How to change the filter element of the Xiaomi water purifier, and how to replace the filter element

The method of different models is not quite the same, if it is convenient for you, you can verify the specific model with **customer service

The method of replacing the filter element of the Xiaomi water purifier is as follows:

1. Open the cover on the top of the Mi Water Purifier.

2. When replacing the filter element, the water and electricity should be cut off.

3. To disassemble the old filter element, you need to find the filter element that needs to be replaced, and then slowly rotate it counterclockwise, and you can take it out.

4. On the right is the replaced waste filter element, and on the left is the newly purchased filter element. It doesn't make much difference from the appearance alone, but one is scrapped and the other is new.

5. The process of installing a new filter element is opposite to dismantling the old filter element: implant the new filter element in the corresponding position, clockwise.

Reset is sufficient. <>

6. Then open the water inlet three-way ball valve (horizontal direction of the handle) and turn on the power supply.

7. After replacing the filter element, to reset, press the select button to find the filter element that needs to be replaced, then the corresponding filter element indicator light flashes, and then press and hold the reset button until you hear the tick tick sound, and the corresponding filter element indicator light is off, even if the reset is successful.

8. After the filter element is reset, the indicator light in front of the water purifier has been blue in normal working condition.

9. Turn on the faucet, then the faucet indicator is orange, let it drain by itself, after a few minutes, until the faucet indicator is blue, the flushing process is completed.

2. Replacement. Turn off the main unit first, and after 2 minutes, the old filter can be removed. Then illustrate the steps to complete the installation of the new filter cartridge.

3. Debugging. After installing the new filter element, turn on the machine, press the "Select" button, select the indicator light of the new filter element, and then press and hold the "Reset" button for three seconds, after hearing the "Didi Didi" prompt tone, the indicator light will go out, and the filter element will be reset successfully.

4. Use. After a successful reset, we can rinse it with pure water mode for 10 minutes and then it will be ready for normal use.

The Xiaomi water purifier is developed by Yunmi Technology, and the main features are as follows: the volume is 205*260*410mm, and the horizontal area is smaller than that of A4 paper; 400 gallon high flow, 4-stage cartridge RO reverse osmosis technology, filtration accuracy micron. The water quality meets the latest "National Packaged Drinking Water for Food Safety" standard, which means that the water from the Xiaomi water purifier is the same as the bottled water on the market.

The water production rate is as high as 50%, the wastewater ratio is as low as 1:1, and the water purification flow rate is worth mentioning that the Xiaomi water purifier adopts a sterile and clean production environment, the whole machine is vacuum packaged, and the installation is simple, and it can be done in just three steps.

Different models may have different methods, if it is convenient for you, you can confirm it in Xiaomi** customer service

The method of replacing the filter element of the Xiaomi water purifier is as follows:Tool: Mi Water Purifier.

1. Open the lid of the Xiaomi Hail Mill water device.

2. Rotate the filter element that needs to be replaced counterclockwise.

3. Rotate the new filter element clockwise into the water purifier.

4. Finally, close the lid and complete the replacement of the filter element.

Tips: Close-up of the source at the bottom of the filter element, a water outlet hole, an inlet stool outlet, and a prominent buckle at the bottom, so that the filter element is more firm inside the water purifier.