The rice cooker steamed rice jumped when it was not cooked, what is going on Please point with a hig

The main reasons why rice cooker steamed rice jumps when it is not cooked is as follows:

Common reason 1: the contact switch is not in good contact, deformed, inflexible in action, and there is a phenomenon of jamming, which causes the contact not to engage and the heat preservation switch works so that the pot is always in a state of heat preservation, so the rice is not cooked.

Solution: Adjust and repair or replace with a new large contact switch.

Common reason 2: the heating plate is partially melted and deformed, and the surface of the heating plate cannot be closely attached to the bottom of the pot when cooking after the heating plate is deformed, and a gap is formed, so that the heat cannot be completely conducted, resulting in the water tripping without opening.

Solution: Observe whether the heating plate is deformed, if it is deformed, you can directly replace the original heating plate.

Common reason 3: deformation of the bottom of the inner pot, the principle of cooking uncooked rice due to the deformation of the bottom of the pot is the same as that of cooking uncooked rice due to the deformation of the heating plate, but it has a high probability of failure, and it is caused by excessive force when serving rice or brushing the pot, causing the bottom of the pot to collide and deform.

Solution: Put the pot body on the heating plate, gently hit the uneven part of the bottom of the pot with a semicircular hard object, and find a way to make the bottom of the pot close to the surface of the heating plate, and the fault can be eliminated.

The rice cooker tripped when the steamed rice was not cooked.

It means that there is less water in the rice cooker. Just play a little more next time. The discharge of water must be more than an inch.

The rice cooker steamed rice jumped when it was not cooked, what is going on, this should be a problem with the spring in the rice cooker, you can go to repair it, or it may be that the bottom of the rice cooker is uneven, turn the inner tank of the rice cooker before cooking, and then cook it.

Well, if this rice cooker steams rice, and the rice jumps when it is not cooked, then it is very likely that there is a problem with the fuse inside, or there is a problem with the capacitor resistance inside.

If you don't know it, you should jump if you don't know it, and the water in your rice will be boiled dry for you, so he will jump.

The rice cooker steamed rice jumped when it was not cooked, what happened? Please point your high finger to the rice cooker and skip if the steamed rice is not cooked, it must be that the key of your steamed rice is broken, or your water is less.

Friend rice cooker steamed rice is not cooked and jumps, this may be inside. There is a problem with the button button in the rice cooker, so it will jump like this, you can disassemble it for some conditioning, I hope it can help you.

The most likely possibility is that the water is too low, causing the local temperature of the rice to be too high, or there is a problem with the parts of the temperature control part.

The rice cooker should be timed, it may be that the time you set is too short, and you jumped before the rice is cooked.

Rice nest steamed rice in the rice without saying jumped on, proving that your rice cooker is broken, I suggest you. Press it again, and if it doesn't work, the others will change it.

Is this less water you put in? Because the water in the rice cooker is boiled dry, it will automatically trip. So you better put more water and try again next time.

The steamed rice in the electric pot jumped when it was not cooked, it may be that the power supply is not in good contact, or it is inside. Which piece is broken? You can find a professional maintenance person to repair it for you.

This is a problem with the place where the rice cooker tripped, or there is a problem with the bubbling skin, and it is necessary to check it specifically, but in this case, it is best to buy a new rice cooker.

The rice cooker steamed rice jumped when it was not cooked, and this is because of the heating plate of the rice cooker. There is a quality problem with the electric hot plate, and it is best to be able to repair it in time.

What is it about the rice cooker steaming rice that jumps when it is not cooked He even chose the wrong one when you choose, or you sometimes put too much rice, and he tripped when the time came, but your rice is raw.

This is a problem with the function of the rice cooker itself. Or maybe you showed up in the way you chose and chose the wrong time.

I came to this problem, the rice cooker steamed rice was not cooked and jumped, the pot was about to break, hurry up and go to the electrical appliance to rest.

The rice cooker steamed rice jumped when it was not cooked. It's a problem with the rice cooker. Open for repair.

It may be that the inner tank of the rice cooker is not very good, and you can change it to an inner tank.

It's the rice cooker that has poor contact, so you can take it for repair.

If there are parts inside the rice cooker that are broken, just let the repairman check and repair them.

The rice cooker is not cooked when steaming rice, which should be a failure of the rice cooker and needs to be repaired.

