Why can t my router connect to broadband?

Connect the computer network card with the LAN port of the router with a network cable and turn on the power of the router; Double-click the IE browser on the computer, enter the IP address of the router default settings page in the address bar, and press Enter; Enter the default username: admin, and the default password:

admin；Click OK. Click Setup Wizard in the left rail, click Next; Click on ADSL Virtual Dialing (PPPoE) and click Next; Enter the broadband, password, and click Next; Click Done. Many friends think that the dial-up connection is over after setting up, but in fact, there is still one point that is not completed.

Because the following settings are not completed, many friends fail to dial up, or can connect to the network, but it will be dropped after a short time. Let's continue the settings: click the MAC address clone menu in the network parameters menu on the left sidebar, click Clone MAC address in the interface that appears, and click Save.

At this point, the router will prompt you to restart the router, click OK to restart the router. After the router restarts, close the Internet Explorer. Connect the WAN port of the router with an incoming network cable, and then connect the computer to the LAN port of the router with a network cable to start surfing the Internet.

What should I do if my router is connected but I can't connect to the Internet?

1. First of all, make sure that the network cable is connected correctly. That is, the network cable of the external network is connected to the WAN port of the router or cat, and the network cable of the computer is connected to the LAN port

2. After the network cable is connected correctly, be sure to set the correct Internet account and password in the router WAN settings

3. When the WAN connection is correct and the account is configured correctly, you can check the running status of the WAN port in the "Running Status". If you get a DNS server, it's no problem, otherwise there's a problem:

4. If you have a problem at this time, you can find a service provider.

5. After the network connection between the router and the service provider is successful, if there is still a problem with the network, it is a computer problem.

6. First of all, the router needs to enable the DHCP service. On the left, select DHCP Server, and then select DHCP Service

7. Set the "DHCP server" on the right to "enable", as shown in the figure above;

8. Then, when setting up wireless, it is recommended to set the wireless channel to commonly used, such as 6 or 9:

9. After the setup is complete, remember to restart the router

10. Finally, ensure that network-related services have been turned on.

After 5 minutes of shutdown, after restarting, if it doesn't work, either the router is broken, or the broadband is broken, if it is a telecom, it is best to call them to take a look.

The router can also be factory reset. It must be that the previous IP settings are still saved in the router. Factory reset.

The router needs to set the IP address and gateway Are you a new router? Take a look at the manual! There are IPs that need to be set

It may be that the router is feigned dead, try it after the power is off.

The most common scenario is that the dots are connected and then "connecting" and then automatically disconnect.

There are several reasons for this:

If the account number and password are incorrect, reset in the router's setup wizard.

2.The cat should be connected to the WAN port of the router, and the computer should be connected to number 3First use the computer to connect directly to the cat, use the system's built-in "broadband connection" to see if it can dial up the Internet normally, and then check the above two items if it is normal.

4.The network cable is not normal.

5.If there is no problem with the above checks, change the router.

...It's not set up. Call the computer repairer to get it for you!