How far can Wuling Hongguang 1 0 go when the water temperature rises

If it is only elevated, as long as it is not higher than 100 degrees, the car can continue to drive if it does not call the police, and it is generally not recommended to drive again after the alarm.

Hello owner, the vehicle can not continue to drive when the water temperature is high, the high water temperature will make the lubrication ability of the oil decline, if you continue to drive the engine will be damaged due to lack of lubrication, and finally have to repair the engine.

Hello, this depends on how tall you are with me, if it reaches more than a hundred, this will have a great impact on the engine.

This water temperature is high, so it's best not to keep driving, although if you're only running a small amount of mileage, it's not a big problem.

Hello, if the water temperature rises, it is better not to continue driving, as it will damage the engine.

Hello, if you find that the vehicle is already hot, it is better not to drive to avoid causing engine failure.

Hello! The water temperature of this car is too high, and I personally recommend that you stop in time, wait for a while and will be driving or find a rescuer to come and check.

If there is a high water temperature alarm in Wuling Hongguang car, it is recommended to stop and check whether there is a lack of antifreeze in the water tank, and you can consider replacing it with water for emergency replacement in the later stage.

If the water temperature rises to the alarm, then you can not continue driving, and you must check the working condition of the coolant and thermostat.

Hello! For Wuling Hongguang, if the engine water temperature is too high alarm, it is recommended that you stop immediately, do not drive again, although the car can still be started, but it will soon lead to damage to the inside of the engine, it is recommended that you stop immediately to check.

If the water temperature light alarms, it is best not to continue driving, otherwise it is easy to pull the cylinder. It is best to stop and check immediately

Hello! During the normal use of the vehicle, as long as the engine and water temperature indicator are not lit, there is generally no problem.

There are many reasons for the high temperature of the water, the thermostat is damaged, the water pump is damaged, and the lack of water may cause high temperature.

If you find that the water temperature in your car is too high, do not turn off the engine immediately. At this time, the piston, cylinder, crankshaft, etc. are in a state of high-temperature expansion, which may cause the soft metal to fall off after the flameout, and some even cause the cylinder to stick. If you find that the water temperature is too high during driving, you should never use cold water to flush it.

This may cause the tank to crack, but don't rush to open the lid of the tank to avoid squirting hot water and injuring people.

Open the engine cover and check that the auxiliary tank coolant is not too low. In this case, you can add coolant if possible, or if you don't have coolant, you can add clean water to replace it temporarily. Let the engine run at high speed, gently unscrew the water tank cover until the gas is just released, and some of the cooling water will flow out with the gas until you feel that the gas is discharged.

If there is air in the cooling system, it can form an air block, which will cause poor circulation of the cooling water, resulting in excessive engine temperature. The following methods can be used to deflate: let the engine run at high speed, gently unscrew the water tank cover until the gas is just released, at this time, some cooling water will flow out with the gas, and so on many times until you feel that the gas is exhausted (at this time, touch the upper and lower pipes with your hands, and the temperature will be significantly different from before the gas).

After troubleshooting, the cooling water should be replenished in time. If the vehicle is driving on dirt roads or muddy roads for a long time, there will be some dirt adhering to the radiator, which will affect the heat dissipation effect over time, resulting in high water temperature. In this case, you can blow the radiator grid with compressed air first.

If the temperature is too high or the temperature indicator light keeps flashing, stop to check whether the cooling water in the water tank is normal, and whether there is leakage in the water tank and water pipe.

The reasons for the high water temperature of Wuling Hongguang can cause problems are:

1. Thermostat failure.

2. Pump failure.

3. The water tank is blocked.

4. High engine idle speed.

5. The cooling fan speed is slow or malfunctioning.

The high water temperature means that the cooling heat of the engine is not dissipated in time. What can be problematic is; 1. Thermostat failure. 2. Pump failure.

3. The water tank is blocked. 4. High engine idle speed. 5. The cooling fan speed is slow or malfunctioning.

The above needs to be checked one by one to judge.