The rice cooker steamed rice is not cooked, and the nine tripped, what's going on? Is there less water Chen? You have to pick up the fan pot and pan to see if there is any dirt down there? Poor contact may also cause a trip!

If you understand this, you can open the line to see, if it doesn't work, find a professional to repair it.

This one could be a rice cooker. There was a problem with the functionality. It's a bit of a problem with the bottom one.

Add water, add too little and the rice reaches the temperature, but it is not cooked.

The rice cooker is broken and needs to be replaced with a new one, and it is not expensive.

You're putting too little water.

Rice cooker steaming rice jumps when it is not cooked is the rice cooker is faulty.

The rice cooker steamed rice jumped when it was not cooked, what happened? Please point out with your fingers, there is a problem with the internal temperature control point of the rice cooker, and you need to go to the electrical repair department to repair it.

It may be caused by a problem with the current, or it may be caused by the fact that the button is not pressed when pressed, which is very critical, and it is also very important.

Summary. There are about three reasons why the rice cooker jumps when the rice is not cooked, hello, there are three reasons why the rice cooker steam rice is not cooked and jumps: the first is: the bottom of the pot is not in good contact with the heating surface (deformed or there are foreign bodies).

The second is: the core of the magnet is broken and needs to be replaced, and the third is: the sensitivity caused by the deformation of the trip switch.

Solution: If the rice cooker always jumps to the insulated state when the rice is not cooked in the pot, first check whether there is dirt between the inner tank of the pot and the heating plate, and if so, it needs to be cleaned up.

For example, the rice cooker does not have any "observable" abnormalities, but it jumps to keep warm when the rice is not cooked, that is, it is due to the aging of the "magnetic steel thermostat" in the middle of the heating plate.

The reason is that in the use of the pot, the spring in the magnetic thermostat is often at high temperature, and the magnet in the thermostat will suddenly disappear when the temperature of the pot is higher than 103 degrees (when the water in the pot is boiled dry), and this temperature is called "Curie point temperature";

The rice cooker steamed rice jumped when it was not cooked, what happened? Please high-finger point?

Hello, I'm glad to answer this question for you, it may take a few minutes for me to sort out the information, please be patient, oh ......

There are about three reasons why the rice cooker jumps when the rice is not cooked, hello, there are three reasons why the rice cooker steam rice is not cooked and jumps: the first is: the bottom of the pot is not in good contact with the heating surface (deformed or there are foreign bodies).

The second is that the core of the orange segment is broken and needs to be replaced, and the third is: the sensitivity solution caused by the deformation of the trip switch

Rice cooker cooking like round reed fruit always jumps to the state of keeping warm when the rice in the pot is not cooked, first check whether there is dirt between the inner tank of the pot and the heating plate, if there is, it needs to be cleaned up. For example, the rice cooker does not have any "observable" abnormalities, but it jumps to keep warm when the rice is not cooked, that is, it is due to the aging of the "magnetic steel thermostat" in the middle of the heating plate. The reason is that in the use of the pot, the spring in the magnetic thermostat is often at high temperature, and the magnet in the thermostat will suddenly disappear when the temperature of the pot is higher than 103 degrees (when the water in the pot is boiled dry), and this temperature is called "Curie point temperature";

After the magnetism disappears, the spring in the thermostat resets the thermostat, and the circuit is turned to a state of heat preservation and hunger. When working in a non-thermal heating state, if the temperature limiter is aged, it is easy to make the temperature limiter act before the temperature reaches 103 degrees (and the temperature limiter reaches more than 103 degrees without jumping away and causes the pot stool to burn the dust). Therefore, in order to eliminate this fault phenomenon, the "magnetic steel thermostat assembly" should generally be replaced (the linkage rod of the thermostat assembly of the 1500-watt rice cooker is longer than the one of the 1000-watt rice cooker within the general household Zaozen, which is not the same), so as to effectively solve the problem.

Hello, the above is the answer given, if my answer is helpful to you, you praise my service, your praise is my biggest driving force to move forward, I wish you a happy life, and grind

Take Midea's rice cooker as an example, the rice cooker will automatically jump when it is not cooked for the following reasons:

First: the contact of the large switch is poor, deformed, or stuck, resulting in the contact not being engaged and the power supply voltage is unstable, so that the operation of the rice cooker is stuck, so it trips repeatedly when cooking, so that the rice in the pot is not cooked.

