How to hook slippers, hook slippers beginner tutorial is the easiest

1. First hook the line on the bottom (special line for the bottom - coarse cotton thread or nylon thread).

2. Use a short needle to hook a short needle on the bottom line, (if you want to stand a little bit, you can use two wire hooks) hook four rows, and the heel does not need to hook four rows.

3. Weaving the bottom: use two rod needles to weave according to the shape of the bottom, according to the thickness of the wool and the size of the sole, add a needle on both sides of the second row of weaving to form a rounded corner, and add a needle to the width of the weaving point, not too much, the bottom of the weaving is better than the sole is a little smaller, because the wool shrinkage is good and the weaving will be too large and uneven. (In order to weave two insoles into the same, you can use two threads to knit at the same time) The needle is also rounded according to the shape of the bottom.

4. Sew the woven bottom on the sole: if there is a thin sponge, put two layers under the woolen sole (the sponge and the woolen bottom can be sewn from top to bottom with a thread in the middle).

5. Needle: the toe of the shoe is facing yourself. To leave a piece of thread slightly longer than the sole, the needle can be started according to the size of the sole, or 7, needle.

In short, the two sides should not be crooked, but should be equal. (If there is an unevenness on one side, you can separate the braid at the same time, and sometimes you can separate the two braids.) Utility.

It depends on the high and low). The first stitch is short, then one braid, two medium and long stitches (i.e., one large stitch) in the third braid, two medium and long stitches in the fifth braid, and so on. Hook to the end and hook a short needle, and then hook the remaining thread out of the short needle loop and tighten it.

Again, the needles mentioned above are all large needles. The first stitch of the medium-length needle in the second row is hooked in front of a large needle in the first row, and the second needle is hooked in the braid needle below, (if the yarn is thin, you can also hook both needles underneath, so that it will be thicker.) The first needle of the medium and long needles in the third row is the same as above, the second needle is hooked in the middle of the two medium and long needles in the lower row, and so on.

Remember. The first and last stitches of each row are short stitches.

6. In order to make the upper not high or low, don't hook every braid, but properly separate the braid hook, if each braid is hooked, the upper will be high.

7. Hook flower: to choose the pattern suitable for the size of the sole, try to hook in the middle, the general size of the pattern is three big needles to start. Note:

The front and back should be symmetrical, and the front and back should be three large needles. The hook is more than 20 rows, the sole is long, and the number of rows will be more) When changing the color and line, it is changed when there are two medium and long needles and one needle.

8. End: After hooking, hook one or two rows of short needles. There is also a method of twisting the needle, which is very thick .

Hook method for woolen slippers**

Step 1: Hook shoes should be selected with a good bottom, I bought a good line, or I can put it on my own. I figured it conveniently and the price was about the same, so I chose it.

Step 2: I use a short needle to hook the sole of the shoe, which is one circle smaller than the sole. After the hook is done, a circle of short needles is hooked around, and the number of needles is determined by the upper line of the sole.

Step 3: Place the bottom surface on the sole. The number of needles should be evenly distributed. Because this will affect whether the upper looks good or not.

Step 4: Hook two short needles at the junction between the edge of the sole surface and the center.

Step 5: The upper can be hooked below. First, the toe hook six to seven groups of medium and long needles or long needles (two needles in each group), and leave a certain length of thread on the left side to close the needle.

Step 6: Four or five rows of toe toe heads, each row of starting and closing needles should be close to the previous row, and one needle is separated from each row of starting and closing needles in the back.

Step 7: Hook until the end. I sample the diagram.

The technique of the slipper hook is as follows:

1. Hook shoes should be selected with good soles.

2. Hook the sole surface of the shoe with a short needle, and the size is smaller than the sole. After the hook is done, a circle of short needles is hooked around, and the number of needles is determined by the upper line of the sole.

3. The bottom surface will be done on the sole, and the number of needles should be evenly distributed, which will affect whether the upper looks good or not.

4. Hook two short needles at the junction between the edge of the sole surface and the center.

5. Hook the upper, first hook six to seven groups of long needles or long needles (two needles in each group), and leave a certain length of line on the left side to collect the needle.

6. There are four or five rows of toe toe heads, and each row of starting and closing needles should be close to the front row, and one needle is separated from each row of starting and closing needles in the back.

7. Hook until the end, and the hook shoe is completed.

Benefits of doing handicrafts:

1. Pei Xun cultivates creativity.

In the baby's handmade many times, the teacher first provides some things or shapes, and then guides the children's divergent thinking to think, and then mobilizes the children's enthusiasm for production, so that the children can give full play to their imagination and create things in their minds. This handmade not only exercises the children's manual ability, but also cultivates the children's creative ability.