It is recommended to clean the water tank and then replace the water temperature sensor to keep the heat dissipation and ventilation normal!

Hello, there are many reasons for this: 1. The water level is insufficient. The long water cycle will cause the water to be lost slowly, resulting in a lack of water in the tank, and we do not check and add water in time. This can easily cause the water tank to "boil".

2. The water tank is corroded. If there is dirt in the tank, such as mud, rainwater, etc., it is easy to rust the tank. 3. The water tank is leaking.

A leak in the water tank will block the water circulation and seriously cause the water tank to "boil". 4. The thermostat size cycle conversion is not working properly. 5. The speed of the cooling fan is abnormal, the cooling fan may be damaged or the wire is short-circuited, causing the fan to not work, or the cooling fan speed is very slow.

If my answer is helpful to you, please set it to.

There are several reasons for the high water temperature of the engine: 1. The cooling fan does not rotate. The cooling fan may be controlled by a thermostat switch; It may also be controlled by a water temperature sensor.

2. Insufficient cooling medium. Antifreeze: High-end cars are required to be filled with antifreeze all year round; Water or distilled water:

temporary substitution; The water tank cover is leaking. 3. The thermostat is damaged. If you want to remove the thermostat, you should plug the small circulation at this time, so as to ensure that all the coolant is dissipated by the water tank; When installing a new thermostat, you should pay attention to the water hole, such as Santana does not have a water hole, at this time, a 6mm drill bit should be used to drill a hole.

One function is to be used as a marker; Another function is that during the heating process of the car, the temperature difference between the two sides of the thermostat is generated, so that the thermostat is accurately opened with the water temperature. Fourth, the water tank is clogged. External blockages should be removed with water or gas; Internal blockages affect coolant circulation and create pressure, which can result in two outcomes, one is a leaking water tank or the other is a particularly high water temperature at high speeds.

5. Pump failure. The impeller slips or gets stuck, causing the timing belt to break; The impeller is deformed. 6. Cylinder corrosion.

The combustion chamber and the waterway are flushed, and at this time, the water will be drained from the drain pipe or white smoke will be discharged, resulting in a frequent shortage of water in the water tank; The waterway and the oil channel are flushed (the oil is white when there is water); The waterway and the waterway are rushed, resulting in poor heat dissipation of the cylinder block, especially at high speed; Blocked waterways. 7. Incorrect ignition timing (corrected with timing lamp) and excessive oil pressure.

Summary. Hello, dear, the car master for your service, attentive, careful, attentive for you to answer the car questions, for you to find the corresponding problem solutions and solutions, will provide you with a satisfactory answer! We hope you find this answer helpful.

Your family is happy and the Year of the Tiger is auspicious

Hello, Wuling Hongguang runs, the water temperature decreases, the related reasons and treatment methods are as follows.

First, if the coolant is not replaced for a long time, the thermal conductivity of the coolant will deteriorate, so it is recommended to replace it with a new antifreeze.

Second, under normal circumstances, the replacement cycle of antifreeze is generally two years or 40,000 kilometers.

Thirdly, if there is a problem with the thermostat that causes this phenomenon, it is recommended to check the thermostat.

Hello, I am helping you sort out the answers to your questions, please wait a while Hello, dear, the car master will serve you, attentively, carefully, and concentrate on answering your car questions, and find solutions and solutions to the corresponding problems for you, and will definitely provide you with a satisfactory answer! We hope you find this answer helpful. Your family is happy, the Year of the Tiger is auspicious Hello, Wuling Hongguang runs, the water temperature is reduced, the relevant reasons and treatment methods are as follows: First, the coolant is not replaced for a long time and the coolant thermal conductivity deteriorates, it is recommended to replace the new antifreeze Second, under normal circumstances, the replacement cycle of antifreeze is generally two years or 40,000 kilometers Third, there is a problem with the thermostat caused by this phenomenon, it is recommended to check the thermostat.

