What to do if the zipper doesn t close, what to do if the zipper can t close

The zipper can't be closed, it must be that the zipper on both sides is misaligned, if you say look at the pliers.

Fix it, it should be the case, it can be alleviated.

First, it can't be pulled.

The main reason why the zipper cannot be closed is that the distance between the upper and lower cards of the slider on the zipper is stretched wider or wider left and right, as long as pliers are used.

Just gently clip it up and down or clip it left and right, and be careful not to use too much force, so as not to break the zipper pull! After repairing, you can apply a little wax to the zipper for a smoother use in the future. If you clamp it with pliers many times and it breaks down again after a few days, you should consider replacing the zipper pull.

Second, it can't be pulled.

If you can't pull the zipper, you can apply soap or wax to it, and then slide it up and down a few times to pull the zipper.

3. Tips for using zippers:

In order to avoid frequent problems with the zipper of clothes, there are also some tips when using zippers on weekdays!

1. Don't pull it until it is stretched too tightly, so as not to stretch it.

2. Don't pull too quickly, too violently, and don't pull hard.

3. When washing clothes, be sure to close the zipper, otherwise the zipper will be washed and twisted arbitrarily by the washing machine and dryer, resulting in the zipper sawtooth falling off and being damaged.

4. Frequently apply a layer of wax to the zipper, and then pull it back and forth to ensure that it can slip smoothly.

5. Check the zipper frequently, pay attention to whether there is a phenomenon such as "tooth loss" and "crooked", if it is loose, you can use a small hammer to lightly click on the zipper head a few times, so that the upper and lower sawtooth bite a little tighter, and the sawtooth will not often fall off.

The zipper does not close the solution:

First, first observe all the chain teeth on both sides of the zipper, whether there is damage or missing, if there is damage or missing of the general individual can not be solved, you need to find a professional master to repair, if all the chain teeth are normal, carry out the following steps.

Second, if all the chain teeth are normal, then the reason for the failure to close is generally caused by the large bite of the zipper pull.

3. At this time, you can take out a pair of pliers.

Gently clamp the position pointed by the two arrows in the figure below to make the narrow side of the zipper puller a little smaller (you don't need to clip it too narrowly, just a little smaller than the original opening).

Fourth, after repairing the zipper pull, the zipper can be completely snapped together.

1. Try to lubricate the teeth. Sometimes, the teeth don't fit because they're too rough, and if so, refer to method 1. Apply the pencil to all sides of the tooth. Try pulling the zipper back and forth to see if it closes.

2. If that doesn't work, try applying glass cleaner, wax, soap or lipstick.

3. Use pliers to straighten out the bent teeth. Double-check the teeth to see which ones are different or protruding, and carefully pull them back with pliers. Use small needle-nose pliers to clamp the teeth one by one. Otherwise, it is very likely that other normal teeth will be accidentally damaged.

4. Repair the zipper with pliers. The zipper sometimes opens and does not close properly. Use pliers to close the top and bottom of the zipper so it can grab the other teeth.

Be careful not to close the zipper so hard that it looks like it's sinking. If the zipper is fully closed, it can no longer be pulled. Instead, you just need to close it to the point where you can zip it quickly.

Hello dear, it is a pleasure to serve you <>

According to the data query, the method Step 1 clamps the vise on the side of the zipper head, gently presses it, and is too forceful, otherwise the zipper will be clamped off if you accidentally open the other side of the zipper head.2 The other side of the zipper head is also tightened with a vise, and the teeth of the zipper can be closed smoothly.3 If the zipper head slides, see if the zipper head is not locked, and the zipper pulls it up, that is, downward, so that the zipper head will not slide 4 If the zipper of the newly bought clothes is not good, let it be pulled, You can gently wipe it with sesame oil, and it will be smooth easily.