-
Subject 2 Exam Content:
1.Reversing into storage.
2.Side parking.
3.Curve driving.
4.Right-angle turns.
5.Stop at a fixed point at an uphill start.
Key points of the test: When the test is reversed into storage, the most important point is that you can't stop halfway, once you stop, you won't pass the test. Before preparing to enter the garage, trainees can look at the garage sideline from the rearview mirror, and the front of the car will start to slowly reverse backwards.
The vertical lining of the triangular window on the right side of the rear door should coincide with the upper right corner of the yellow edgeline, and the direction can be reversed into the garage.
Drive the vehicle to the front of the garage parallel to the direction of travel, and then reverse to the right rear into the garage, there can be no pause in the middle, as long as the side parking in this range does not cross the edge of the garage, it is considered to pass.
The vehicle is driving on the S-shaped road surface of the specified width, and the curb line shall not be squeezed, and the direction shall be used freely. The purpose is to develop the skills of motor vehicle drivers in the use of steering and the operation of wheel tracks.
With a low speed according to the prescribed driving route, a 90-degree sharp turn without stopping passes through a right angle. If you fail to turn a corner, or if you stop the engine in the middle of the game, you will be deducted points.
When the car is parked on the ramp, the handbrake will be tightened to prevent rolling, and then the process of starting acceleration and passing the ramp in the ramp is the test of ramp start.
-
Driving school subject 2 test process, practice these 5 items well, and the test is worry-free!
-
Subject 2: Examination content and passing criteria.
1) The content of the test.
1. Driving a motor vehicle in the specified venue to complete the test items;
2. Mastery of motor vehicle driving skills;
3. The ability to judge the spatial location of motor vehicles.
2) Examination items.
Basic test items: pile test, ramp fixed-point parking and starting, side parking, passing through unilateral bridges, curve driving, right-angle turning, speed limit through the width limit gate, passing continuous obstacles, 100 meters plus and down gears, undulating road driving.
There shall be no less than 6 test items for large buses, tractors, city buses, medium-sized buses, and large trucks. Compulsory test items for large buses and city buses: pile test, ramp fixed-point parking and starting, right-angle turning, passing unilateral bridges, passing continuous obstacles; Tractor quasi-driving type compulsory test items:
Pile test, ramp fixed-point parking and starting, curve driving, right-angle turning, speed limit through the width limit gate; Medium-sized passenger cars and large trucks are required to drive the vehicle: pile test, ramp fixed-point parking and starting, side parking, passing unilateral bridges, and passing continuous obstacles. Other test items are randomly selected.
There shall be no less than 4 items in the quasi-driving test for small cars, small automatic vehicles, low-speed trucks, ordinary three-wheeled motorcycles, and ordinary two-wheeled motorcycles. Compulsory test items for small cars and low-speed trucks: pile test, ramp fixed-point parking and starting, side parking; Compulsory items for small automatic transmission cars:
pile test, side parking; Ordinary three-wheeled motorcycles and ordinary two-wheeled motorcycles are required to drive the vehicle: pile test, ramp fixed-point parking and starting, and passing unilateral bridges. Other test items are randomly selected.
The subject 2 exam should be taken first. If there is no point deduction in the pile test, the pile test can no longer be conducted when the make-up test or the test is rescheduled.
Other quasi-driving test items shall be determined by the traffic management department of the provincial public security organ.
3) Eligibility criteria.
The full score is 100 points, and the evaluation criteria for unqualified, 20 points, 10 points, and 5 points are set. Those who meet the following requirements will pass the examination:
1. Apply for large buses, tractors, city buses, medium-sized buses, and large trucks, and score 90 points;
2. Those who apply for other quasi-driving types with a score of 80 points.
-
Subject 2 exam items include:Reversing into the garage, side parking, ramp fixed-point, right-angle turning, and curve driving are five compulsory tests
Reversing into storage.
First, drive the test car outside the designated area, stop and adjust the mentality, because it is not time outside, and it is not illegal, and after the adjustment, we will drive the car into the test area of the reversing warehouse.
1. Remember that there is a longitudinal stringing and horizontal stop (these two things will directly affect your results, and these two things are very easy to do).
2. After the completion of longitudinal threading and transverse parking, play a circle to the right, walk forward about 1 meter to stop and then pull the reverse gear, the reversing into the warehouse officially begins, and the whole process of reversing and warehousing must be completed within 210 seconds. Control the speed of the car, keep an eye on the right mirror, and remember to adjust the method of wide and narrow back. After entering, through the reflector, the body is parallel to the line, quickly return to the right, and stare at the lower edge of the right reflector and the upper left line to stop the car.
