What s going on with a small flow of water in the kitchen faucet

The small water output of the kitchen faucet is caused by the following problems. 1. Water quality problems, impurities such as stones and rust in the water make the faucet blocked. Room faucet spout.

Twist and unscrew the drain of the strainer head, if the water flow is restored, the problem is out of the net. Then the removed filter is gently placed in the pool and the large particles of solids fall naturally. Remember not to pick it, as it will get stuck when pressed into the filter.

In order to be able to clean in place, the filter and gasket can be removed and washed, and the dirt in the middle of the filter hole can be pierced with the tip of a needle. Reattach it after it is completed. Like you can learn from kitchen faucets, many times if you wholesale faucets, you can go to kitchen faucet manufacturers.

2. There is another situation in the kitchen faucet, if the situation caused by large foreign objects is relatively rare, but it is also difficult to reach, so I am also a little lower here, in fact, it is very simple, only need to disassemble the wrench used for the faucet.

In fact, most faucets can be used to twist the faucet with great strength, and of course, the filter head must also be removed. Turn the faucet upside down, take the water and pour it in, if the water behind it is not smooth, there is a foreign body in the card. It can also be placed for cleaning to ensure that it can be in place.

Then you can do it again, taking care to tighten the water at the same connection when you put it back in. 3. The water volume of the kitchen faucet is reduced, and there is no fouling and blockage of the filter screen of the air aerator (the aerator is the whole structure of the faucet, and the function is the foaming of the water from the faucet through the kitchen water). Remove the spout and clean it.

4. The water output of the shower is small, the water pressure is low or the shower head is blocked. Treatment: Sprinkle the rubber gasket of the sprinkler inlet filter or sprinkle the top spray. 5. The basin faucet and kitchen have a small amount of water and do not bubble.

Cause the aerator to not be able to foam. Solution: Remove the faucet faucet and replace it with an aerator.

The causes of faucet water are: water pressure problems, water quality problems, foreign body blockage problems, and aerator problems.

1. Water pressure problem

First of all, you need to determine whether the water output of the local faucet is small or the whole house faucet has this situation, and then determine whether the main water valve at home is not fully opened, resulting in a small amount of water, and you can also ask the neighbor if the water pressure has the same problem, if so, you can discuss with the property to solve it.

If there is no property in the community, the water output can be improved by installing a pressurized pump at the main valve by itself in the case of insufficient water pressure.

2. Water quality problems

The water contains impurities such as sand and gravel, rust, etc., which will cause the faucet to clog over time, resulting in a small amount of water output. You can unscrew the faucet outlet to check, and with the strainer head unscrewed, turn on the faucet, if the water flow returns to normal, it means that the problem is with the filter.

You need to gently pat the filter of the faucet in the pool to let the sand and other large particles of solid impurities fall down, remember not to pick it by hand, this will press the sand into the filter and get stuck. In order to ensure that the cleaning is in place, the filter and gasket inside the faucet can be removed and rinsed, and the stain in the middle of the filter hole can also be pierced with the tip of a needle, and it can be reinstalled after cleaning.

3. The problem of foreign body blockage

The small amount of water coming out of the faucet may be caused by large foreign objects, which is rare but can also be encountered. In fact, the operation is simple, only need to prepare a wrench to disassemble the faucet, and break the faucet interface under the basin with a wrench, in fact, most faucets can be twisted open with great strength by hand, after the faucet is removed, the faucet filter head is removed and placed aside.

If the water flowing out of the back end of the faucet is not smooth, it means that there is a foreign object in the faucet, which needs to be thoroughly rinsed under clean water, and then reinstalled after cleaning, remember to tighten the faucet.

4. Aerator problem

When we clean the faucet every day, we often only pay attention to the surface of the faucet, but in fact, the inside of the faucet is more important. If the water output from the faucet becomes smaller, it is most likely due to a clogged aerator. You need to remove the aerator and soak it in vinegar, then use a small brush or other tools to clean the debris, and finally reinstall it.

There are several reasons why the water output of the faucet becomes smaller after years of use;

1.limescale clogging faucet filter aerators;

2.Scale clogging water pipes, general iron water pipes may have this problem;

3.The faucet is broken.

It is necessary to investigate step by step, find the cause in the order of the cause and implement the solution, and then repair according to the determined cause.

1.limescale clogging faucet filter aerators;

For the cause, pipe wrenches or large-mouth pliers can be used.

