Can you fix a broken razor How to fix a broken razor

The answer is: whether the razor is broken or not depends on where it is broken, and it depends on what kind of razor it is.

If it is an ordinary razor with a blade, it can be repaired and the blade can be changed directly.

If it is the kind of electric one, you can extend its service life by maintaining it regularly.

1 .Battery care:

If it is a cordless razor, it is best to recharge it when the battery inside is used up. That is, once used up and charged once. On the initial charge, charge for an additional 3 to 4 hours on top of the full charge time-.

1 hour full charge 4 hours, 8 hours full charge 12 hours) If it is - with a battery razor, pay attention to the replacement of the battery. It is best to remove the battery after each use to prevent the battery from leaking. It is best to use alkaline batteries in normal times.

2.Knife Maintenance:

Mainly the head of the knife, after each use, clean the beard inside. After one to two months of use, open the cutter head, share the blade knife net, and then use the brush to clean the head - touching the beard and all areas until there is no beard. The most common way to clean the bits is to rinse with clean water.

When rinsing, it is best not to touch the shaver body with water to avoid mechanical failure. If you are using a product - it is a wet and dry type, the base part is still - and do not come into contact with water to avoid damaging the motor. This prolongs the service life of the cutter head and ensures the use effect.

3.Other. It is best to be careful not to expose the cutter head to any external squeezing - and stress, so as not to deform the bit. When not in use, the cutter head should be covered with a protective cover. Do not hit the shaver to avoid loose or short circuits of the wires on the body.

If it's an ordinary razor, it's better to buy a new one every time you repair it, and if it's very expensive, you still have to look at the place where you bought a razor.

If the repair period has passed, it is better to replace it with a new one, which is generally not of much value, and the quality after repair is not necessarily good.

It depends on the breakdown of that place!

Can be repaired, Tsinghua has repair, there is a place**.

See if there is still a warranty? If you can, take it to the warranty. If you can't, you don't know where to fix it.

1. After the power is turned on, the rotating blade does not rotate or has no reciprocating motion (1) The battery voltage is too low: the voltage can be measured by the DC voltage level of the multimeter; It is also possible to use small beads to connect in parallel, and judge the voltage level by depending on its brightness. If the voltage is low, the dry battery should be replaced, and if the rechargeable battery is used, it should be charged in time.

2) Shavers using AC power, poor contact between plugs and sockets or broken power cords: should be replugged, and if the plug is faulty, it should be repaired in time. (3) Oxidation wear and poor contact of the power switch contact

Contacts can be cleaned with anhydrous alcohol; It can be replaced by soldering one layer.

How do you fix a broken razor?

Hello, dear, I have seen your question and am sorting out the answer, please wait patiently for three minutes Hello, dear, the common faults of shavers and their maintenance methods are shared with you. Common faults and maintenance methods: 1. After the power is turned on, the rotating blade does not rotate or has no reciprocating motion (1) The battery voltage is too low

The voltage can be measured with the DC voltage level of the multimeter; It is also possible to use small beads to connect in parallel, and judge the voltage level by depending on its brightness. If the voltage is low, the dry battery should be replaced, and if the rechargeable battery is used, it should be charged in time. (2) Shavers using AC power, poor contact of plugs and sockets, or broken power cords

It should be reinserted, and if the plug is faulty, it should be repaired in time. (3) Oxidation and wear of the power switch contact, poor contact: the contact can be cleaned with anhydrous alcohol; It can be replaced by soldering one layer.

4) Poor contact between the battery clamp and the battery: Since the battery clamp spring is corroded by battery leakage, resulting in poor contact, sandpaper can be used to polish to remove the dirt. If it is caused by insufficient spring elasticity, a metal sheet can be inserted at the bottom of the battery to make good contact.

5) The grille is deformed and the moving blade is stuck: a non-metallic material (such as cloth balls, thread balls, sandbags, etc.) similar to the inner surface of the grille can be found and pasted to the inner surface of the grille and squeezed to restore its original geometric shape. If the grille is broken, it should be replaced with a new one.

6) Severe wear or fall off of the carbon brush of the motor: replace, regrind or reinstall the carbon brush. (7) The motor rotor is disconnected and disconnected

Send it to a professional repair shop for repair.

Electric shavers can be repaired in some electrical repair shops or mobile phone repair shops. The circuit of the electric shaver is very simple, and it can be repaired anywhere the electrical appliance is repaired. If the price of the electric shaver is very cheap, don't repair it, because the repair of the trace rock money is enough to buy a new one, of course, if it is very expensive or has special significance, if it is broken to repair, you can find a repair electrical appliance, or some mobile phone repair shops can also repair, if it is still within the warranty period, you can directly find the seller or Xiaoyin manufacturer to repair it.

Summary. Dear dear, it's a pleasure to answer your <>

If the electric shaver is broken, you can take it to the repair shop that repairs the electrical appliance to repair it. Every man will use a razor, after buying a razor, if there is a problem within the warranty period, you can take it to replace or repair, if the warranty period is over, then you can only spend your own money to get the repair shop to repair, because the razor is also an electrical product, so the repair shop that repairs electrical appliances can also be repaired. It is a famous brand that can go to after-sales, and the repair shop is not that it will not repair but that there are no accessories.

If it's not a problem with accessories or other simple problems, you can go to a nearby repair shop. <>

The electric shaver is broken and repaired.

Dear dear, it's a pleasure to answer your <>

If the electric shaver is broken, you can take it to the repair shop to repair the electrical appliances. Every man will use a razor, after buying a razor, if there is a problem during the warranty period, you can take it to change or repair, if you pass the repair period of the Baolun code, then you can only spend your own money to get the repair shop to repair Youchang, because the shaver is also an electrical product, so the repair shop that repairs electrical appliances can also be repaired. It is a famous brand that can go to after-sales, and the repair shop is not that it will not repair but that there are no accessories.

If it's not a problem with accessories or other simple problems, you can go to a nearby repair shop. <>

Kiss <>

Reciprocating electric gear stop shaver maintenance, you must absolutely remove the electric shaver from the power supply before servicing it. Before you start, unplug or mold out the battery from the wall. <>

The head assembly needs to be removed, and it is held in place by a pressure button, screw, or clip. Next, remove the strainer from the nose and clean it thoroughly. If this part is corroded or damaged, then it needs to be replaced.

You will find a blade assembly inside the oscillator assembly that can be cleaned with canned air. There may be dust or hair stuck there that needs to be removed. Then follow the instructions in the owner's manual provided by the manufacturer and apply lube to your shaver.

In addition, it is recommended that the foil of these razors be replaced at least once a year. The more you use it, the more the foil wears out, and it can develop holes that cause the device to pinch your ** or even cut you. You can find ** online** for demonstrations of how to replace the foil.