What do you think you need to pay attention to when driving in tunnels?

Pay attention to your speed, there will be a speed limit sign in a prominent position at the entrance of the tunnel, and there will be a speed limit reminder inside the tunnel. Maintain a normal speed and do not exceed the speed limit. And don't be in a hurry to accelerate when you are about to drive out of the tunnel mouth, in addition to the driver's eye light changes will have a "white hole effect" in addition to the fear of rear-end collision with the car in front, at the same time, some illegal speeding camera positions will be designed here, be careful not to get hit.

Don't speed, don't go too slow, due to the light problem in the tunnel, people's judgment of speed at this time is lower than in the open air. If you are too fast or too slow, you can easily get rear-ended. Also, lane changes are prohibited.

Do not turn on the high beams, as turning on the high beams for a long time at night will affect the oncoming and the vehicle in front, as the high beams will blind the driver's visual perception instantly. In the tunnel, due to the difference in light between the inside and outside of the tunnel, the driver's visual experience is very uncomfortable, and if the high beam light line is added, it is more likely to be dangerous, so the high beam is avoided in the tunnel.

Do not honk in the tunnel, because the sound effect in the tunnel is more obvious, and the volume generated by the horn is more prominent, so no matter how anxious you are in the tunnel, do not honk, the effect on the owner or others is very bad.

Slow down and turn on the lights before entering the tunnel, if it is daytime driving, the bright will be instantly darkened when entering the tunnel, often at this time the human eye will be difficult to adapt to in a short time, so before entering the tunnel, the speed should be reduced, the distance between the car should be pulled, and the lights should be turned on at the same time, and the relatively slow speed should be kept to enter the tunnel safely.

It is important that the lights are turned on regardless of the lighting in the tunnel, especially in tunnels where there is a large difference in brightness between the inside and outside, and the lights are turned on to make it easy for the car behind to see you. I have entered the tunnel many times, and because the difference between the brightness inside and outside is too great, I feel that it is dark inside, and I can't see anything for a moment, and if there is a car in front of me without the lights on, it is really possible to be invisible. This situation occurs mostly in urban expressway tunnels, some people are used to not turning on the lights, the brightness difference between inside and outside is very large, entering from the outside is to feel that nothing can be seen, instinctively will slow down, the brakes are good, the brake lights can give the rear car a hint, just afraid of dark cars, do not brake, do not turn on the lights, do not step on the accelerator to slow down, it will be easy to be rear-ended.

I have passed through the Qinling Tunnel 8 times, from Xi'an to Chengdu, passing through the Qinling Tunnel Group, which is so shocking! 540 bridges and 136 tunnels, which were quite fresh at first, but then I wanted to vomit when I drilled the tunnels. Here, traffic accidents often occur, and traffic jams are commonplace!

Therefore, be careful when entering the tunnel. Before entering the tunnel, the headlights must be turned on in advance, when the light becomes the driver's only signal in the tunnel**. At this time, do not use automatic headlights, which are turned on only after entering the tunnel, so that the vehicles in the tunnel can perceive us in advance.

I have a friend who is a professional driver and doesn't know that you need to turn on the lights to enter the tunnel. Even during the day, the headlights, vision lights, and tail lights should be turned on about 50 meters from the tunnel entrance to identify the condition of the vehicle in front and attract the attention of the vehicle behind. Don't turn on the high beams at the end!

Don't turn on the high beams! Don't turn on the high beams!

Choose your road, "keep an eye" sign, generally the sign at the entrance of the tunnel will be very large, what we need to do is to choose your own road in advance before entering the tunnel, after entering the tunnel is a lane with a white single solid line, overtaking is prohibited. In addition, even if you are driving normally, some cars are changing lanes and overtaking in the compacting line in the tunnel, etc., you still drive the car to prevent it and be careful of accidents.

Tunnel traffic is not allowed to stop at will except for changing lanes and merging lanes. These tremor situations are very dangerous to occur in tunnel traffic. Let's take a look at what you should pay attention to when driving in a tunnel.

You should slow down before entering the tunnel.

As a tunnel, there are generally signs of deceleration at the entrance of the tunnel, mainly to prevent some accidents, because when the owner enters the tunnel, his vision outside will definitely be more limited than before, and at the moment of entry, the light becomes dim, so it is actually difficult for the owner to adapt at this time. If the car is fast, it is easy to crash into the car in front of him, causing a series of rear-end accidents, and sometimes some serious accidents.

