Southeast V3 Ling Yue shifted gears with a sense of frustration and no energy to accelerate

What is the blind address, the theoretical school only, you are also repairing the car, the age of the car does not know the nonsense, V3 This car has a common problem is the coil ignition problem, manual gear shift will feel a little bit, this is a normal situation, everyone has a different feeling about the clutch and throttle, but the feeling of the landlord should be that the acceleration will be frustrated and weak, this is the problem of the engine, the ignition can not keep up, the common problem of the southeast car, the new car will have a year or two, the spark plug ignition coil is replaced on the good, In this case, you can feel it by pressing the accelerator in neutral mode, and the engine sound will be interspersed in the middle, and people who don't understand it can't hear it.

In many cases, the automatic transmission is not damaged by the internal valve body, but by stubborn dirt and impurities inside, especially in the internal valve body, the dirty impurities accumulate to form a blockage, resulting in the inability to effectively adjust the oil pressure, resulting in the occurrence of the problem of stagnation, impact and slippage. At the same time, the problem of high temperature of the gearbox cannot be ignored. According to the Automatic Transmission Repair Association, it is called

More than 90% of all faulty automatic transmissions are caused by overheating. ”

High temperatures can damage the quality and friction characteristics of automatic transmission fluids, increase friction and wear, and transmission noise will follow, as well as sludge (impurities or dirt) will also be generated inside the transmission (e.g. valve body), resulting in transmission setbacks and shocks. If the temperature exceeds 120 °C, the rubber sealing material will begin to harden, eventually leading to leakage and reduced hydraulic pressure. If the temperature is higher, the gearbox starts to slip, which in turn causes the temperature to rise even higher.

Audi and other high-end models will call the police and enter the transmission protection mode) If it is not solved in time, the transmission will be scrapped.

Therefore, only by removing the stubborn dirt and impurities in the gearbox and effectively controlling the working temperature of the gearbox can the gearbox problem be completely solved and prevent its recurrence. This is also the key to achieving "no dismantling and repairing to solve transmission failures", the specific content can be understood in detail!

Summary. Hello.

1. The most common fault of jitter during acceleration is that the spark plug is damaged, the spark plug pole gap is worn and the spark plug ignition is insufficient, the mixture is not fully burned and the acceleration is shaking, and there is a crack in the ceramic part of the spark plug, which causes the spark plug not to ignite, and a cylinder that does not work will also lead to acceleration jitter.

What is the reason for the car shaking when the southeast v3 Lingyue accelerates.

Hello 1, the most common fault of jitter during acceleration is that the spark plug is damaged, the spark plug pole gap wear leads to insufficient ignition of the spark plug, the mixture is not fully burned resulting in acceleration is jitter, and the spark plug ceramic measure pin part is cracked, resulting in the spark plug not ignition, and there is a cylinder that does not work will also lead to acceleration jitter.

2. The quality of gasoline is not good, resulting in the poor atomization effect of the fuel injector, and the mixture is not fully burned in the cylinder, so it will also lead to idle shaking.

3. The most common fault of shaking when driving is that the tread of the four wheel tires has uneven trembling holes, such as bulging, foreign bodies, and the loose bearing of the wheel will also lead to the shaking of the vehicle.

The spark plug was just changed.

It may be that the oil is not good.

One gear, two gears, three gears.

If you have cleaned the engine carbon deposit, washed the throttle grip door, changed the oil pad and spark plug, etc., and still found that the body shakes when idling, it is recommended that you go to the 4S shop to check whether the fuel supply pressure and intake pressure sensor are normal.

Summary. First of all, the gearbox.

1.The transmission fluid needs to be changed, just like the engine oil, the transmission fluid is also the gear oil in the gearbox. To a certain extent, the gearing oil of the gearbox needs to be changed regularly.

If it is not replaced in time, its lubrication effect will be greatly reduced, which will greatly increase the resistance of shifting, making the gear very rough.

2.Usually the gears of the new car are relatively simple, because the new car has not been run-in, and the parts in the gearbox have not reached the best run-in state, so compared with the car that has been driven for a while. New cars are often more difficult to shift.

3.Cold shifts often make the car's gears awkward. After all, when the temperature is cold, the adhesion of the gear oil in the gearbox is not optimal, and the lubrication effect will naturally not be very good, so it will lead to a pause when shifting.

Southeast Lingyue V3 automatic gear is jerky.

Hello dear, I'm very happy to answer for you, the reason why the Southeast Lingyue V3 gear shift is not smooth, is generally the following two questions: First, the gearbox 1The transmission fluid needs to be changed, just like the engine oil, the transmission fluid is also the gear oil in the gearbox.

To a certain extent, the gearing oil of the gearbox needs to be changed regularly. If it is not replaced in time, its lubrication effect will be greatly reduced, which will greatly increase the blocking force of the gear shift, making the gear very rough. 2.

Usually the gears of the new car are relatively simple, because the new car has not been run-in, and the parts in the gearbox have not reached the best run-in state, so compared with the car that has been driven for a while. New cars are often more difficult to shift. 3.

Cold shifts often make the car's gears awkward. After all, when the temperature is cold, the chain collapse and grinding adhesion of the gear oil in the gearbox cannot reach the best state, and the lubrication effect will naturally not be very good, so a good shirt will lead to a pause when shifting.

Second, the clutch aspect 1Clutch control system failure, because the failure of the clutch will cause the clutch to disengage the stroke to be insufficient, which in turn will lead to incomplete clutch disengagement and inability to shift gears. Such lovers suggest going to the repair shop to adjust potatoes and shouting the whole separation schedule.