1. Cause of failure: If the circuit system of the cooling fan fails, the engine will be in a strong hail for a long time, so the water temperature will rise very slowly.

Solution: Repair the cooling fan circuit system.

2. Cause of failure: the water pump controls the flow of antifreeze in the engine for heat dissipation, and the seepage of the thermostat is also the direction of controlling the flow of antifreeze, controlling the large cycle and small circulation, if the thermostat is not installed, the antifreeze will always circulate large, that is, it will enter the engine after the water temperature radiator heat dissipation, so the situation that the thermostat is not installed will also cause the water temperature of the engine to rise very slowly.

Solution: Install a thermostat.

3. Cause of failure: Turning on the hot air conditioner as soon as you get on the car will also cause the water temperature to rise very slowly, because the warm air source Youxing is also provided by the heat of the antifreeze in the engine.

Solution: Get in the car and wait for a while before turning on the air conditioner.

Cause 1, air resistance.

Settle; There should be an exhaust screw for the engine water pump, just open it up.

Reason 2, the problem of water temperature sensing circuit, check by turning on the headlights and other high-power consumption driving and normal driving water temperature meter can be found, solved: replace the line or induction plug.

Reason 3, gasket breakdown, 10 percent.

No way. Reason 4, lubricating oil quality problems.

1. Turn on the vehicle's air-conditioning and refrigeration system, if the air-conditioning compressor has been started and the fan is still not running, the fan must be faulty; Some vehicles (more in the U.S.) will let the fan run on its own to protect the engine when the water temperature sensor is disconnected, and the water temperature sensor can be unplugged for such vehicles.

2. Open the engine cover to observe whether the radiator located behind the bumper is mixed with too many foreign objects, if the radiator is too seriously blocked, you need to go to the jujube repair shop for cleaning.

3. In this case, the coolant can not be circulated normally, and it cannot play the role of cooling at all, mainly because the water tank and the return pipe are at room temperature (under normal circumstances, it should be hot), and due to the expansion of the gas in the water pipe, the upper and lower water pipes will become very hard at this time.

4. Open the engine compartment to observe whether the coolant level meets the requirements.

5.Poor working of the water pump: the water pump belt will slip and idle due to the use of the belt for a long time, and when this problem occurs, the main feature is that it will return to normal after stepping on the accelerator to keep it right and dismantle it for a period of time.

6. If the water temperature is too high, it may be caused by the failure of the water temperature sensor or the failure of the instrument and circuit, so it is necessary to go to the maintenance station in time for a detailed inspection.

The reasons for the high water temperature of Wuling Hongguang are as follows: 1. The cooling system leaks or the cooling water is insufficient; 2. The indication of the water temperature gauge is inaccurate or out of order; 3. There is too much scale in the cooling system, and the heat dissipation effect is poor; 4. The radiator shield net or the radiator core ventilation duct is blocked by debris, resulting in poor heat dissipation; 5. The belt of the water pump and fan is too loose or broken. Additional Information:

1. The coolant needs to be replaced regularly, if it is not changed for a long time, the freezing point of the coolant will increase and the boiling point will decrease, which will affect the normal operation of the engine. When replacing the coolant, be sure to go to a professional store and find a professional user to replace the equipment. 2. The thermostat of some cars will be damaged after a long time, which will also lead to high water temperature.

The thermostat is used to control the size of the circulation, if the coolant is in a small circulation, the coolant will not pass through the cooling water tank to dissipate heat, and the temperature of the coolant will be too high. 3. After the thermostat is damaged, it needs to be replaced with a new thermostat. When you usually use the car, you must maintain your car on time, and you must use the best posture parts when maintaining.

Daily maintenance is more important for the car, and the maintenance can keep the car in good condition all the time. Maintenance is to replace the oil and wearing parts on the car, the oil on the car has coolant, transmission oil, engine oil, brake fluid, steering oil.