When entering the tunnel, you should turn on the headlights in time.

Although there are lights when the car owner drives into the tunnel, the brightness must be far from the outside, and the tunnel in some areas is not equipped with lighting equipment, so it is easy to cause some accidents when the car owner enters the dark. To avoid these accidents, car owners should turn on their headlights before entering the tunnel, but never switch to high beam mode to avoid some accidents.

Tunnels should be kept at a safe distance.

When driving into the tunnel normally, due to the large difference in light in and out of the tunnel entrance, the line of sight will be blind in a short time, so many people will subconsciously brake with one foot, and the rear car may also be in a blind state, so maintaining a long distance can ensure sufficient safety. And if there are too many vehicles in the tunnel, you can reserve a certain amount of reaction empty room to keep a long distance.

Be careful not to change lanes in the tunnel.

Usually the tunnel width is limited, the lane is few, the light in the tunnel is not good, and the driver's vision is limited. Therefore, it is strictly forbidden to change lanes in the tunnel, drive in the lane you are in, and do not overtake.

Millions of car purchase subsidies.

Be careful not to slow down and not overspeed.

When approaching a tunnel: Look carefully at traffic signs or traffic information boards.

Two-lane tunnels: You should stay on the right side of the road and drive at a normal speed.

Start the lights in advance: Turn on the headlights and width indicators in advance.

Reduce travel speed: The brightness inside and outside the tunnel is different, so slow down.

When the Qingqing Tunnel should carefully observe the traffic signs and traffic information boards, when driving on the right side of the road in the tunnel, turn on the lights and width indicators in advance, reduce the speed of the vehicle, control the direction of the vehicle, and prohibit overtaking in the tunnel.

Two-lane tunnels: You should stay on the right side of the road and drive at a normal speed. Start the lights in advance: Turn on the headlights and width indicators in advance. Reduce travel speed: The brightness inside and outside the tunnel is different, so slow down.

If the car has an accident, it is necessary to turn on the danger warning lights in time and put warning signs behind the car to call the police in time.

When driving in the tunnel, you must not change lanes and merge lanes, and you must not stop at will. Sufficient safe driving distance should be maintained and the lights should be turned on before entering the tunnel.

Before entering the tunnel: slow down appropriately and turn on the low beams;

Driving in the tunnel: it is strictly forbidden to change lanes, speeding, etc.;

Exit the tunnel: Slow down and then accelerate away.

Hello, tunnel driving needs to be careful not to change lanes, do not drive at low speed or high speed, and slow down when entering or exiting the highway.

When driving in the tunnel, be careful to turn on your headlights and prohibit lane changes. Sidewalks are very unsafe.

The most serious point of tunnel traffic is that it is forbidden to change lanes, and it is necessary to pay attention to turning on the lights to ensure that the line of sight is bright.

The following wisdom defeat is the precautions for vehicles passing through the tunnel: 1. Meet the requirements: carefully observe the elevation, width of the traffic signs and text instructions at the entrance before entering the tunnel dry road, and the vehicles that do not meet the requirements cannot enter the tunnel; 2. Observe the incoming car:

Before entering the one-way tunnel, vehicles should carefully observe whether the other party is allowed to pass through and sound the horn or turn on the wide lights appropriately; 3. Drive on the right: When the vehicle enters the double-traffic tunnel, it should drive on the right side, turn on the lights according to the situation, and pay attention to the intersection of vehicles and the tunnel should not honk; Former J-4, no overtaking: no overtaking, reversing, U-turn and parking vehicles are not allowed in the tunnel, when the vehicle breaks down, the wide lights and tail lights should be turned on and try to move outside the tunnel.

What are the precautions for vehicles passing through tunnels? 1) Before entering the tunnel, carefully observe the traffic signs and text descriptions such as elevation and standard width at the entrance. Vehicles that do not meet the requirements are prohibited from entering the tunnel, as shown in Figure 7-51.

2) Before entering the single-lane tunnel, the vehicle should carefully observe whether the other party is coming, and whether there is any traffic situation. When allowed, the horn is sounded or the width indicator is turned on, as shown in Figure 7-52. 3) When entering the two-lane tunnel, the vehicle should drive on the right side, turn on the lights as appropriate, and pay attention to the fact that the vehicle should not sound the horn as if passing through the tunnel in one fell swoop, as shown in Figure 7-53.