2.The state selling transmission disc of the clutch book hand compass pressure plate assembly is deformed for some reason, resulting in poor separation. In this case, you should replace the *** pressure plate that matches the original car.

3.The first shaft of the gearbox is rusty, the clutch disc cannot move normally, and the return is poor, resulting in the gear being unable to follow the normal track clutch field, the self-locking force is too large, and it is difficult to enter and exit the gear. In this case, it is advisable to go to the repair shop to adjust the clutch cable and gear lock.

Shake when the vehicle accelerates, while driving:

1. The most common fault of jitter during the tremor speed is that the spark plug is damaged, the spark plug is not ignited due to the wear of the pole gap of the spark plug, the acceleration is shaking due to the insufficient combustion of the mixture, and there is a crack in the ceramic part of the spark plug, which causes the spark plug not to ignite, and a cylinder that does not work will also lead to acceleration jitter.

2. The quality of the oil sold by the steam trembling cherry is not good, resulting in the poor atomization effect of the fuel injector, and the mixture is not fully burned in the cylinder, so it will also lead to idle shaking.

3. The most common fault of shaking when driving is that the tread of the four wheel tires is uneven, such as bulging, foreign bodies, and loose bearings of the wheels will also cause the driving vehicle to shake.

Sorted out the "What are the common problems of Southeast V3 Lingyue?" that everyone often pays attention to? ", as follows. Mitsubishi Southeast V3 Lingyue This car has a grand appearance, and the cost performance is quite high, this car is more suitable for self-driving tours, and it is worth buying. Mitsubishi Tojun does South V3 Ling:

1. Appearance: Lingyue car has the appearance of Mitsubishi blood, the most popular trapezoidal large-hole grille, although the style is slightly outdated, but relatively durable, it looks very spiritual after a long time;

2. Interior: Beige + black interior is very ordinary, the interior workmanship is too rough, the seams of the center console are uneven and hard plastic, the steering wheel feels very good, the style is also good-looking, the storage space is small, the inside of the door basically can't put anything, and the workmanship should be improved;

3. Space: I feel that the space is good, I am more satisfied, the space of the trunk is also quite large, and I have not installed large items to make branches, which is usually enough;

4. Configuration: The cost performance should be the highest, 4-wheel disc brake, rear independent suspension, Mitsubishi technology engine, rich modified parts, and workmanship, all of which only need 50,000, and I can't find a more cost-effective ride than him;

5. Motivation: Motivation: My personal opinion is that as long as you are willing to give oil to push the back, there must be a feeling. In terms of motivation, I personally feel more satisfied.

Millions of car purchase subsidies.

There is no problem of unstable idle speed caused by the carbon deposition of the engine throttle, and it is generally more important to consider whether the starting operation is proper in terms of oil separation.

The torque of the small displacement automobile engine is small at low speed, so the throttle should be properly refueled to ensure that the engine speed is about 1000 1500 rpm when starting, slowly lift the clutch pedal, and then supplement the throttle and control the lifting clutch to a fully integrated state after the vehicle moves forward.

There are also a very small proportion of vehicles, 4S said that due to the clutch and other parts of the new car is not completely run-in, the starting combination is too uneven, and it will improve after a period of running-in. The jitter problem that only occurs in the initial stages should be related to the clutch components, and changing to high-standard gasoline such as the 97 should not help much.

Summary. Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

In this case, it may be caused by the insufficient output torque of the engine, Hulu will clean the carbon deposits of the hungry rubber engine, replace the spark plug, if it is still rotten, then it is necessary to replace the gearbox oil, as well as clean the solenoid valve in the gearbox, or it may be caused by the solenoid valve in the gearbox.

I'm automatic.

Shake when you start, and you'll be fine when you run.

I know that it is an automatic transmission, that is, first clean the carbon deposit of the engine, if it is not good, then you need to replace the transmission oil and clean the solenoid valve in the transmission slippery difference.

This situation is mainly caused by the unbalanced work of the solenoid valve at the beginning of the gearbox.

Does it have anything to do with throttle and fuel injector?

Relatedly, if the throttle or fuel injector is not working properly, it will also lead to a decrease in power at the start.

How much does it cost to replace the solenoid valve in the gearbox?

The solenoid valve in this gearbox is cleaned up, which is about seven or eight hundred yuan, and it takes more than 2,500 yuan to replace it.

I've cleaned the throttle.

Then change the transmission oil first, if it still doesn't work, then clean the solenoid valve inside the gearbox.

Okay thank you. You are welcome.

If I can help you, please give me a thumbs up Thank you!

Southeast V3 Lingyue 4G15 cylinder idle squeak, the louder the throttle, hello pro 1This situation may be due to engine knocking, or it may be a lack of oil, or the oil pressure is relatively low, and the friction between the valve and the guide pipe and the hydraulic tappet is generated; 2.For this kind of sound, the professional name is called "Detonation Leak Book".

The main reason for the formation is that there is carbon deposit on the top of the piston, because the carbon deposit forms a hot surface with high strength, at this time, the fuel mixture gas entering the combustion chamber begins to spontaneously ignite because of the carbon deposit before the stroke of igniting the spike; 3.Although this combustion phenomenon seems to be sufficient, this combustion is spontaneous combustion and premature combustion, and there is no safety regulation to burn in the stroke, and there will be a metal sound of the piston hitting the cylinder wall, which is what we often call the rod. Excessive carbon deposition is the cause of detonation; Ignition is too early; Low rpm high grade; Or the addition of low-grade gasoline may cause such failures due to back-to-base; Knocking should be repaired in time, as a long-term and severe knock will lead to early wear of the cylinder components, which will greatly shorten the service life of the vehicle.

I hope I can help you, I wish you a happy life and smooth work!