How do you install the drain pipe of the washing machine companion

Automatic washing machines are also divided into drum type and wave wheel type, it is estimated that your washing machine is drum, the drainage method of the drum washing machine is the pump type, the drain pipe is lowered and the water is added to flow out, so it must be raised more than the upper edge of the inner cylinder, and the water pump can pump the water out; The drainage method of the wave wheel washing machine is a solenoid valve, and the drain pipe must be lower than the bottom of the inner cylinder.

1. Put the washing machine down;

2. You can see the head of the drainage pipe;

3. There are screws and spring clamps;

4. Loosen the screws or pinch the spring clip;

5. You can unplug the tube. Just put on a new one.

1. First take out the drain pipe of the washing machine and place it in the matching position, pay attention to one end of the drain pipe of the washing machine is installed at the drain outlet, and the other end is installed at the drain closure of the washing machine.

2. Then plug the sewer pipe into the reserved opening of the washing machine base until it fits the length of the washing machine drain pipe.

3. After installing the drain pipe properly, tighten the screws, and then install and fix the bottom plate.

4. Finally, move the washing machine to a suitable position and use it when you turn on the electric talk Bichen source.

Precautions for installation and use of washing machines:

1. The lower drain port must be higher than the drain pipe during installation, otherwise the water may remain in the drain pipe.

2. The location of the washing machine is best in a relatively ventilated and dry place.

3. After washing the clothes, take them out to dry immediately, and do not stuff them in it for a long time.

4. After washing clothes, the water should be fully drained and the lid should be opened to dry to avoid residual water in the machine and form a breeding ground for microorganisms.

It should be noted that this answer is applicable to most brands of washing machine models such as Midea, Gree, and Haier.

How to put the drain pipe of the washing machine on the <>: put a section of the drain pipe of the washing machine into the drain outlet, and put the other end on the drain of the washing machine, and then anastose, plug the drain pipe from the reserved mouth of the base until the length of the drain pipe of the washing machine reaches a suitable length, use the drain port to the quasi-sewer pipe, and if possible, you can seal it with items such as a circlip or a sealed bag, screw the screws, and it is almost done.

This answer is suitable for most washing machine brands such as Haier XQG80-B1226S, Siemens WS12M468Ti, etc.

Since the drum washing machine does not have a drain valve control, it is opened when the drain is needed, otherwise it is always closed, and the drum and drain pipe are directly connected. There is a drainage pump for drainage, if the drainage pipe is directly horizontal such as a floor drain, it will cause water to enter and discharge water directly at the same time, and it is impossible to store water for a few stupid liters.

It is actually very easy to fix the drain pipe, on the back of the machine, there is a drain pipe fixing buckle, as long as you follow it, the drain port, buckle, and floor drain can ensure that the installation is correct.

Alternatively, the drain pipe must be installed in an inverted U-shape, and the highest point must be higher than the highest point of the cylinder barrel.

Let's talk about the installation method of the drum washing machine:

Square Ruler Method Steps.

Check that the outer box is in good condition, and if it is in good condition, open the outer box.

Remove the four fixing bolts on the cup surface, remove it along with the rubber pad inside, and keep it.

<> install the dust cover at the fixing bolt position and fix it with a Torx screwdriver.

Open the front panel and remove the two hoses inside. Potato old.

<> install the drain pipe and fix the drain pipe to the drain with the clamp that comes with the washing machine.

<> install the inlet pipe in the same way as above.

Energized, watered, and tested.