-
When the 28 cm long tweezers are soaked in the tweezers, the height of the disinfectant solution in the container is 14 cm.
When the sterile forceps and its container are soaked and stored, the general ward should be replaced once a week, and the departments with high frequency of use, such as the operating room, outpatient dressing change room, injection room, etc., should be replaced once a day. Dry storage should be replaced every 4-6 hours.
When using sterile forceps, keep the front end facing down at all times, not turning upside down, so as to avoid the reverse flow of disinfectant solution to the handle of the forceps and then backflow downwards to contaminate the forceps end. Open the lid on the outside of the sterile container lid in your hand and keep your hands out of touch on the inside of the lid. If placed on a tabletop, the inside side of the lid should be facing up.
-
When the 28 cm long tongs are soaked in the container, the disinfectant level in the container is 14 cm.
Surfaces such as walls, floors, and other surfaces in contaminated rooms, toilets, corridors, etc., should be disinfected before removing obvious excrement or vomit, etc.; The soil surface should also be scraped off the contaminated topsoil (separately disinfected), and then sprayed with disinfectant containing available chlorine or effective bromine 2000mg l 5000mg l; For non-dirt surfaces, use 1000mg l 2000mg leffective chlorine spraying and disinfection;
The dosage varies according to the surface properties, the liquid absorption is 150 ml m2 to 300 ml m2 for soil walls, and 100 ml m2 for cement walls, wood wall and lime wall. The floor is disinfected once from the outside to the inside, with a spraying volume of 200 ml m2 and 300ml m2, and then repeated from the inside to the outside after the indoor disinfection is completed. The above disinfection treatment should be used for no less than 60 minutes.
-
14cm。For example: indoor environment air: effective chlorine 1000mg l 2000mg l disinfection, spray disinfection of the patient's living room according to 300ml m2, and open the door and window for ventilation for 1 hour.
For example, 300ml m2 * 100m2 = 30000ml = 30 ml = 30 l disinfectant is required for 100m2 disinfection area.
a. 84 disinfectant in units.
Calculation: That is, a bottle (a little more) of 84 disinfectant plus 15 liters of water, the disinfection area is 50m2 or the concentration of 1:50 according to the description is 800mg L, and the ratio is 1:1 when the effective chlorine content reaches 1600mg L
25, that is, a bottle of 84 disinfectant 500ml, can be prepared into a liter of disinfectant with an effective chlorine content of 1600mg l.
b. Trichloroeffervescent tablets.
Calculation: The available chlorine content is 500mg tablets, if the available chlorine content reaches 2000mg L, 1 kg of water needs 4 tablets, that is, 1 liter of water plus 4 effervescent tablets.
-
2-3cm above the shaft joint
1. The disinfectant solution should be soaked 2 3cm above the joint axis of the sterile forceps or one-half of the forceps.
2. Only one holding instrument should be placed in each container; Distant pick-ups should be moved together with sterile bottles and cans.
3. When soaking, the end of the sterile holding forceps should be opened so that the instrument can fully contact the disinfectant.
4. Do not clamp the oil gauze, so as not to affect the disinfection effect.
5. Disinfect once a week. Sterile forceps and sterile jars collected and stored by the medical education network should be replaced every 4 8 hours to maintain their sterility.
-
The level of disinfectant in the barrel of wet sterile forceps should exceed 1-2cm above the shaft section of the forceps, or 1 2 places of the length of the forceps.
-
Soak the tweezers with a burning degree of 24cm in a sterile container, and the appropriate height of the disinfectant section is ().
Correct answer)
-
Soak in a sterile container with a length of 25 cm of tweezers, and the appropriate height of the disinfectant is ().
Correct answer)
-
Answer]: Sterile tweezers are soaked in the disinfectant solution, and the soaking disinfectant solution level should be at 1 2 places (9cm) of the tweezers.
-
Summary. Hello dear, I am a gold medal mentor of cooperation, I have provided a total of 1w people with a cumulative service time of more than 3000 hours! I have received your question, it will take some time to answer, please wait a while, it will take 5 minutes to get the result, please do not end the consultation, you can also provide more effective information, so that I can better answer for you If my answer is helpful to you, please give it a thumbs up, thank <>
<> the amount of disinfectant soaked in sterile holding tweezers.