Side parking
1. When entering the test area, you should thread longitudinally and park horizontally.
2. After entering the park, stop the car, play a circle to the right to hang the reverse gear, look at the left reflector, see through the mirror that the left rear rear car tail and the right rear library angle form a straight line, and then quickly turn the steering wheel back to the right, and then through the left reflector, you can see the left rear tire, the car tire crimped line quickly to the left full, go inside through the reflector to see the body and the line parallel parking.
3. Turn on the left turn signal at the exit, stare at the left corner and take the left yellow line to quickly return to the right, and then pass the highest point of the wiper or take the left yellow line to quickly turn to the right.
The ramp stops at a fixed point to start
1. Before going uphill, it is best to aim the car at the parking area and drive over, so you don't need to adjust too much on the slope;
2. After parking, the distance between the wheels and the side line should be within 30cm, and the front of the car should be in the yellow line area;
3. Start again, slowly lift the clutch to semi-linkage, and start naturally without rolling and turning off.
Curve driving.
1. The front of the car is facing the entrance of the curve slightly to the right side line.
2. When the upper left corner of the front of the car and the right sideline are about to collide, make a circle of the steering wheel to the left and add 1 to 4 circles, keep the upper left corner of the front of the car always along the right sideline, and adjust the direction at a small angle at any time when there is a deviation.
3. When the upper left corner of the front leaves the right sideline and is about to collide with the left sideline, turn the steering wheel back to the right.
4. When the upper right corner of the front of the car is about to collide with the left sideline, make a circle of the steering wheel to the right and add 1 to 4 circles, keep the upper right corner of the front of the car always along the left sideline, and adjust the direction at a small angle at any time when there is a deviation.
5. After the front of the car exits the corner, observe the left rearview mirror, and when the rear wheel of the left car is about to be parallel to the left sideline, return to the right direction and drive out of the corner.
Right-angle turns.
1. Enter the right-angle turn, control the speed, and have longitudinal threading before entering, which is subject to about 30cm between the body and the right sideline.
2. The longitudinal check number should turn on the left turn signal, and the computer says: "right-angle turn" and turn off the turn signal artificially.
3. When the left rearview mirror is parallel to the horizontal line at a right angle, quickly fill it to the left.
4. When the car turns around, you should quickly turn the steering wheel back to the right and walk out.
-
The second subject of the driving test is the field test, which generally tests the reversing into the garage, side parking, ramp starting, curve driving, etc.
-
Subject two, also known as the road test, is a part of the motor vehicle driver's license assessment, is the abbreviation of the field driving skills test subject, the car C1C2 test items include reversing into the garage, side parking, ramp fixed-point parking and starting, right-angle turning, curve driving (commonly known as S bend) five compulsory tests.
-
Reversing into the garage, S bay, side parking, right angle, and slope up, a total of five projects, I hope you pass through it at one time.
-
For the second subject of the driving test, the current content of the test is still the reversing into the garage, as well as right-angle turning, side parking, half-slope starting, and curve driving, these items.
-
The content of the second test of the driving school subject is as follows:
Subject 2 requires 15 to 20 days of practice before you can take the exam, of course, it still depends on the learning ability of each student. There are some students who learn faster and may not need so much time to take the exam, but there are also some students who have a slower grasp of knowledge and need to study for a longer time to be able to firmly grasp the key points of each knowledge bridge and then take the exam.
Subject 2 requires a full number of hours to take the exam. For example, the C1 driver's license requires 16 hours of practice, and you can play up to 4 hours a day, so it takes 4 days to complete the school hours the fastest. There are also full hours of study, not immediately can take the exam, to audit, the audit hours basically take about 3 7 days, of course, there are some faster review speed, may be completed in one or two working days.
In most areas, there are 5 test items in the subject 1 exam, mainly reversing into the garage, side parking and right-angle turning, curve driving and ramp fixed-point parking and starting. These items are not particularly difficult to operate, but in the process of learning, students need to keep in mind the knowledge points of each project explained by the coach, practice Tongxiang repeatedly, and master it proficiently, so as to help them pass the exam smoothly.
Subject 2 includes five compulsory tests: reversing into the garage, side parking, ramp fixed-point parking and starting, right-angle turning, and curve driving (commonly known as S curve).