Remove the filter aerator from the faucet, check whether the water output of the faucet is still small in the absence of a filter, if the water volume is normal, it means that the filter is blocked, please buy a replacement on a treasure yourself.

2.Scale clogging water pipes, general iron water pipes may have this problem;

On the premise of excluding Cause 1, for Cause 2You can use a pipe wrench to remove the faucet and check whether the water output of the water pipe is still small in the absence of a faucet, what to do if the faucet leaks will cause a great waste of resources and bring a lot of inconvenience to life.

The structure of the faucet is very simple, and generally speaking, if the faucet is leaking, you only need to replace the shaft gasket inside the faucet.

or gasket parts such as triangular gaskets, which can be solved.

It is the leakage at the faucet joint, which is mainly caused by the damage of the water-stop tape that ties the fixing screws of the faucet part, so just use a wrench to remove the faucet and re-roll the new water-stop tape in the place where the screw is fixed.

If you find that the faucet at home has become smaller, you can analyze the reason, and then solve it in a targeted manner.

The workers of the faucet came to take a look.

There are also other problems in the process of using the faucet at home, such as water leakage, etc., in the face of the faucet problem affecting daily use, you must solve it in time to avoid it The problem continues.

The reason why the amount of water in the faucet becomes smaller The faucet is a very long and long kind that bends downward, and hot water is often used, which causes the water to be very thick and alkaline, and the water flow becomes very small. There are many people who encounter this kind of problem, and many people will find that there will be a layer of sediment inside the faucet after being used for a long time, which will seriously affect the filter screen and level, resulting in poor use of the faucet.

The kitchen faucet is used more frequently, and Li Zhengyin is turned on dozens of times a day. In the process of using the faucet, some people obviously feel that the water in the faucet at home is slowly shrinking, even when it is turned on, the water is very slow, which will make people very irritable. So what are the causes of small water output from the faucet and what are the solutions?

You need to determine if the local tap water is small or the water in the whole house, then determine if the main water valve in the home is not fully opened, causing a small amount of water, and ask your neighbor if the water pressure is the same problem. If yes, you can discuss it with the property. Much of this is due to the lack of pressure on the upper water supply.

If there is no property in the community, a compressor pump can be installed at the main valve to improve the water volume when the water pressure is insufficient.

Small faucet water can be caused by large foreign bodies. This is rare, but it can be encountered. In fact, the operation of the faucet water outlet is very simple.

Just take out the wrench on the faucet. The faucet connector under the basin was broken with a wrench. In fact, most faucets can be unscrewed by hand.

After disassembling the faucet, remove the faucet filter head and set it aside. The faucet stands on its head and fills the faucet with a bottle of water. If the water coming out of the back of the faucet is not smooth, it means that there is a foreign object present inside the faucet.

It needs to be thoroughly cleaned under clean water and reinstalled after cleaning. Remember to tighten the faucet.

When cleaning the faucet every day, it is often only the surface of the faucet that is clean, but in fact, the inner part of the faucet is more important. If the tap has a small outlet, it is most likely due to a blockage in the bubble generator. You'll need to remove the bubble generator, soak it in vinegar, then clean up the debris with a brush or other tool, and finally reinstall it.

If you find that the faucet at home is small, you can analyze the cause and then focus on solving the problem. If you don't want to be so troublesome, you can go directly to a professional faucet repair worker to take a look. There are also other problems with the use of faucets in the home, such as water leakage, etc.

When encountering a problem that affects daily use, it must be solved in time to prevent it from continuing.

You can get it for free

If the faucet at home is small, you need to find a way to solve it. What's the deal with the small water coming out of the faucet? PChouse will take you to find out.

1. Clogged filter screen: Some faucets have added filter screens to prevent sand from entering the sand, unscrew the faucet interface to see if there is something blocking the filter screen.

2. The water pressure is too small: If you live on a high floor, you may encounter insufficient water pressure, resulting in water that cannot be hit and there is little water.

3. The valve of the water is smaller: If someone closes the valve smaller, then the water will definitely be less. There is also a problem with the valve.

4. Large water consumption at home: If a large amount of water is used in multiple places at the same time, the water output will be diverted, and the water output will definitely be reduced.

5. There is a problem with the faucet: check whether the water in other places is normal, if it is normal, then there must be a problem with the faucet.

6. Water pipe blockage: If the water pipe is blocked, this needs to be dealt with by professionals.