Hello dear, I am a cooperative Zhenghe gold medal tutor, I have provided a total of 1w people, and the cumulative service time is more than 3000 hours! I have received your question, it will take some time to answer, please wait a moment, it will take 5 minutes to get the result, please don't end the consultation, you can also provide more effective information, so that I can better answer for you If my answer is helpful to you, please give it a thumbs up, thank <>
<> dear and dear for you, I will find out that the amount of anti-dust key venom soaked sterile holding tweezers disinfectant is: sterile holding forceps soaked in 1 instrument disinfectant solution or 2 glutaraldehyde solution. For example, the commonly used benzalkonium bromide (new jieer) instrument disinfectant. <>
Kiss, the disinfectant needs to be soaked in 2/2 of the sterile tweezers<>
I hope my answer is helpful to you, and please give a thumbs up (comment on the bottom left Jane Tsai corner), looking forward to your like, your efforts are very important to me, and your support is also the driving force for my progress. If you feel that my answer is still satisfactory, you can click on my avatar for one-on-one consultation. Finally, I wish you good health and a happy mood again!
-
Forceps oval is a medical device that is commonly used in surgical procedures or other medical procedures. In order to ensure the sterility of the forceps oval, sterilization is required. The height of the liquid is something to pay attention to when performing disinfection, and the following are the recommendations for the height of the disinfectant liquid level of the forceps oval:
Liquid height: The level of disinfectant soaked in a sterile container should be high enough to cover all parts of the oval forceps, including the clamping section and the handle section. This ensures that each part of the forceps oval is adequately soaked in the disinfectant.
Not to the shank: The height of the disinfectant should be below the shank of the oval forceps and not beyond the shank. This is to prevent the sanitizer from spilling out of the container, causing cross-contamination or waste.
Avoid touching the bottom of the container: When soaking in the forceps, try to avoid any part of the forceps touching the bottom of the container. This reduces the risk of contamination.
A larger container can be selected to ensure that the oval forceps are fully immersed in the disinfectant solution, while leaving some space to prevent contact with the bottom of the container.
Pay attention to tightness: During the soaking forceps oval, the container should be kept airtight to prevent the evaporation of the disinfectant solution or the ingress of outside bacteria. You can use a container with a lid or seal the mouth of the container with plastic wrap to ensure the stability and sterility of the disinfectant.
Time control: The duration of soaking of forceps oval in the disinfectant solution should be determined according to the specific disinfectant requirements and usage guidelines. Different disinfectants may have different soaking time requirements, and the instructions for use should be strictly followed.
It is important to note that the forceps oval need to be thoroughly cleaned and disinfected before use to ensure that bacteria or other pathogens are not introduced during operation. In addition, different medical institutions or operating practices may vary, and it is recommended to operate according to the actual situation and professional guidance.
Hope the above information is helpful to you! If you have any further questions, please feel free to ask.
1) If the long side is curled, the radius of the cylinder is meters, and the volume is cubic meters. >>>More
1. Generally, about 20 can be raised, and if the filtration system and oxygenation system are relatively perfect, it can be about 40. >>>More
<> as shown in the figure, problem 1: the remaining area is equal to the area of the rectangle minus the area of the square, the area of the rectangle = length * width = 12*5=60 the area of the square = the square of the longer = 3*3 = 9So the area of the remaining part is 60-9=51 >>>More
As long as you insist on playing basketball every day, complaining that you are actually still in a state of mind, height is not a hurry, you have to relax, don't have too many bad behavior habits, such as sy is very hurtful to the body, sleep is also an important factor, to ensure that you sleep for about 8 hours a day, drink a bottle of milk in the morning and evening, and it is best to supplement more nutrients at noon to play basketball at the end of class in the afternoon and get up to play basketball on Sunday morning, and it is perfect to be able to do this, and you can achieve your ideal height This is the method I have summed up, and it is definitely not a copy Is it during the growth period that you want to measure it every day Is it very noisy I want to grow a little longer every day During this period, it is better not to be anxious Really, if you measure it every day. And I've told me that sometimes I wake up and measure it up, and I'm happy to find that it's a little bit higher. Then in the afternoon, I went to measure it again and found that it was short again, and I was disappointed. >>>More
The minute hand of a certain clock is 10 centimeters long, and from 1 o'clock to 2 o'clock, the tip of the minute hand has traveled by centimeters. >>>More