-
The second test of the driving school subject is as follows:
1. Reversing into storage: Reversing into storage is more practiced in the process of the subject two exams, and it is also a subject that students think is more difficult in the subject two exams. Before preparing to enter the garage, the trainee can look at the garage sideline from the rearview mirror to determine the angle of the steering wheel when reversing.
The body should be kept meters to meters away from the sideline, and the front of the car should start to reverse slowly with infrared light. The vertical lining of the triangular window on the right side of the rear door should coincide with the upper right corner of the yellow edgeline, and the direction can be reversed into the garage.
2. Side parking: Side parking is a more commonly used technology in the daily driving process, driving the vehicle to the front of the garage parallel to the direction of progress, and then reversing to the right rear into the warehouse, there can be no pause in the middle, as long as the side parking in this range does not pass the side line of the storage location, it is considered to pass. Pay special attention to the failure of the mid-stop test;
3. Uphill start fixed-point parking: when carrying out uphill start and fixed-point parking, the most worrying thing for students is the problem of stalling, when the car is parked on the ramp, in order to prevent the car from slipping, the handbrake will be tightened, and then the process of starting acceleration and passing the ramp in the ramp is the test of ramp start. Points will also be deducted for slipping;
4. Right-angle turning: When making right-angle turns, it is necessary to control the speed of the car, use low speed according to the prescribed driving route, and make a 90-degree sharp turn through the right angle without stopping. If you fail to turn a corner, or if you stop the engine in the middle of the game, you will be deducted points.
When turning at a right angle, pay attention to the angle of the car and try to stay on the side of the road, so that it is easy to pass;
5. Curve driving: Curve driving requires students to have a certain sense of driving, and the vehicle is driving on the S-shaped road surface of the specified width, and the road edge line is not allowed to be squeezed, and the direction is used freely. The purpose is to train the motor vehicle driver to use the steering and the skills to master the wheel trajectory, and it will be easier to master the car feeling.
Millions of car purchase subsidies.
-
1. Reversing into storage, reversing into storage can be said to be the longest training time in these five projects, and it is also the most error-prone in the subject two exams, it mainly looks at the coordination of students' hands and feet and the control of the clutch, the speed is too slow, there will be a phenomenon of stopping halfway, and the speed is too fast It is easy to press the line or stop beyond the parking line. Everyone must pay more attention to this project, as the first item of the subject 2 exam, it can often affect your later performance;
2. Side parking, when you have mastered the trick of reversing into the warehouse, then side parking is very simple for you. The training time of this program is not very long, and it can be learned in half a day. This project also needs to master the control and reaction speed of the clutch, which is basically the same as reversing into the garage.
I just need to follow the coach's instructions, look at the good spots, and align the line;
3. Curve driving, curve driving is the simplest project that many people think, and its training time is not long, mainly to examine the reaction speed of the trainees and the control of the steering wheel, adjust the steering wheel in the slow forward, and avoid contact between the vehicle and the curve. Of course, the simpler the thing, the easier it is for people to take it lightly, and there are many students who will fall into this level if they don't pay attention to it, so don't be careless;
4. Right-angle turning, this project can be said to be the shortest training time, after all, the previous exercises have been involved in the inspection and to the point-to-line, and can almost master the adjustment of the steering wheel, so the right-angle turning is no longer difficult at this time. Of course, it's still the same sentence, don't take it lightly;
5. Banpo parking and starting, most of the students are hanging in the two projects of reversing and parking and starting. The half-slope parking and starting are also the longest training time except for reversing and storage. It is mainly to practice the fixed point, and the inaccurate grasp of the distance of 30 cm has also made many people win again.
As the last project of subject 2, if you fail, you have to start all over again, and the pressure is not small, so you have to practice more.
Millions of car purchase subsidies.
All the steps of subject 2 include reversing, side parking, fixed-point starting, and curve driving; >>>More
The first level: reversing into storage.
Candidates need to find the right spot, pour in from one side and drive out to the other side, and then pour in once from the other side. >>>More
Be sure to pay attention to what the lights on the dashboard represent, and pay attention to the points of each item.
Subject 2. The main thing is to watch, which requires you to fix your seat and "adjust" your eyes. >>>More
Driving test subject 2 S bend requires the hand to grasp the exact position of the steering wheel, which is not strictly required in the exact position, in principle, at least the hand can not leave the steering wheel. The second subject exam is that you are only in the car, and there is no safety officer to watch. >>>More