Change the routing settings and how to modify the router

TP-Link should be connected to the LAN1 port and turn off its autodialing.

In addition: Huawei HG510 router settings and two computer Internet settings:

2.Connect the network cable of the computer to the LAN 1 port of the router, and change the IP protocol of the local connection attribute of the computer to automatically obtain.

3.Type in IE browser.

4.The login box interface appears, enter the username: admin, password: admin

5.In Advanced Settings WAN Select VPI VCI Select PPPOE Telecom to give you the username and password -WAN Services, NAT, Firewall Default LAN Configuration Default -Save.

6.In the Advanced Settings --- Virtual Port--- unbind the virtual port --- save.

7.In the advanced settings --- lan--- change the rental period to the maximum value --- save.

8.In the last column--- Save Reboot --- restart your computer.

9.Connect the network cables of the two computers to the LAN 3 and LAN 4 ports of the router, and change the IP protocol of the local connection attributes of the two computers to be obtained automatically.

10.Well, both are available for internet access.

You need 2 routers in series??? Then you can only use Huawei's LAN port to connect to TP!

You also have to see if your TP works, if it is only used as a switch, then use the LAN port, if it also works in routing mode, then use the WAN port.

Here's how to set up your router:

1. The broadband bus (the network cable from the cat) connects to the WAN port of the router.

2. Connect one end of the network cable to any LAN port of the router, and connect the other end to the computer, and start the computer and router equipment;

3. After starting the device, open the browser and enter it in the address bar to enter the wireless router settings interface.

4. An account and password to log in to the router appear in the settings interface, enter the default account and password admin

5. According to the setting wizard step by step setting, select the Internet mode, usually ADSL users choose the first PPPoE, if you use other network service providers, select the following two according to the actual situation, if you don't know how to choose, directly select the first item to automatically select, convenient for novice operations, click next after selection;

6. Enter the account and password applied for from the network service provider, and go directly to the next step after the input is completed;

7. Set the wifi password, try to make the alphanumeric combination more complicated and not easy to be rubbed off the network.

8. After entering correctly, it will prompt whether to restart the router, select Yes to confirm the restart of the router, and you can access the Internet normally after restarting the router.

1。Login route: The browser enters the cat.

2。Enter the back point network "broadband settings" in the connection name,Find the connection name of the internetr069 delete the word (after deleting the telecom, you can't chase your settings,Can't give you 48 hours to brush it once),Then create a new one yourself,Don't move anything in the options when you create a new one,Just enter your broadband account and password in the place where the account password is entered。

3。Restart the route.