Second: the heating plate of the inner pot is partially deformed and melted, resulting in too high temperature will cause burning insurance, the heating plate of the rice cooker is easy to deform after a long period of use, and the surface of the heating plate can not be well attached to the bottom of the pot when cooking rice after the deformation of the heating plate, and a gap is formed, so the heat can not be completely conducted, resulting in the water tripping if it is not opened.

Third: damage to the magnet of the rice cooker, which is the most common. In the case of long-term use, the magnet inside the rice cooker will lose its original demagnetization characteristics, causing the temperature in the pot to not reach a fixed value, and the magnet of the rice cooker has lost its magnetism, and finally bounces off, leading to tripping and making the rice in the pot uncooked.

Fourth: The internal wires of the rice cooker are broken, which makes the rice cooker unable to work normally, and it cannot withstand the specified heat and trips, resulting in the rice in the pot not being cooked.

This answer applies to most brands of rice cooker models such as Gree, Midea, Haier, etc.

The rice cooker jumps before the rice is cooked, and the reason should be found first and then dealt with.

Reasons and treatment methods for tripping when the rice cooker is not cooked:

1. The rice cooker is operating normally but keeping warm in advance, check whether the exhaust valve is installed when cooking, if it is not properly deflated in advance, it will be automatically insulated, and the unplugged exhaust valve will be re-installed.

2. The heat preservation of the rice cooker in advance is most likely due to the aging of the temperature sensing magnet! Or the connection between the switch and the magnet is deformed, there is no thermistor in the rice cooker, if the cooking state jumps, it means that the magnetic thermostat is broken, causing it to jump if the temperature is not reached, and change it.

3. The rice pot and the heating base should be in good contact, the bottom of the pot and the heating base should be clean, and poor heat transfer will also cause malfunctions. Adjust the internal bimetal sheet and other temperature sensing elements.

Summary. If the rice cooker is not cooking the rice while it is cooking and tripping, there could be several reasons: The rice cooker is overheating:

If the temperature inside the rice cooker is too high, the fuse on the rice cooker will be disconnected to prevent the temperature from being too high and causing dangers such as fire. This condition is usually caused by poor heat dissipation and high voltage in the rice cooker. Power failure:

Rice cookers need a stable voltage to function properly. If the mains voltage is too low or too high, the rice cooker may not function properly, resulting in an inability to cook the rice and trip. Excessive amount of food:

If too much rice is put in, the fuse of the rice cooker may also be disconnected to prevent dangers such as fire caused by excessive temperature. Therefore, when using a rice cooker, it is necessary to make a reasonable match according to the capacity of the rice cooker and the amount of rice. Damaged or aged:

If the heating pipes, temperature sensors, and other elements inside the rice cooker are damaged or deteriorated, it may also cause the rice cooker to fail to cook properly and trip.

If the rice cooker stove can't cook the rice while cooking and trips, there may be several reasons: The rice cooker is overheating: If the internal temperature of the rice cooker is too high, the fuse on the rice cooker will be disconnected to prevent the temperature from being too high and causing dangers such as fire.

This situation is usually caused by poor heat dissipation in the rice cooker, hidden staring, high voltage, etc. Power failure: The rice cooker needs a stable voltage to function properly.

If the mains voltage is too low or too high, the rice cooker may not function properly, resulting in an inability to cook the rice and trip. Excessive amount of rice: If too much rice is put in, the fuse of the rice cooker may also be disconnected to prevent dangers such as fire caused by excessive temperature.

Therefore, when using a rice cooker, it is necessary to make a reasonable match according to the capacity of the rice cooker and the amount of rice. Damaged or aged: If the heating tubes, temperature sensors, and other elements inside the rice cooker are damaged or aged, it may also cause the rice cooker to fail to cook properly and trip.

In response to these problems, the following measures can be taken: Check whether the heat vent of the rice cooker is clean and whether there is any blockage. If there is, it needs to be cleaned up in time.

Check whether the voltage of the electric wax source is stable, and if it is unstable, the power supply equipment needs to be replaced or repaired. According to the capacity of the rice cooker and the amount of rice, it is reasonable to set up several rounds of buried matching, so as not to exceed the capacity of the rice cooker. If the internal components of the rice cooker are damaged or aged, the rice cooker needs to be repaired or replaced.

If it's not a problem with the parts, you have less water, and there is a more ordinary rice cooker that needs to be stuffy for a while, so that it will be delicious.