2. Cultivate children's hands-on ability.

Handmade not only depends on the creative ability in the child's mind, but also allows the child to put this creative ability into practice, transfer it to real life, and use his own hands to complete the creation. For babies, this is the best way to train babies to complete one thing independently. From the initial design, creation to later planning and production, it is up to the baby to complete it little by little.

It is a good cultivation for the baby's hands-on ability.

The steps for hooked slippers are as follows:

1. Raw materials: coarse wool, crochet needle. Hitch and.

2. First of all, prepare the sole of the good line, hook the bottom line from the toe position, and leave a line beyond the length of the sole when hooking.

3. After hooking the bottom line of a circle, hook the left tail line into the last stitch, and then tighten the thread so that it is fixed (the toe head should be hooked a little tighter, because the line is thicker and the distance will be farther, which is not conducive to starting to hook the upper).

4. Then pull the main line to the other side, the line should be hooked a short needle obliquely forward, and then a "medium and long needle" should be hooked every other needle, and a total of "5" long needles should be hooked on the toe cap (each fixed needle should be hooked forward).

5. In the process of crocheting, there will be inconsistencies on both sides, which is a normal situation.

6. In the process of crocheting, it is necessary to compare it with another hooked shoe from time to time, so that the two shoes can be the same. And when hooking to the middle position, the two needles should be fixed forward, and the two sides should be consistent.

7. When hooking to the back rows, tighten the line appropriately to avoid the collar being too fat. And when Jian Yu finally knew how to star, he had to hook three stitches back, so that the curvature of the slippers could be revealed, and he should also pay attention to the consistent position of the hems of the two shoes.

8. When the slippers are hooked to the last line, this row does not hook the medium and long needles, but instead hooks a line of short needles. After the hook is finished, cut the thread, and then hide the thread end, and a pair of warm home slippers is complete.

Tools: thread, crochet, soles, insoles.

1. Prepare the sole first, that is, you need to hook the thread on it.

2. Then spread the insole of the sole on it, and then start crocheting from one side.

3. Then go around from one side to the other side, making a stop of almost the length of the slipper.

5. The most critical step is that the general women's shoes start with 14 stitches, and men's shoes start from 16 stitches. The first needle is hooked with two long needles, and the second is not hooked, so that the hook is separated by one needle. When hooked to the left side, the last stitch snaps with the line on the left side and the thread is pulled onto the hook on the right side.

6. Hook the top of the shoe with two long needles. The second line is hooked in the hole vacated in the middle of the first line, and the third line is hooked between the two long needles of the second line. Finally, the crochet is done.

There are countless ways to hook slippers, whether you want a man or a woman, an adult or a child.

The hook slippers beginner tutorial is the simplest as follows:

1. Hook shoes must first choose a good sole, and it is best to buy a good sedan car to change the line, which is convenient. Then use a short needle to hook the sole, and the size is much smaller than the sole. Once the hook is complete, continue to hook a short circle of needles around it.

2. Then put the bottom surface of the shoe that we have done. Remember that the number of needles must be evenly distributed. Next, hook two short needles at the junction between the edge and center of the sole surface.

3. Then we can hook the upper. Start by hooking six to seven sets of medium or long needles (two needles each) on the toe cap, leaving enough length of thread on the left side to close the needle.

4. In the first four or five rows of the toe cap, the starting and closing needles of each row should be next to the front row, and the starting and closing needles of each row in the back should be separated by one stitch. Repeat the steps until the end of the hook.

Slippers are a type of shoe with an empty heel and only a toe cap in the front, mostly flat soles, and no laces. The material is often quite soft leather, plastic, cloth, etc. The types of slippers vary according to the occasion and performance purpose.

For example, beach slippers will not be made of fabric, but plastic, which is to be waterproof and easy to clean, and the toe style is also specially designed, often called clip-on slippers, which is what we call flip-flops.

However, in order to keep warm, indoor slippers in winter may use fluff cloth instead of plastic to make Juefan Rock, so that people can have better enjoyment in the living room. There are also non-slip slippers for bathing, and anti-static slippers commonly used in electronics factories and dust-free workshops.

The hook slippers beginner tutorial is as follows:

1. Hook shoes should first choose a good sole, it is best to buy a good line, convenient, and then use a short needle to hook the sole, the size is smaller than the sole is about the same.

2. After the hook is done, continue to hook a circle of short needles around, and then put the bottom surface of our finished shoes to the sole.

3. Remember that the number of stitches must be evenly distributed, and then hook two short needles at the junction between the edge of the sole surface and the center of the shield.

4. Then we can hook the upper of the shoe, first hook six to seven groups of medium and long needles or long needles (two needles in each group), and leave a certain length of thread on the left side to collect the needle.

5. The first four or five lines of the toe cap, the starting and closing needles of each row should be close to the previous row, and the interval between the starting and closing needles of each row behind is one needle, repeating the above steps and hooking until the end.