillful force to clean out the dust and debris in the gaps of the keyboard until the dust and debris of the keyboard come out.

Prepare a tool that can blow the air on the side of the keyboard, blow the dust off the surface of the keyboard, wipe the surface of the keyboard with a soft cloth and detergent, and then wipe it with a clean cloth.

If the keyboard is not suitable for the environment, the stains on the keyboard stick to the keyboard, and the stains under the keyboard cap are also stuck together and difficult to clean, then there is no trick to solve it, you can only clean it patiently.

First, disconnect the keyboard from the main unit, then hold the two opposite corners of the keyboard cap, buckle the keyboard cap hard, and then put it in water to soak it for later use. Prepare a brush to brush the entire dirty part of the keyboard vigorously, and after brushing off the dirt that sticks to the keyboard, the keyboard is in turn afraid of dust, so that the dust does not become more difficult to clean when exposed to water. Wipe the keyboard with a damp towel dipped in water-diluted dish soap, wipe it clean, wipe it again with a dry towel, and wait for it to dry.

After soaking the keyboard cap in water, brush the sludge on the surface with a soft brush, brush it clean, dry it with a towel, and press it back in the original order.

The cleaning mud of the keyboard can indeed clean a small amount of dust on the keyboard, but it is difficult to clean up the stains that have been air-dried on the keyboard, especially when cleaning the keys underground, it is easy to stick, it will be very troublesome, and the effect is not good. Therefore, if you want to clean up the keyboard, you still have to clean it carefully according to the steps.

Now there has been a special brush for computer keyboards on the market, the bristles are fluffy and long, the soft and hard are moderate, the shape is chic, the brush head can go deep into the crack of the keyboard, the surface and the inside are swept at the same time, ** according to the different quality, generally between a few yuan and more than ten yuan, some computer stores will also give random gifts, and the daily cleaning keyboard is very easy to use. There is also a special transparent keyboard dust cover, which is both beautiful and dustproof when covered on the keyboard.

You can also use a cotton swab dipped in alcohol to scrub the keyboard keys, for the gaps that are difficult to clean, find a small thin stick, like a toothpick, wrap an appropriate amount of cloth or soft paper with strong adsorption, dipped in alcohol, it can be easier to wipe out the dust. Of course, these are just daily maintenance, if you want to be cleaner and safer, every few months, it is best to open the back cover of the keyboard, take out the circuit board for deep cleaning, and clean it thoroughly with a soft cotton swab, but try to be careful to avoid damaging the parts, you are not sure, you can go to the computer store to find a professional to do it.

If you have an old keyboard card, you either buy a new one, or go to the computer city to clean it and tell someone else to reinstall it

If the keyboard is dirty, or if you have a drink, you can take it apart and clean it.

Of course, it depends on what kind of keyboard it is, there are many types of keyboards now, some can't be disassembled, or it's not easy to restore, so the keyboard is poured into the drink or dirty things into it is not easy to deal with.

For general keyboards, after the power is off, remove the keyboard caps one by one, and the dirty things and drinks will be under the keycaps, on the top of the keyboard version, and generally will not enter the inside of the keyboard. The raised square opening on the top of the keyboard is just under the keyboard cap, so it generally does not enter the inside of the keyboard. At this time, it is good to clean it with a vacuum cleaner or rag, and it is best to rinse the keyboard cap with water.

Dry it and put it back on.

It's so dirty inside the keyboard! Teach you a trick, the dirty things will run out automatically, try them all.

It can also clean the keyboard, and it can decompress, which is comfortable.

Sweep off the dust with a brush first, and then wipe it with a rag!

It can also clean the keyboard, and it can decompress, which is comfortable.

Buy some small brushes and other cleaning tools, and then wipe them with a damp rag, you should be able to clean up.

The vacuum cleaner is afraid that it will not be clean, and there will be places that have not been washed when washed with water, and the keyboard will be dirty is the dirtiest in the gap, right, it is very easy to do, remove the keyboard on the keyboard one by one, wash it, and then wipe the keyboard groove with a dry cloth, and finally put the press on it in the original order, it doesn't take much time, the keyboard is like new, I do it every time, it works. However, it is best not to remove the large press that occupies more than two units, because it is easy to remove and it is difficult to install it.